JLTV TEST A STUDY GUIDE 2026/2027
COMPLETE QUESTIONS WITH
VERIFIED CORRECT ANSWERS ||
100% GUARANTEED PASS
<NEWEST VERSION>
1. 4 VARIATONS OF JLTV - ANSWER ✔ Utility, General Purpose, Heavy
Guns Carrier, Close Combat Weapons Carrier
2. Why do the High Pressure Gas (HPG) pumps automatically stop running
after continuously for 10 minutes? - ANSWER ✔ C. To prevent the system
from overheating
3. The transaxle receives power from the __ and transfers it to the front and
rear wheels. - ANSWER ✔ B. Transmission
4. Using the picture below, write the height of each of the red lines. -
ANSWER ✔ 60in, 30in
5. The __ adjusts air pressure in all tires to correspond to cargo and terrain
settings when selected by the driver. - ANSWER ✔ B. CTIS
6. With the vehicle CTIS set to MSS, what line lock is the JLTV automatically
in? - ANSWER ✔ C. 2
,7. What is the purpose of (RPM) control? - ANSWER ✔ D. It prevents
slipping and sliding on soft soil road conditions
8. When driving a JLTV equipped with tire chains, why is it desirable to allow
the chains to creep or move on the tires? - ANSWER ✔ B. It reduces the
possibility of the chain links gouging into the tires
9. Which CTIS setting would you use to operate in standard soft sand
conditions? - ANSWER ✔ C. MSS
10.Explain how operating in mud can degrade the JLTV's performance -
ANSWER ✔ Mud can get into vital parts of the vehicle such as the radiator
and cause damage.
11.When traversing through sand, snow, or mud, which of the following driving
techniques is recommended? - ANSWER ✔ B. Keep a steady throttle and
momentum
12.Why must your setting be configured properly BEFORE driving on soft
soils? - ANSWER ✔ Without the proper configuration there is a good
chance of it getting stuck.
13.What is the key difference between driving on flat terrain and slopes? -
ANSWER ✔ D. Traction
14.The independent suspension of the JLTV uses __ and hydraulic damping to
keep the tires in contact with the ground over varying terrain - ANSWER ✔
C. high pressure gas shocks
,15.As a JLTV driver, what must you do before beginning to ascend a steep
slope? Select all that apply. - ANSWER ✔ A. Assess the terrain and
available traction B. Choose the safest route D. Choose proper gearing
16.What mode should CTIS be in for ascending a 60% grade? - ANSWER ✔ B.
CC
17.You are preparing to climb a 60% grade and traction is limited. You choose
to set the transaxle to low range. What steps must you follow to put the
transaxle in low range? Select all that apply. - ANSWER ✔ A. Select AXLE
LOCK B. Put transmission in neutral D. Allow vehicle to move slightly
forward or backward to complete the range change.
18.Fill in the blanks in the vehicle hierarchy below: - ANSWER ✔ UTL
GENERAL PURPOSE
HEAVY
CLOSE COMBAT
TRAILER
19.What vehicle-handling factor changes (vehicle reaction) is a result from the
change in terrain when driving from flat terrain to slopes?
A. Speed
B. Terrain
C. CTIS
D. Traction - ANSWER ✔ D. Traction
20.The independent suspension of the JL TV uses hydraulic pressure in the
maintain wheel-to-ground contact, which provides a smooth ride over
varying terrain.
A. Leaf springs
to
, B. Air suspension
C. Roll Control Circuit (Cross plumbing)
D. Coil over springs - ANSWER ✔ C. Roll Control Circuit (Cross
plumbing)
21.Select all that apply. As a JLTV driver, what must you do before beginning
to ascend a steep slope?
A. Assess the terrain and available traction
B. Choose the safest route
C. Accelerate to high speed
D. Choose proper gearing - ANSWER ✔ A. Assess the terrain and
available traction
B. Choose the safest route
D. Choose proper Gearing
22.What mode should CTIS be in when inclinometer shows you are ascending a
30° degree grade on an unimproved hard-packed road?
A. HWY
B. CC
C. MSS
D. EMER - ANSWER ✔ B. CC
23.Select all that apply. You are preparing to climb a steep hill (30° grade) and
traction is limited. You choose to set the transaxle to low range. What steps
must you follow to put the transaxle in low range?
A. Stop the vehicle.
B. Do not stop the vehicle.
C. Put transmission in neutral.
D.
