Dr illin g /
Fin al Exam Question s W ith An sw er s
/ // // // // //
The purpose of using a pre-
// // // // //
flush in cementing operations is ___________________
// // // // //
a. Accelerate the setting time.
// // // //
b. Remove some of the wall cake.
// // // // // //
c. /
Provide a spacer between the drilling mud and the slurry.
/ // // // // // // // // //
d. /
Increase
/ /
the
/ /
density of the slurry. - CORRECT ANSWERS(S)✅✅B & C
/ // // // // // // // //
The best temperature range for slurry is _____________
// // // // // // //
a. Below 60oF to prevent water loss from evaporation.
// // // // // // // //
b. Between 60oF and 90oF as it goes into the well.
// // // // // // // // // //
c. Between 90oF and 100oF as it goes into the well.
// // // // // // // // // //
d. /
Higher
/ /
than
/ /
100oF
/ /
to ensure proper viscosity. - CORRECT ANSWERS(S)✅✅B
/ // // // // // //
,Benefits /
derived
/ /
from
/ /
using
/ //
a /
bottom
/ /
plug in the cementing operation include ____________
/ // // // // // //
a. Wiping mud film from inside the casing.
// // // // // // //
b. Reducing slurry contamination.
// // //
c. Preventing entry of air into slurry.
// // // // // //
d. All of the above - CORRECT ANSWERS(S)✅✅A & B
// // // // // // // // //
Pressure /
should be bled off the casing before ______________
/ // // // // // // //
a. The top plug ruptures.
// // // //
b. The cement sets, so the pipe will not bulge.
// // // // // // // // //
c. The valve in the float collar closes.
// // // // // // //
d. None of the above. - CORRECT ANSWERS(S)✅✅B
// // // // // // //
Which /
of
/ /
the
/ /
following substances can be used as displacement fluid?
/ // // // // // // //
a. Seawater
//
, b. Fresh water
// //
c. Drilling fluid
// //
d. /
All
/ /
of
/ /
the above - CORRECT ANSWERS(S)✅✅d. all of the above
/ // // // // // // // //
In /
determining
/ /
the volume of an open hole with the diameter-
/ // // // // // // // //
squared method, a slightly larger figure for
// // // // // //
diameter should be used to allow for _______________ // // // // // // //
a. Larger casing ID.
// // //
b. Hole enlargement
// //
c. Errors in calculation
// // //
d. /
An
/ /
extra
/ /
amount
/ /
of
/ /
cement
/ /
slurry as a safety factor. - CORRECT ANSWERS(S)✅✅B
/ // // // // // // //
An /
operator
/ /
desiring
/ /
Fin al Exam Question s W ith An sw er s
/ // // // // //
The purpose of using a pre-
// // // // //
flush in cementing operations is ___________________
// // // // //
a. Accelerate the setting time.
// // // //
b. Remove some of the wall cake.
// // // // // //
c. /
Provide a spacer between the drilling mud and the slurry.
/ // // // // // // // // //
d. /
Increase
/ /
the
/ /
density of the slurry. - CORRECT ANSWERS(S)✅✅B & C
/ // // // // // // // //
The best temperature range for slurry is _____________
// // // // // // //
a. Below 60oF to prevent water loss from evaporation.
// // // // // // // //
b. Between 60oF and 90oF as it goes into the well.
// // // // // // // // // //
c. Between 90oF and 100oF as it goes into the well.
// // // // // // // // // //
d. /
Higher
/ /
than
/ /
100oF
/ /
to ensure proper viscosity. - CORRECT ANSWERS(S)✅✅B
/ // // // // // //
,Benefits /
derived
/ /
from
/ /
using
/ //
a /
bottom
/ /
plug in the cementing operation include ____________
/ // // // // // //
a. Wiping mud film from inside the casing.
// // // // // // //
b. Reducing slurry contamination.
// // //
c. Preventing entry of air into slurry.
// // // // // //
d. All of the above - CORRECT ANSWERS(S)✅✅A & B
// // // // // // // // //
Pressure /
should be bled off the casing before ______________
/ // // // // // // //
a. The top plug ruptures.
// // // //
b. The cement sets, so the pipe will not bulge.
// // // // // // // // //
c. The valve in the float collar closes.
// // // // // // //
d. None of the above. - CORRECT ANSWERS(S)✅✅B
// // // // // // //
Which /
of
/ /
the
/ /
following substances can be used as displacement fluid?
/ // // // // // // //
a. Seawater
//
, b. Fresh water
// //
c. Drilling fluid
// //
d. /
All
/ /
of
/ /
the above - CORRECT ANSWERS(S)✅✅d. all of the above
/ // // // // // // // //
In /
determining
/ /
the volume of an open hole with the diameter-
/ // // // // // // // //
squared method, a slightly larger figure for
// // // // // //
diameter should be used to allow for _______________ // // // // // // //
a. Larger casing ID.
// // //
b. Hole enlargement
// //
c. Errors in calculation
// // //
d. /
An
/ /
extra
/ /
amount
/ /
of
/ /
cement
/ /
slurry as a safety factor. - CORRECT ANSWERS(S)✅✅B
/ // // // // // // //
An /
operator
/ /
desiring
/ /