- Study guides, Class notes & Summaries
Looking for the best study guides, study notes and summaries about ? On this page you'll find 17 study documents about .
17 results
Exam (elaborations)
Chapter 6 to 12 OBT3 Test Questions Fully Solved.
fuel oil is a member of the __________ family of chemical compounds - Answer hydrocarbon 
 
approximately 96% to 99.75% of the fuel oil is composed of: 
a) methane and propane 
b)sulphur, oxygen and nitrogen 
c) hydrogen and carbon 
d)manufactured oil - Answer c) hydrogen and carbon 
 
that two general categories of refined fuel oils are: 
a) distillates and residuals 
b)light and dark 
c)natural and manufactured 
d)cracked and uncracked - Answer a) distillates and residua...
Exam (elaborations)
OBT 3 Questions and All Correct Answers.
Popular1 You must never use a chisel with a ______ head. - Answer mushroomed 
 
3. A ____ wrench is better suited to loosening tight nuts. - Answer box 
 
4. Name three types of snips: - Answer Straight snips 
combinations snips 
Compound snips 
 
Name three types of pliers: - Answer needle nose 
side cutters 
channel locks 
 
5. A masonry drill bit is suited for drilling into concrete due to its _____ tip. - Answer carbide 
 
6.____ hammers are best suited for striking chisels...
Exam (elaborations)
Oil tech test Questions and All Correct Answers 2026 Updated.
whats a good definition for viscosity - Answer viscosity is resistance to flow 
 
whats the flash point of number 2 heating fuel - Answer 115 degrees 
 
whats the pour point of number 2 heating fuel - Answer 17 degress Fahrenheit 
	 
what is a btu - Answer the amount of energy to raise one pound of water one degree fairenheit 
 
choose the formula used to determine the cubic foot of air required for proper combustion - Answer GPHx1540x 1.25 = 
 
what would u do if you ha...
Exam (elaborations)
OIL HEAT Questions and All Correct Answers.
The oil-fired, forced-warm-air furnace has two main systems: Which are... - Answer Heat-producing system and heat-distributing system 
 
What is the heat-producing system? - Answer consists of the oil burner, fuel supply components, combustion chamber, and heat exchanger. 
 
What is the heat-distribution system? - Answer composed of the blower, which moves the air through the ductwork, and other related components 
 
After the thermostat calls for heat, what happens? - Answer ...
Exam (elaborations)
OBT3- Chapter 14 Questions and Already Passed Answers 2026-2027 Updated.
Which of the following statements is correct? 
 
Pressure is defined as: 
 
a) Weight per cubic foot. 
b) Force (as measured by weight) exerted against known area. 
c) Force (as measured by weight) exerted against known volume. 
d) All of the listed choices - Answer B 
 
Which of the following statements is correct? 
a) Gases flow from a low pressure to a higher pressure. 
b) Gases do not flow unless pushed by mechanical devices. 
c) Gases flow from a high pressure to a lower pressure. 
d...
Exam (elaborations)
OBT3 Ch. 7 & 11 Questions with Guaranteed Pass Solutions 2026 Updated.
Describe the purpose(s) of a combustion chamber. 
Select one or more: 
a. 
rapid heat up/cool down 
b. 
contains the flame 
c. 
reflects heat back into the flame - Answer a. rapid heat up/cool down 
b. contains the flame 
c. reflects heat back into the flame 
 
Increasing excess air will _______________ (increase or decrease) the temperature of the flame and ________________ (increase or decrease) the temperature of the flue gases leaving the heat exchanger. - Answer excess air will DE...
Exam (elaborations)
Chapter 13 to OBT3 Final Exam with Quality Answers 2026-2027 Updated.
The recommended hot water temperature for domestic uses 
A) 160 F 
B) 100 F 
C) 130 F 
D) 180 F - Answer C) 130 F 
 
True or false 
To repair a leakage temperature and pressure relief valve a plug would be allowed until a new valve could be ordered - Answer False 
 
Explain the service problems of a water tank with a broken dip tube - Answer Cold water would not be pushed to the bottom of the tank, burner cycle would fail 
 
"Stacking" in a water heater could be the resul...
Exam (elaborations)
P-99 / Low PSI Oil Burner Operator Final Exam Questions and All Correct Answers. 
 

All heating, combustion, and cooking equipment shall be provided with insulation or the building construction shall be fire protected, so that during operation the surface of combustible construction materials will not be raised to a temperature higher than ____. - Answer 170 ̊ F 
 
Acceptance tests: Boilers shall not be placed in operation upon completion of construction until they have been ____ and an equipment use permit has been issued by the commissioner. - Answer Inspected and ...
Exam (elaborations)
Mass oil burner / NFPA 31 & NORA Questions Fully Solved.
Cast iron fittings can be used in heating fuel systems? - Answer False 
 
Tank vent shall terminate - Answer Within 12 feet of the fill and visible from the fill 
 
Tanks exceeding 330 gallons must have - Answer Top supply connection 
 
Fuel return piping from an appliance shall - Answer Enter the top of the tank 
 
Oil appliances burning used oil shall only be installed - Answer In commercial or industrial occupancies 
 
Technician must be present for filling of new oil...
Exam (elaborations)
MA oil burners Test Questions and All Correct Answers 2026-2027 Updated. 
 

