Home Inspection Exam Questions and Answers |New Update with 100% Verified Answers
The preferred method for installing drip-edge flashing is _____________. over the roofing
paper/felt along the rake edge
One of the main purposes of using crushed stone or gravel ballast on a built-up roof is to
________________. protect the roof from sunlight
A flat roof will usually have _____ installed. internal drainage
_____ flashing will be found along the peak of the roof. ridge
Slate tile roofs __________ be walked on. should not
Modern bathroom receptacles are typically on _________ circuits. 20 amp GFCI
____________ should not be used as a grounding means. water pipes
Any GFCI breaker or receptacle that _____ should be written up as in need of immediate
replacement. fails to trip and reset properly
Ohms Laws are mathematical models that allows inspectors to understand why a 30-amp fuse
should not be connected to a 14-awg wire. T/F? true
The minimum cable size for a service entrance for a 200-amp supply is ______________. 2/0
copper or 4/0 aluminum
Wires to outlets are called __________. branch circuit conductors
,AFCIs (arc fault circuit interrupters) are _____ to protect bedroom circuits. protect
_________ is defined as the flow of liquids in piping for a potable water distribution system in
reverse of their intended path. backflow
T/F: The design of a drainage system is based on uniform flow in the drainage piping. true
__________ water heaters should not obtain combustion air from sleeping rooms, bathrooms
or toilet rooms. fuel-fired
Glass doors enclosing the shower __________ made of safety glazing. should be
The standpipe and trap for an automatic clothes washer should be at least ____ inches in
diameter. 2
Vent pipes that pass through a roof should end ______ 6 inches above the roof. at least
In order to get good results in relation to observing water pressure at fixtures, it is good
inspection procedural practice to inspect the plumbing fixtures at the ______ point in the
dwelling. highest
Cleanouts for drainage pipes should be installed _____________ apart in horizontal drainage
lines measured from the upstream entrance of the cleanout. no more than 100 feet
An automatic clothes washer must discharge its wastewater through a(n) _________ into a
standpipe or laundry tub. air gap or air break
T/F: The purpose of the joist is to provide a nailing and support system for the floor sheathing
and for the floor itself. True
,Modifications to a bearing wall ______________. generally need to be designed and
approved by a licensed professional engineer
A __________ is a space that is not a full basement and located between the ground and the
bottom of the first floor of a home. crawlspace
The first course of horizontal lumber placed on top of and attached to the foundation wall is
known as the _____________. sill plate
A _____ describes an assembly of three or four vertical studs nailed together to make up a
corner framing element. corner post
Inspecting the _______ potentially poses one of the riskiest, unsafe parts of a home inspection.
crawlspace
The ______ is installed at the intersection of roof rafters at their uppermost point. ridge
When an opening must be made in a load-bearing wall, a _______ must be placed horizontally
to help support the load. header
While lifting a ladder, one should always _________. lift with the leg muscles
Doing tasks that require an awkward posture for more than one minute may contribute to
________. a lower back injury
Dog bites are _________ common than cat bites, but cat bites are more likely to become
infected. less
, A Type IA ladder supports a maximum of _______ pounds. 300
T/F: Damaged ladders may still be used as long as they are properly labeled as to the extent of
the damage identified. False
Methane gas, which may be present in confined spaces such as a basement, can cause death by
__________. asphyxiation
Wooden and fiberglass ladders ________________ protect a person from electrical shock.
