Samenvattingen, Notities en Examens

MD Stationary Engineer Exam Questions with All Correct Answers Gases of Combustion that cool on Contact with the boiler heating Surface before combushion is completed Cause a(n) _________ - ANSWER Formation of soot and smoke In the event of a flame failure, the programmer will______ - ANSWER Secure the fuel, purge the firebox, and then shut down Boil the water must be conditioned to prevent ______ (3 Answers) - ANSWER Formation of scale, oxygen pitt...

Stationary Engineer Exam Questions and Answers 100% Pass How much clearance from the top of the boiler is needed for a HP boiler that produces 70000 lbs of steam? - Correct Answer ️️ -7 feet On a gas fired boiler what is the proper gas to air mixture - Correct Answer ️️ -30%- 70% and in special arrangements it can be as high as 100% . ANSWER CHAPTER 11 remember% What is the total hardness in a system that was found to have calcium hardness of 60ppm and magnesium hardness of 18ppm...

Ohio stationary steam engineer Exam Questions and Answers 100% Pass Combustion efficiency may be increased by_____ the primary air - Correct Answer ️️ -Preheating What is the purpose of cinder reinjection? - Correct Answer ️️ -increase efficiency 2 forces of equal intensity acting in opposite directions is? - Correct Answer ️️ -tension What is true about the dew poimt of flue gasses - Correct Answer ️️ -dew point is the temp at which the gasses will condense What will not...

Stationary Engineer Electric Exam Questions and Answers 100% Pass An AC circuit consists only of a pure inductance and a power source. The relationship between the voltage and the current in this circuit is that the - Correct Answer ️️ - current lags the voltage The power factor of a load is equal to the ____________ power divided by the ____________ power. - Correct Answer ️️ -True ; apparent A 10-ohms and 20-ohms resistor are connected in parallel. The total line current drawn ...

3rd class stationary steam engineer license prep Questions and Answers 100% Pass _________ are necessary for complete combustion - Correct Answer ️️ -time, temperature, mixture, and atomization if the steam pressure gauge indicates 200 PSIG, the absolute pressure is______ - Correct Answer ️️ -214.7 a boiler is operating at 400 PSI, and the safety valve opens at 410 PSI and closes at 398 PSI. The blowdown is______psi - Correct Answer ️️ -12 an oil cooler is commonly used with ...

upStationary Grade 3 Engineering License Exam Questions and Answers 100% Pass how can you loose your license? - Correct Answer ️️ -1) drinking on the job 2) sleeping on the job 3) negligence 4) unsafe work 5) signing a falsified license application for someone 6) failing to renew your license annually what must you do if you change jobs? - Correct Answer ️️ -notify city hall if you change jobs, address or retire why should you do rounds? - Correct Answer ️️ -Find and correc...

Deaerator - A Device used to remove oxygen from boiler feedwater The term "quality of steam" has to do with steams - Moisture content A sleeve is used on the shaft of a centrifugal pump to - Protect the shaft The purpose of an adjusting ring on a safety value is to - Regulate the amount of steam exhausted The maximum wattage allowed on a 30 ampere fuse is (supply line is 115 volts) - W = V x I W = 115 x 30 W = 3450 watts A tachometer is used to measure - Revolution per minute If a Fah...

Stationary Engineer Exam Study Guide How much clearance from the top of the boiler is needed for a HP boiler that produces 70000 lbs of steam? - 7 feet On a gas fired boiler what is the proper gas to air mixture - 30%-70% and in special arrangements it can be as high as 100% . ANSWER CHAPTER 11 remember% What is the total hardness in a system that was found to have calcium hardness of 60ppm and magnesium hardness of 18ppm and carbon hardness of 12 ppm? - TH=(Ca x 2.5) + (Mg x 4.1)...

Stationary Engineer Exam - Questions and Answers (Complete Solutions) How much clearance from the top of the boiler is needed for a HP boiler that produces 70000 lbs of steam? 7 feet On a gas fired boiler what is the proper gas to air mixture 30%-70% and in special arrangements it can be as high as 100% . ANSWER CHAPTER 11 remember% What is the total hardness in a system that was found to have calcium hardness of 60ppm and magnesium hardness of 18ppm and carbon hardness of 12 ppm? TH= (Ca x 2....

Scribe Academy Final Exam Questions And Answers 100% Verified What is the HPI? - answerHistory of present illness; the opening to the patient's story What kind of symptoms should HPI provide? - answeracute and chronic symptoms What are the first elements of the hpi? - answerchief complaint and patient identification What is indicative of patients taking synthroid, levothyroxine, or armour thyroid? - answerHYPOthyroidism What is the scale for prediabetes? - answerA1c < 6.4 If, the pat...