NATE CORE PACKAGE DEAL

An air conditioning technician is working in the basement of a large B37public building. The technician notices several unsafe and dangerous conditions. Of the following conditions that are noticed, which is the most dangerous and should be reported immediately? A: Gas leaking from a cracked pi...

Low airflow over a residential split system air conditioning evaporator can cause A: Liquid flood-back to the compressor B: A decrease in compression ratio C: An increase in suction line superheat D: Oil logging in the evaporator - ️️A: Liquid flood-back to the compressor W...

Ch. 1-1 The ability to utilize all types of communication skills is ________ to the HVACR technician. a) not as important as "hands-on" technical skills b) somewhat important c) unimportant d) very important - ️️d) very important Ch. 1-2 It is important to be _______ in filling out ser...

Which of the following factors affects a customer's level of comfort? a. Air movement b. Humidity c. Temperature d. All of the above - ️️d (All of the above: air movement, humidity, temperature) A cooling load calculation estimates the sensible heat gain of a structure. The maximum sen...

In HVACR terms, what is a feature? - ️️A special characteristic of a product. In HVACR terms, what is a benefit? - ️️The value the customer receives from using the feature What type of temperature is often used by customers when discussing human comfort? - ️️Dry bulb What is an ...

Charging a heat pump with refrigerant is best accomplished in the _______ mode. A: Heating mode B: Cooling mode C: Defrost mode D: Emergency heating mode - ️️B: Cooling mode Heat pumps can provide both heating in the winter and cooling in the summer. In which mode is the heat ...

Class A - ️️Ordinary Extinguisher Class B - ️️Liquid Extinguisher Class C - ️️Electrical Extinguisher Asphyxiation causes what? - ️️Nausea, Dizziness, Heart Irregularities, and Unconciousness Ladder must be at what dimensions in relation to a house? - ️️4 ft for every...

A system is supplied from the factory with charge of 5 pounds 10 ounces for a 15 foot line set. The line set is 25 feet long. The manufacturer's instruction sheet specifies 0.6 ounces of refrigeration to be added for each added foot of refrigerant line set length. What is the total refrigerant char...

Since 1992, the United States Department of Energy has required that all furnaces sold and installed from that date on must have an AFUE of no less than: A: 70% B: 75% C: 78% D: 80% - ️️C: 78% Many pre-1992 furnaces have efficiencies around _______. A: 10% B: 40% C...

What method of heat transfer does not require fluid or solids? - ️️Radiation Capillary tubing should only be cut to length using a - ️️Triangular or knife edge file Before beginning any electrical check out procedure what step must always be taken after the equipment disconnect or circ...