1|Page
NICET LEVEL 2 EXAM NEWEST 2026 ACTUAL
VERIFIED EXAM WITH COMPLETE QUESTIONS AND
CORRECT DETAILED ANSWERS (100% VERIFIED
ANSWERS) |ALREADY GRADED A+| ||NEWEST
EXAM||
For systems employing relocation or partial evacuation, a
_______ or _______ pathway survivability shall be
required for in-building pathway survivability - Answer-
Level 2
Level 3
Central station service, which consists of the following
elements: - Answer-Runner service
The central station service elements shall be provided
under contract to a subscriber by a ________ that has a
listing for central station fire alarm services - Answer-prime
contractor
The central station shall have not less than ______
qualified operators on duty at the central station at all
,2|Page
times to ensure disposition of signals in accordance with
the requirements of 26.3.8 - Answer-two
Complete records of all signals received shall be retained
for at least ________. - Answer-1 year
The protected property shall be either a contiguous
property or noncontiguous properties under one
ownership. - Answer-Proprietary Supervising stations
Drawings which have been approved by the AHJ for a fire
alarm project are commonly referred to as _____
drawings? - Answer-Shop
A project requires photoelectric spot type smoke detectors.
Which of the following environmental conditions typically
will affect photoelectric smoke detector response? -
Answer-Humidity greater than 93%
Consider a Group M where the entire building is one-story
at the level of exit discharge. A fire alarm system is
required when the occupant load is _____ or greater? -
Answer-500
,3|Page
Consider the use of smoke detectors on a level ceiling
with beams where the ceiling height is 10 feet AFF. For a
beam depth of less than _____ inches smooth ceiling
spacing shall be permitted? - Answer-12
An acceptable substitute for FPLP is _____? - Answer-
CMP
Consider NPLFA cable. The minimum conductor size is
_____ AWG? - Answer-18 solid or stranded
Consider the installation of a visible notification appliance
in a corridor which is 15 feet wide. Visible notification
appliances shall be located not more than _____ feet from
each end of the corridor? - Answer-15
OSHA requires that hearing protection be worn when
exposed to sound level of 120 dB for more than _____
minutes? - Answer-8
Consider the use of heat detectors on a ceiling with solid
joists which project down from the ceiling 4 inches and a
, 4|Page
joist spacing of 24 inches. Based on this, spacing parallel
to the joists should be reduced by _____ percent? -
Answer-0
During the acceptance test, the AHJ determines that the
requirements of the code have not been met and wants
you to add five more notification appliances to an area.
What documents will be affected by this change? (Select
Three) - Answer-Voltage drop calculations
Battery calculations
Record drawings
"Shall" in NFPA 72 the National Fire Alarm and Signaling
Code refers to a _____? - Answer-Mandatory requirement
Consider a parallel circuit with total voltage of 24 VDC and
the total current of 1 amps. The circuit has two resistors of
equal value. The value of each resistor is _____ ohms? -
Answer-48
NICET LEVEL 2 EXAM NEWEST 2026 ACTUAL
VERIFIED EXAM WITH COMPLETE QUESTIONS AND
CORRECT DETAILED ANSWERS (100% VERIFIED
ANSWERS) |ALREADY GRADED A+| ||NEWEST
EXAM||
For systems employing relocation or partial evacuation, a
_______ or _______ pathway survivability shall be
required for in-building pathway survivability - Answer-
Level 2
Level 3
Central station service, which consists of the following
elements: - Answer-Runner service
The central station service elements shall be provided
under contract to a subscriber by a ________ that has a
listing for central station fire alarm services - Answer-prime
contractor
The central station shall have not less than ______
qualified operators on duty at the central station at all
,2|Page
times to ensure disposition of signals in accordance with
the requirements of 26.3.8 - Answer-two
Complete records of all signals received shall be retained
for at least ________. - Answer-1 year
The protected property shall be either a contiguous
property or noncontiguous properties under one
ownership. - Answer-Proprietary Supervising stations
Drawings which have been approved by the AHJ for a fire
alarm project are commonly referred to as _____
drawings? - Answer-Shop
A project requires photoelectric spot type smoke detectors.
Which of the following environmental conditions typically
will affect photoelectric smoke detector response? -
Answer-Humidity greater than 93%
Consider a Group M where the entire building is one-story
at the level of exit discharge. A fire alarm system is
required when the occupant load is _____ or greater? -
Answer-500
,3|Page
Consider the use of smoke detectors on a level ceiling
with beams where the ceiling height is 10 feet AFF. For a
beam depth of less than _____ inches smooth ceiling
spacing shall be permitted? - Answer-12
An acceptable substitute for FPLP is _____? - Answer-
CMP
Consider NPLFA cable. The minimum conductor size is
_____ AWG? - Answer-18 solid or stranded
Consider the installation of a visible notification appliance
in a corridor which is 15 feet wide. Visible notification
appliances shall be located not more than _____ feet from
each end of the corridor? - Answer-15
OSHA requires that hearing protection be worn when
exposed to sound level of 120 dB for more than _____
minutes? - Answer-8
Consider the use of heat detectors on a ceiling with solid
joists which project down from the ceiling 4 inches and a
, 4|Page
joist spacing of 24 inches. Based on this, spacing parallel
to the joists should be reduced by _____ percent? -
Answer-0
During the acceptance test, the AHJ determines that the
requirements of the code have not been met and wants
you to add five more notification appliances to an area.
What documents will be affected by this change? (Select
Three) - Answer-Voltage drop calculations
Battery calculations
Record drawings
"Shall" in NFPA 72 the National Fire Alarm and Signaling
Code refers to a _____? - Answer-Mandatory requirement
Consider a parallel circuit with total voltage of 24 VDC and
the total current of 1 amps. The circuit has two resistors of
equal value. The value of each resistor is _____ ohms? -
Answer-48
