CCNP Switch Final Exam Questions with Correct Answers |New Update 100%
Verified By Experts
Refer to the exhibit. The indicated configuration was established on the HSRP standby router
RTB. However, the console message %IP-4-DUPADDR started appearing almost immediately on
the RTB router. Given the output of the show standby brief command on RTA, what is the cause
of the problem? The group number 50 is missing in the Router RTB configuration
commands.
Which statement correctly explains the process of mitigating ARP attacks on a switch where
dynamic ARP inspection (DAI) has been configured? The intercepted packets are verified
against the DHCP snooping binding table for valid IP-to-MAC bindings.
Refer to the exhibit. What feature does an SNMP manager need to be able to set a parameter
on ACSw1? a manager who is using host 192.168.0.5
Which statement is true concerning the core layer within the hierarchical design model?
Routing should be configured without traffic filtering, address translation, or other packet
manipulation at the core.
When a port security violation occurs on a switch port, the switch sends a syslog message but
does not shut down the port. What port security mode is in effect? restrict
Which three steps are required to configure interfaces as routed ports on a multilayer Catalyst
switch? (Choose three.) Enable IP routing globally.
Assign IP addresses to routed ports.
Disable Layer 2 functionality on interfaces that will be configured as routed ports.
A bridging loop occurs in a network and disrupts user connectivity. What action should be taken
by a network administrator to restore connectivity? Disable ports that should be in the
blocking state.
, Which three actions can cause problems with a VTP implementation? (Choose three.) using
a non-trunk link to connect switches
using non-Cisco switches
using lowercase on one switch and uppercase on another switch for domain names
Refer to the exhibit. What two conclusions can be made based on the output? (Choose two.)
Switch DLS1 is not the root bridge for VLAN 1.
The Cost column in the lower part of the exhibit is not the cumulative root path cost.
Which QoS requirement should be taken into account when implementing VoIP in a campus
environment? The QoS requirements should accommodate the smooth demand on
bandwidth, low latency, and delay for voice traffic.
When troubleshooting GLBP in an environment with a VLAN that spans multiple access layer
switches, a network engineer discovers that suboptimal paths are being used for upstream
traffic. What is the recommended solution? Use HSRP instead of GLBP.
Refer to the exhibit. What happens if interface gigabitEthernet 5/1 on SwitchA stops receiving
UDLD packets? UDLD changes the port state to err-disable.
How should a switch port be configured for a connection to a standalone wireless access point
that provides multiple VLAN-separated SSIDs? as a trunk port
Which two procedures should be implemented and in place when deploying VoIP in a campus
network? (Choose two.) Create voice VLANs to keep voice traffic separate from other data
to ensure special handling of the traffic.
Configure traffic shaping QoS policy to guarantee minimum delay for the voice traffic.
What are three possible misconfigurations or indicators of misconfigurations on a Layer 3
interface? (Choose three.) wrong IP address or subnet mask
Verified By Experts
Refer to the exhibit. The indicated configuration was established on the HSRP standby router
RTB. However, the console message %IP-4-DUPADDR started appearing almost immediately on
the RTB router. Given the output of the show standby brief command on RTA, what is the cause
of the problem? The group number 50 is missing in the Router RTB configuration
commands.
Which statement correctly explains the process of mitigating ARP attacks on a switch where
dynamic ARP inspection (DAI) has been configured? The intercepted packets are verified
against the DHCP snooping binding table for valid IP-to-MAC bindings.
Refer to the exhibit. What feature does an SNMP manager need to be able to set a parameter
on ACSw1? a manager who is using host 192.168.0.5
Which statement is true concerning the core layer within the hierarchical design model?
Routing should be configured without traffic filtering, address translation, or other packet
manipulation at the core.
When a port security violation occurs on a switch port, the switch sends a syslog message but
does not shut down the port. What port security mode is in effect? restrict
Which three steps are required to configure interfaces as routed ports on a multilayer Catalyst
switch? (Choose three.) Enable IP routing globally.
Assign IP addresses to routed ports.
Disable Layer 2 functionality on interfaces that will be configured as routed ports.
A bridging loop occurs in a network and disrupts user connectivity. What action should be taken
by a network administrator to restore connectivity? Disable ports that should be in the
blocking state.
, Which three actions can cause problems with a VTP implementation? (Choose three.) using
a non-trunk link to connect switches
using non-Cisco switches
using lowercase on one switch and uppercase on another switch for domain names
Refer to the exhibit. What two conclusions can be made based on the output? (Choose two.)
Switch DLS1 is not the root bridge for VLAN 1.
The Cost column in the lower part of the exhibit is not the cumulative root path cost.
Which QoS requirement should be taken into account when implementing VoIP in a campus
environment? The QoS requirements should accommodate the smooth demand on
bandwidth, low latency, and delay for voice traffic.
When troubleshooting GLBP in an environment with a VLAN that spans multiple access layer
switches, a network engineer discovers that suboptimal paths are being used for upstream
traffic. What is the recommended solution? Use HSRP instead of GLBP.
Refer to the exhibit. What happens if interface gigabitEthernet 5/1 on SwitchA stops receiving
UDLD packets? UDLD changes the port state to err-disable.
How should a switch port be configured for a connection to a standalone wireless access point
that provides multiple VLAN-separated SSIDs? as a trunk port
Which two procedures should be implemented and in place when deploying VoIP in a campus
network? (Choose two.) Create voice VLANs to keep voice traffic separate from other data
to ensure special handling of the traffic.
Configure traffic shaping QoS policy to guarantee minimum delay for the voice traffic.
What are three possible misconfigurations or indicators of misconfigurations on a Layer 3
interface? (Choose three.) wrong IP address or subnet mask