don't always
Many inspection-related back injuries can be attributed to __________________ lifting and
ladder-climbing techniques. poor
One-person inspection businesses _______________. should be especially diligent with
regard to safety because no one is looking out for the inspector but himself/herself
A minimum service of _____ amps is required for a single residential dwelling unit. 100
Proper _________ of a building site is important for preventing wet basements, damp
crawlspaces, erosion, and possible failure of the foundation. drainage
All 15- and 20-amp 120-volt circuits for dining rooms, living rooms, bedrooms, sun rooms,
closets, hallways, and similar areas in a home must be ______ -protected. AFCI
If particleboard is used as wall sheathing, the grade mark with Type _____ or _____ should be
stamped on it. M1 or M2
The preferred method for installing drip-edge flashing is _____________. over the roofing
paper/felt along the rake edge
One of the main purposes of using crushed stone or gravel ballast on a built-up roof is to
________________. protect the roof from sunlight
A flat roof will usually have _____ installed. internal drainage
_____ flashing will be found along the peak of the roof. ridge
Slate tile roofs __________ be walked on. should not
Modern bathroom receptacles are typically on _________ circuits. 20 amp GFCI
____________ should not be used as a grounding means. water pipes
Any GFCI breaker or receptacle that _____ should be written up as in need of immediate
replacement. fails to trip and reset properly
Ohms Laws are mathematical models that allows inspectors to understand why a 30-amp fuse
should not be connected to a 14-awg wire. T/F? true
The minimum cable size for a service entrance for a 200-amp supply is ______________. 2/0
copper or 4/0 aluminum
Wires to outlets are called __________. branch circuit conductors
,AFCIs (arc fault circuit interrupters) are _____ to protect bedroom circuits. protect
_________ is defined as the flow of liquids in piping for a potable water distribution system in
reverse of their intended path. backflow
T/F: The design of a drainage system is based on uniform flow in the drainage piping. true
__________ water heaters should not obtain combustion air from sleeping rooms, bathrooms
or toilet rooms. fuel-fired
Glass doors enclosing the shower __________ made of safety glazing. should be
The standpipe and trap for an automatic clothes washer should be at least ____ inches in
diameter. 2
Vent pipes that pass through a roof should end ______ 6 inches above the roof. at least
In order to get good results in relation to observing water pressure at fixtures, it is good
inspection procedural practice to inspect the plumbing fixtures at the ______ point in the
dwelling. highest
Cleanouts for drainage pipes should be installed _____________ apart in horizontal drainage
lines measured from the upstream entrance of the cleanout. no more than 100 feet
An automatic clothes washer must discharge its wastewater through a(n) _________ into a
standpipe or laundry tub. air gap or air break
T/F: The purpose of the joist is to provide a nailing and support system for the floor sheathing
and for the floor itself. True
,Modifications to a bearing wall ______________. generally need to be designed and
approved by a licensed professional engineer
A __________ is a space that is not a full basement and located between the ground and the
bottom of the first floor of a home. crawlspace
The first course of horizontal lumber placed on top of and attached to the foundation wall is
known as the _____________. sill plate
A _____ describes an assembly of three or four vertical studs nailed together to make up a
corner framing element. corner post
Inspecting the _______ potentially poses one of the riskiest, unsafe parts of a home inspection.
crawlspace
The ______ is installed at the intersection of roof rafters at their uppermost point. ridge
When an opening must be made in a load-bearing wall, a _______ must be placed horizontally
to help support the load. header
While lifting a ladder, one should always _________. lift with the leg muscles
Doing tasks that require an awkward posture for more than one minute may contribute to
________. a lower back injury
Dog bites are _________ common than cat bites, but cat bites are more likely to become
infected. less
, A Type IA ladder supports a maximum of _______ pounds. 300
T/F: Damaged ladders may still be used as long as they are properly labeled as to the extent of
the damage identified. False
Methane gas, which may be present in confined spaces such as a basement, can cause death by
__________. asphyxiation
Wooden and fiberglass ladders ________________ protect a person from electrical shock.
don't always
Many inspection-related back injuries can be attributed to __________________ lifting and
ladder-climbing techniques. poor
One-person inspection businesses _______________. should be especially diligent with
regard to safety because no one is looking out for the inspector but himself/herself
A minimum service of _____ amps is required for a single residential dwelling unit. 100
Proper _________ of a building site is important for preventing wet basements, damp
crawlspaces, erosion, and possible failure of the foundation. drainage
All 15- and 20-amp 120-volt circuits for dining rooms, living rooms, bedrooms, sun rooms,
closets, hallways, and similar areas in a home must be ______ -protected. AFCI
If particleboard is used as wall sheathing, the grade mark with Type _____ or _____ should be
stamped on it. M1 or M2
