Mo-Valley Test 1-1 Study Guide 2025/2026 Complete Questions With Verified Correct Answers || 100% Guaranteed Pass Newest Version

MO-VALLEY TEST 1-1 STUDY GUIDE
2025/2026 COMPLETE QUESTIONS
WITH VERIFIED CORRECT ANSWERS ||
100% GUARANTEED PASS
<NEWEST VERSION>


1. Which of the following items should be read first on every lesson?
a. Reference Material
b. Introductory Information
c. Learning Objectives
d. Question Number 1 - ANSWER ✔ b. Introductory Information


2. Which of the following represents the best method of answering the lesson
questions?
a. Answer all the lesson questions one knows first, then read the
reference material.
b. Answer the lesson questions from the reference material as one goes
along.
c. Read and study the reference material, then attempt to answer the
lesson questions.
d. Read the reference material, then answer only the lesson questions
one remembers. - ANSWER ✔ c. Read and study the reference
material, then attempt to answer the lesson questions.


3. Students should come to class with assigned homework complete and be
prepared to participate in class in a number of ways.
T/F - ANSWER ✔ True

,4. A student should read the lesson questions BEFORE reading the lesson
reference material.
T/F - ANSWER ✔ True


5. The keeper/gate of the snap hook should be positioned so that it is never
load bearing.
T/F - ANSWER ✔ True


6. Fall arrest anchor points must support a minimum of ? per attached worker
and be independent of worker support.
a. 4,000 lbs
b. 5,000 lbs
c. 7,000 lbs
d. 8,000 lbs - ANSWER ✔ b. 5,000 lbs


7. For fall arrest, the anchor point should always be kept ? the rear fall arrest
attachment.
a. above
b. below
c. diagonally to
d. perpendicular to - ANSWER ✔ a. above


8. Positioning side D-rings are intended for attachment of ? .
a. connecting device only
b. fall arrest only
c. rescue device only
d. work positioning only - ANSWER ✔ a. connecting device only


9. The sternal D-ring is for fall attachment when likely fall distance is not
greater than ? .
a. 1'

, b. 2'
c. 3'
d. 4' - ANSWER ✔ b. 2'


10.The dorsal D-ring, pigtail D-ring, or web loop are the ? for ? attachment.
a. primary / fall arrest
b. primary / work positioning
c. secondary / fall arrest
d. secondary / work positioning - ANSWER ✔ a. primary / fall arrest


11.The suspension bride is only used for ? .
a. fall arrest
b. rescue
c. travel restraint
d. work positioning - ANSWER ✔ d. work positioning


12.If a harness shows signs of minimal fraying, it should be discarded.
T/F - ANSWER ✔ False


13.Where should lanyards be attached on harnesses?
a. Front at sternum level
b. Lower back by the waist
c. Middle back near shoulder blades
d. Work positioning D-ring - ANSWER ✔ c. Middle back near shoulder
blades


14.A fall arrest attachment with a web loop must be attached to a harness with a
? or a ? .
a. hitch / carabiner
b. hitch / locking snap hook
c. hitch / metal connector

, d. none of the above - ANSWER ✔ a. hitch / carabiner


15.To help prevent climber cutouts, gaffs must be sharp, properly sized, and
properly shaped.
T/F - ANSWER ✔ True


16.Climbers should be inspected for ? .
a. gaff width and thickness
b. stirrup width, stirrup thickness, and gaff length
c. tip profile and cutting edge angle
d. all of the above - ANSWER ✔ d. all of the above


17.When should a plane test be performed?
a. Once a month after receiving climbers
b. When climbers have been received
c. When gaffs have been maintained
d. Any of the above - ANSWER ✔ d. Any of the above


18.The gaff is properly shaped and sharpened when it begins holding a distance
of ? .
a. 1"
b. 2"
c. 3"
d. 4" - ANSWER ✔ a. 1"


19.When performing the cut out test, at what distance should the gaff be pushed
into the pole?
a. 1/4"
b. 1/2"
c. 1"
d. 1 1/2" - ANSWER ✔ a. 1/4"