CDT EXAM 2024 WITH COMPLETE
SOLUTIONS
The incisal edge of the maxillary laterals should - ANSWERSnot touch the occlusal plane
A working relation occurs when the - ANSWERSmandibular buccal cusps contact the central fossae of the
maxillary teeth
Which is not a common error when mounting casts that affect jaw relations? - ANSWERS(all of the
above) interference in the posterior region of the casts. the failure to close the articulator, interference
in the posterior region of the base plate and occlusa1 rims
Selection of the posterior teeth is based on - ANSWERSthe size of the residual ridge
The midline should be determined by the dentist. However, if this information is missing or unclear, it
can be determined by the technician after locating - ANSWERSincisal papilla
If a Jig is not closed completely during the relining of a complete denture, what will occur? -
ANSWERSincreased vertical dimension
A maxillary denture's distal border is determined by - ANSWERS(all of the above) The distal end of the
denture must cover the tuberosities, extend into the hamular notches,
and it should end 1-2 mm posterior to the vibrating line
The irregular rloges in the mucous membrane located in the anterior portion of the hard palate are -
ANSWERSrugae
When refining excursive movements by selective grinding. - ANSWERS(any of the above procedures are
acceptable) one side should be completed before the opposite side is started, one side should be
completed and then the opposite quadrant, both posterior quadrants Should be ground simultaneously
SOLUTIONS
The incisal edge of the maxillary laterals should - ANSWERSnot touch the occlusal plane
A working relation occurs when the - ANSWERSmandibular buccal cusps contact the central fossae of the
maxillary teeth
Which is not a common error when mounting casts that affect jaw relations? - ANSWERS(all of the
above) interference in the posterior region of the casts. the failure to close the articulator, interference
in the posterior region of the base plate and occlusa1 rims
Selection of the posterior teeth is based on - ANSWERSthe size of the residual ridge
The midline should be determined by the dentist. However, if this information is missing or unclear, it
can be determined by the technician after locating - ANSWERSincisal papilla
If a Jig is not closed completely during the relining of a complete denture, what will occur? -
ANSWERSincreased vertical dimension
A maxillary denture's distal border is determined by - ANSWERS(all of the above) The distal end of the
denture must cover the tuberosities, extend into the hamular notches,
and it should end 1-2 mm posterior to the vibrating line
The irregular rloges in the mucous membrane located in the anterior portion of the hard palate are -
ANSWERSrugae
When refining excursive movements by selective grinding. - ANSWERS(any of the above procedures are
acceptable) one side should be completed before the opposite side is started, one side should be
completed and then the opposite quadrant, both posterior quadrants Should be ground simultaneously
