ASM CDC 3 AND 4 Exam Questions with Complete Solutions

When you are installing aircraft bolts in a panel you place shims under the plate nut? - ANSWER-because the grip length of the bolt is slightly greater How can you avoid stripping threads when installing a nut and bolt? - ANSWER-Torque the nut to proper specifications The fastener removal tool is primarily designed for use on a - ANSWER-flat surface The most you should turn a screw with a screw punch tool is - ANSWER-one-quarter (1/4) turn What nut style do you use when all bolt hole locations are equally spaced around an opening? - ANSWER-Channel Which nut is used where the assembly is frequently removed and you can obtain the desired tightness with your fingers? - ANSWER-wing The two major types of self-locking nuts you will install are - ANSWER-Prevailing torque and free spinning You need to consider heat requirements for which prevailing torque, self-locking nut locking device? - ANSWER-Nonmetallic insert When a rigid type camloc receptacle needs to be replaced you replace - ANSWER-it with a floating receptacle What is the final step that completes a camloc fastener assembly installation? - ANSWER-check the grip length of the stud To properly install a new flush-type airloc turn-lock fastener, the size of the punched hole in the access panel should be - ANSWER-approximately the same size as the diameter of the stud shank What part of an airloc assembly is never reused? - ANSWER-Cross-pin When drilling holes for fasteners you can maintain proper hole alignment by - ANSWER-Clamping all repair members in place How do you drill an interference fit hole for a fastener? - ANSWER-Pilot drill the hole and use a reamer to finish