Air Heater. - Answer . An indirect-fired appliance intended to supply heated air for space heating and other purposes, but not intended for permanent installation. 
 
Air pressure switch . - Answer An electrical switch designed to prove that the proper draft has been established by the power venter or burner and allows the burner to operate. If the power venter or burner is not performing so as to satisfy the operating requirements of the equipment for safe performance, the switch will...
Exam (elaborations)
OBT3 6 & 10 And Ch. 7 & 11 Final Exam with Guaranteed Pass Solutions.
As the ratio of carbon to hydrogen atoms increases in comparing hydrocarbon molecules then the heavier the molecule, the slower it burns and the more heat per volume it produces 
Select one: 
True 
False - Answer true 
 
Approximately 96% to 99.75% of fuel oil is composed of: 
Select one: 
a. 
methane and propane 
b. 
sulphur, oxygen and nitrogen 
c. 
hydrogen and carbon 
d. 
manufactured oil - Answer hydrogen and carbon 
 
The minimum flash point of No. 2 fuel oil allowed by Standard ...
Exam (elaborations)
OBT3 Final EXAM Questions with Guaranteed Pass Solutions All Solved Graded A+.
Which of the following should be worn when using power tools? 
a) Safety glasses 
b) A hard hat 
c) Leather gloves 
d) Safety boots - Answer A 
	 
What is the minimum acceptable type of respiratory protection to be used when cleaning a soot filled furnace? - Answer Disposable Filter Masks 
 
What is the proper vertical to horizontal distance ratio for ladder placement? - Answer 3:1 or 4:1 
 
What muscles or parts of your body should you primarily use to lift a weight from the ...
Exam (elaborations)
OBT3 Final Exam Questions And All Correct Answers 2026-2027 Updated. 
 

Chapter 1 - Safety - Answer 
 
Which of the following should be worn when using power tools - Answer Safety glasses 
 
Ratio for a ladder - Answer 3:1 or 4:1 
 
What is the minimum acceptable type of respiratory protection to be used when cleaning a soot filled furnace - Answer Disposable filter mask 
 
What muscles or parts of your body should you primarily use to life a weight from the floor - Answer Leg muscles 
 
Water on wood fires, electrical fires, and flammable ...
Exam (elaborations)
OBT3 Final Exam Questions and All Actual Answers 2026 Updated. 
 

Fuel oil is a member of the _______ family of chemical compounds. - Answer Hydrocarbon 
 
Approximately 96% to 99.75% of fuel oil is composed of - Answer Hydrogen and carbon 
 
The two general categories of refined fuel oils are - Answer Distillates and residuals 
 
True or false: kerosine is classified separately from fuel oil but considered as fuel oil under the fuel oil code - Answer True 
 
0 fuel oil application - Answer Intended for use in appliances in far norther...
Exam (elaborations)
OBT: Unit 9 (gas) & OBT Test Questions All Solved 2026-2027 Updated. 
 

What term is used to describe a burner flame that moves back through the burner nozzle? 
a. floating flame 
b. flame lift 
c. flash back 
d. orange flashing flame - Answer c. flash back 
 
through which device is fuel discharged to an atmospheric burner? 
a. orifice 
b. nozzle 
c. zero governor - Answer a. orifice 
 
which type of atmospheric burner produces a single large flame? 
a. inshot burner 
b. single or mono-port burner 
c. drilled port burner 
d. upshot burner - Answer...
Exam (elaborations)
OBT 3 Final Exam Questions Fully Solved.
1 You must never use a chisel with a ______ head. - Answer mushroomed 
 
3. A ____ wrench is better suited to loosening tight nuts. - Answer box 
 
4. Name three types of snips: - Answer Straight snips 
combinations snips 
Compound snips 
 
Name three types of pliers: - Answer needle nose 
side cutters 
channel locks 
 
5. A masonry drill bit is suited for drilling into concrete due to its _____ tip. - Answer carbide 
 
6.____ hammers are best suited for striking chisels...
Exam (elaborations)
OBT 2 Mohawk Exam Questions with Complete Solutions 2026.
About _____________ cubic feet of air is required to ensure complete combustion of one [1] gallon of #2 fuel oil. - Answer 2000 
 
T/F? Air supply openings that communicate with the outdoors of a building must be located not less than twelve [12] inches above the outside grade level. - Answer True 
 
An oil-fired boiler with an input of 0.75 USGPH that is vented into a clay lined masonry chimney 20 feet high must maintain a minimum base temperature of ____________ °F. - Answer 32...