MEDICAL GAS INSTALLERS FINAL EXAM AND PRACTICE EXAM QUESTIONS 2025 NEWEST
ACTUAL EXAM COMPLETE QUESTIONS WITH DETAILED VERIFIED ANSWERS (100%
CORRECT ANSWERS) /ALREADY GRADED A+
The Medical air compressor intake shall be located a minimum of how many feet away from any exhaust
or plumbing vents? - (ANSWER)25 feet
when is the initial pressure test conducted, by a Medical gas installer, on a nitrous oxide system?
A) after the blowdown of a distribution piping
B) after the installation of the alarm sensors
C) before the blowdown of the distribution piping
D) before the instillation of station rough-in assemblies - (ANSWER)A) after the blowdown of a
distribution piping
In those portions of systems intended to handle oxygen at pressure greater than 350 psi the
interconnecting hose shall not contain what materials?
A) Brass
B) Copper
C) Polymeric
D) stainless steel - (ANSWER)
In a category 1 dental and gas vacuum piping system, which of the following is an NFPA 99 requirement
for the labeling of pipes?
A) color coding
B) fixed label width
C) label shall wrap completely around the pipe
D) reflective label - (ANSWER)
ACTUAL EXAM COMPLETE QUESTIONS WITH DETAILED VERIFIED ANSWERS (100%
CORRECT ANSWERS) /ALREADY GRADED A+
The Medical air compressor intake shall be located a minimum of how many feet away from any exhaust
or plumbing vents? - (ANSWER)25 feet
when is the initial pressure test conducted, by a Medical gas installer, on a nitrous oxide system?
A) after the blowdown of a distribution piping
B) after the installation of the alarm sensors
C) before the blowdown of the distribution piping
D) before the instillation of station rough-in assemblies - (ANSWER)A) after the blowdown of a
distribution piping
In those portions of systems intended to handle oxygen at pressure greater than 350 psi the
interconnecting hose shall not contain what materials?
A) Brass
B) Copper
C) Polymeric
D) stainless steel - (ANSWER)
In a category 1 dental and gas vacuum piping system, which of the following is an NFPA 99 requirement
for the labeling of pipes?
A) color coding
B) fixed label width
C) label shall wrap completely around the pipe
D) reflective label - (ANSWER)