A plus

1 Big Box - 0.20 sec 1 Small Box - 0.04 sec 1st Degree AV Block - Regular Rate: 60-100 P Wave: Present, upright PR interval: >0.20 sec CONSISTENTLY LONG QRS: <0.12 sec Husband stays late till 9 consistently 2nd Degree AV Block Type I Mobitz, Wenckebach - IRREGULAR Rate: 60-100 P wave: Present, upright PR Interval: Progressively longer until dro

1% solution equals - One gram of medication in 100% mL solution. [1g also = 10oomg] 3 characteristics of normal heart rhythms - Rate, regularity, and rhythm. 4 key questions to ask patient in evaluation - Are they currently under physicians care, do they take any meds, do they have any allergies and reactions they have, review of systems. A beta blocker would be given in which emergency? - Hypertension A fluid bolus of NS and ephedrine can be given with what emergency? - Hypotension ...

1 Big Box - 0.20 sec 1 Small Box - 0.04 sec 1st Degree AV Block - Regular Rate: 60-100 P Wave: Present, upright PR interval: >0.20 sec CONSISTENTLY LONG QRS: <0.12 sec Husband stays late till 9 consistently 2nd Degree AV Block Type I Mobitz, Wenckebach - IRREGULAR Rate: 60-100 P wave: Present, upright PR Interval: Progressively longer until drop (PR interval longer and longer until drop) QRS: <0.12 sec Husband stays late till 9, then 11, then 1, then doesn't com...

A medication drip is ordered at 13 units/kg/hr.The patient weighs 50 kg. The medication is available in a concentration of 25,000 units/500 mL. The medication should be infused at _____mL per hour. Answer- 13 A medication is ordered as an IV drip at 3 units/kg/hr for a patient weighting 108 kg. The concentration of the medication is 2 units/mL. The drip should be set at _____ mL/hr. - Answer 162 A patient weighs 630 grams and has a glucose level of 208 mg/dL. The Physician has ordered Insu...

A sample contains aggregate larger than that appropriate for the size of the moulds or equipment. - Answer It must be wet-sieved prior to testing Air Content - Answer The volume of air voids of plastic concrete, exclusive of pore space in aggregate particles, determined through observations of the change of air volume in concrete with a change in

A board pushed vertically into a pile just above the sampling point aids in preventing further segregation. A) True B) false - Answer A) True A relative yield value of mire than 1.000 indicates the batch is "short of it's designated volume". A) True B) False - Answer B) False An excess of concrete protruding approximately ________ mm above the top of the measure after consolidation is optimum. A) 1 B) 2 C) 3 D) none of the above - Answer C) 3 Bleeding and expansion of grout is perfor...

Measuring Bowl - Answer Sufficiently rigid to limit expansion to 0.1% of scale reading at operating pressure. 7L bowl maximum aggregate size of 40mm, 15L bowl maximum aggregate size of 56mm. Moisture Room - Answer Temperature must be read every 15 mins by a recorder- Must be accurate to 1 degree C. Movable Portion of Bearing Block - Answer Must be able to rotate freely and tilt 4 degrees in any direction. Perpendicularity - Answer No specimen shall depart from perpendicularity to t...

A sample contains aggregate larger than that appropriate for the size of the moulds or equipment. - Answer It must be wet-sieved prior to testing Air Content - Answer The volume of air voids of plastic concrete, exclusive of pore space in aggregate particles, determined through observations of the change of air volume in concrete with a change in pressure. Air Guage Dial - Answer Permits direct reading to a minimum of 0.2% for air volumes in the usual range of 0-8%. Air Meter Readin...

A23.2-3C 1. Scope - This Test Method specifies the procedure for making and curing compression test cylinders and flexural test beams from samples of plastic concrete. Procedures for both field and laboratory work are included. Answer ACI - American Concrete Institute A23.2-3C 3. Summary - Answer This Test Method is used to cast compressive or flexural strength test specimens and cure them on site prior to timely transportation to the laboratory for subsequent curing and strength testing...

Category 1 and 2 License annual fee -Answer $400 Category 1 License - Answer LP Gas Dealer (can sell, deliver, exchange, and install appliances and piping, requalify cylinders) Category 2 License - Answer LP Gas Dispenser (dispensing, selling and storing) Category 3 and 4 License annual fee - Answer $65 Category 5 and 6 License annual fee - Ans