FOR THE BEST EXAMS AND VERIFIED ANSWERS GURANTEED A+

ABYC Proctored Exam With Comkpete Solution {} FALSE. End fittings introduce the possibility of high resistance. TE-4, Conductors - CORRECT ANSWER-A sailboat's rigging is considered a reliable path to ground for lightning? T/F? Spark igntion Diesel Study Guide, Chapter 1 - CORRECT ANSWER-Gasoline engines use what kind of ignition? Compression ignition Diesel Study Guide, Chapter 1 - CORRECT ANSWER-Diesel engines use what kind of ignition?

ABYC Electrical exam with certified question & answer (100% correct) higher voltage increased capacity - CORRECT ANSWER-2 or More batteries connected in series provides_________, or in parallel to provide_________ hydrogen - CORRECT ANSWER-Batteries gas of what the engine negative terminal or the DC main negative bus - CORRECT ANSWER-If an AC system is installed the main AC system grounding bus shall be connected to what? isolation transformer isolates all current crying AC system con...

Abyc Electrical Latest Exam 1. ALL OF THE FOLLOWING COULD CAUSE A CONDUCTOR TO OVERHEAT EXCEPT: - CORRECT ANSWERINSULATION TEMPERATURE RATING TOO LOW 1. THE MINIMUM BATTERY RESERVE CAPACITY IN HOURS OR MINUTES FOR SUPPLIED BATTERY POWER IS_____BASED ON ABYC - CORRECT ANSWER-90 MINUTES what is ohm's law the measure of - CORRECT ANSWER-resistance 1. TECH A SAYS THAT A FAULTY CIRCUIT BREAKER COULD REQUIRE AN OVERHAUL. TECH B SAYS THAT CIRCUIT BREAKERS USED IN RECREATIONAL MARINE APPLICAT...

ABYC Marine Electrical Exam With Multiple Choices & Certified Answers When selecting an inverter, ___ is the primary concern. A. physical size B. output capacity C. connection type D. power-feed type - CORRECT ANSWER-B. output capacity The efficiency loss through inverters is typically between ___, so a battery charger cannot be powered from one and create a perpetual system. A. 0.5% to 3% B. 5% to 15% C. 20% to 25% D. 35% to 50% - CORRECT ANSWER-B. 5% to 15

ABYC Marine Exam Question & Correct Answer (A+ Graded) Every 18 inches. - CORRECT ANSWER-How often (in inches) shall wire bundles be supported? Insulated Metallic Hanger Clamps - CORRECT ANSWER-What type of clamps are to be used for supporting wire bundles when routed over engines and machinery? 40 lbs (E-11 Table XV) - CORRECT ANSWER-What tensile force must a 10 Gauge crimp connector withstand for one minute?

ABYC Marine Study Guide Test With Complete Solution If Voltage at shore power goes up under additional loads this is indicative of.... - CORRECT ANSWERGround/ Neutral connection ELCI trips at how many mA? - CORRECT ANSWER-30 miliamps @100 ms One horsepower = _________ Watts - CORRECT ANSWER-746 watts Most common type of circuit fault is? - CORRECT ANSWER-unwanted open

Abyc Proctored Exam Question & Correct Answer 2024 require on all wet exhaust system - CORRECT ANSWER-an indicator of loss of exhaust cooling water is 1" - CORRECT ANSWER-the lowest point of a self-bailing cockpit sole shall be how high above the full load water line to prevent bilge pump cycling - CORRECT ANSWER-a check valve can be used in a bilge pump's discharge line length of discharge piping , number and radius of bends, and roughness of interior surfaces of piping of fittin...

ABYC Proctored Exam Question & Correct Answer () Polyethylene - CORRECT ANSWER-What is the most often used materials for potable water systems? 1. Copper Alloys (incl. bronze, brass and nickel-copper) 2. AISI Type 300 series stainless steel 3. Glass-lined metal 4. FDA approved plastic 5. FDA approved rubber - CORRECT ANSWER-Name 5 materials allowable for contact use in potable water systems: Siphon Break - CORRECT ANSWER-What device can be used to separate potable water from other w...

ABYC Latest Exam With Certified Answer (A+ Graded) E - CORRECT ANSWER-Ball valves may be sealed to through hull fittings with: A. 5200 B. SikaFlex C. Teflon D. All the above E. None of the above B - CORRECT ANSWER-Tubes are measured by: A. ID B. OD C. nominal size

Small Boat Exam Question & Correct Answer () `With what types of boats will most NJROTC cadets come into contact while on training visits to Navy ships and shore stations? - CORRECT ANSWER-powerboat A powerboat - CORRECT ANSWER-any .vessel that is propelled through the water by some type of motor or engine. A sailboat - CORRECT ANSWER-a vessel that is propelled mainly by the wind through the use of some type of sail a motor sailor - CORRECT ANSWER-are designed to be propelled by bot...