24.Select T-AXLE LOW. - ANSWER ✔ A. Stop the vehicle
C. Put transmission in neutral
D. Select T-AXLE LOW
COMPLETE QUESTIONS WITH
VERIFIED CORRECT ANSWERS ||
100% GUARANTEED PASS
<NEWEST VERSION>
1. 4 VARIATONS OF JLTV - ANSWER ✔ Utility, General Purpose, Heavy
Guns Carrier, Close Combat Weapons Carrier
2. Why do the High Pressure Gas (HPG) pumps automatically stop running
after continuously for 10 minutes? - ANSWER ✔ C. To prevent the system
from overheating
3. The transaxle receives power from the __ and transfers it to the front and
rear wheels. - ANSWER ✔ B. Transmission
4. Using the picture below, write the height of each of the red lines. -
ANSWER ✔ 60in, 30in
5. The __ adjusts air pressure in all tires to correspond to cargo and terrain
settings when selected by the driver. - ANSWER ✔ B. CTIS
6. With the vehicle CTIS set to MSS, what line lock is the JLTV automatically
in? - ANSWER ✔ C. 2
,7. What is the purpose of (RPM) control? - ANSWER ✔ D. It prevents
slipping and sliding on soft soil road conditions
8. When driving a JLTV equipped with tire chains, why is it desirable to allow
the chains to creep or move on the tires? - ANSWER ✔ B. It reduces the
possibility of the chain links gouging into the tires
9. Which CTIS setting would you use to operate in standard soft sand
conditions? - ANSWER ✔ C. MSS
10.Explain how operating in mud can degrade the JLTV's performance -
ANSWER ✔ Mud can get into vital parts of the vehicle such as the radiator
and cause damage.
11.When traversing through sand, snow, or mud, which of the following driving
techniques is recommended? - ANSWER ✔ B. Keep a steady throttle and
momentum
12.Why must your setting be configured properly BEFORE driving on soft
soils? - ANSWER ✔ Without the proper configuration there is a good
chance of it getting stuck.
13.What is the key difference between driving on flat terrain and slopes? -
ANSWER ✔ D. Traction
14.The independent suspension of the JLTV uses __ and hydraulic damping to
keep the tires in contact with the ground over varying terrain - ANSWER ✔
C. high pressure gas shocks
,15.As a JLTV driver, what must you do before beginning to ascend a steep
slope? Select all that apply. - ANSWER ✔ A. Assess the terrain and
available traction B. Choose the safest route D. Choose proper gearing
16.What mode should CTIS be in for ascending a 60% grade? - ANSWER ✔ B.
CC
17.You are preparing to climb a 60% grade and traction is limited. You choose
to set the transaxle to low range. What steps must you follow to put the
transaxle in low range? Select all that apply. - ANSWER ✔ A. Select AXLE
LOCK B. Put transmission in neutral D. Allow vehicle to move slightly
forward or backward to complete the range change.
18.Fill in the blanks in the vehicle hierarchy below: - ANSWER ✔ UTL
GENERAL PURPOSE
HEAVY
CLOSE COMBAT
TRAILER
19.What vehicle-handling factor changes (vehicle reaction) is a result from the
change in terrain when driving from flat terrain to slopes?
A. Speed
B. Terrain
C. CTIS
D. Traction - ANSWER ✔ D. Traction
20.The independent suspension of the JL TV uses hydraulic pressure in the
maintain wheel-to-ground contact, which provides a smooth ride over
varying terrain.
A. Leaf springs
to
, B. Air suspension
C. Roll Control Circuit (Cross plumbing)
D. Coil over springs - ANSWER ✔ C. Roll Control Circuit (Cross
plumbing)
21.Select all that apply. As a JLTV driver, what must you do before beginning
to ascend a steep slope?
A. Assess the terrain and available traction
B. Choose the safest route
C. Accelerate to high speed
D. Choose proper gearing - ANSWER ✔ A. Assess the terrain and
available traction
B. Choose the safest route
D. Choose proper Gearing
22.What mode should CTIS be in when inclinometer shows you are ascending a
30° degree grade on an unimproved hard-packed road?
A. HWY
B. CC
C. MSS
D. EMER - ANSWER ✔ B. CC
23.Select all that apply. You are preparing to climb a steep hill (30° grade) and
traction is limited. You choose to set the transaxle to low range. What steps
must you follow to put the transaxle in low range?
A. Stop the vehicle.
B. Do not stop the vehicle.
C. Put transmission in neutral.
D.
24.Select T-AXLE LOW. - ANSWER ✔ A. Stop the vehicle
C. Put transmission in neutral
D. Select T-AXLE LOW
