- Study guides, Class notes & Summaries
Looking for the best study guides, study notes and summaries about ? On this page you'll find 129 study documents about .
129 results
Exam (elaborations)
ASE BRAKES Exam #4 pdated 2024/2025 Questions and Answers 100% Correct.
The right rear brake is dragging on a vehicle with independent rear suspension. All other brakes operate 
normally. Which of the following could be the cause? 
A. Damaged right front brake line 
B. Damaged right rear brake line 
C. Damaged left rear brake line 
D. Damaged left front brake line - B 
A height sensing proportioning valve would be located on: 
A. The left front. 
B. The right front. 
C. The rear in the center. 
D. Only on all wheel drive vehicles. - C 
A vehicle equipped with a hydr...
Exam (elaborations)
ASE BRAKES Exam 1questions well answered CORRECT!!!
ASE BRAKES Exam 1questions well answered CORRECT!!!
Package deal
Ase Exam Package Deal With Complete Solutions.
Ase Exam Package Deal With Complete Solutions.
Exam (elaborations)
ASE BRAKES Exam #1 Questions and Answers (Latest Update 2024)
ASE BRAKES Exam #1 Questions and Answers (Latest Update 2024)
Exam (elaborations)
ASE BRAKES Exam #1 Questions and Answers(A+ Solution guide)
A drum is chattering on the brake lathe. This could be the result of: 
A. Failure to install the dampening belt. 
B. Cutting too slowly. 
C. Dull cutting blades. 
D. Cutting speed too fast. - Answer-A 
A vehicle is equipped with a hydro-boost brake system has a hard pedal with little braking action. Which 
of the following could be the cause? 
A. Low brake fluid 
B. Air in the brake fluid 
C. Low power steering fluid 
D. An overtightened power steering belt - Answer-C 
Which of the following cou...
Exam (elaborations)
Ase Brakes Exam With Guaranteed Correct Answers
A - correct answer A drum is chattering on the brake lathe. This could be the result of: 
A. Failure to install the dampening belt. 
B. Cutting too slowly. 
C. Dull cutting blades. 
D. Cutting speed too fast. 
 
C - correct answer A vehicle is equipped with a hydro-boost brake system has a hard pedal with little braking action. Which of the following could be the cause? 
A. Low brake fluid 
B. Air in the brake fluid 
C. Low power steering fluid 
D. An overtightened power steering belt 
 
D - co...
Exam (elaborations)
ASE BRAKES Exam Complete Questions and Answers 2024 Latest Edition
ASE BRAKES Exam Complete Questions and Answers 2024 Latest Edition
Exam (elaborations)
Ase Brakes A5 Test (Exam 1), Ase A5 Brakes, Ase Brakes A5 (Exam 3), Ase Brakes A5 Test (Exam 2) All In One Perfect Studypack Updated 2023 With Detailed Rationales
Ase Brakes A5 Test (Exam 1), Ase A5 Brakes, 
Ase Brakes A5 (Exam 3), Ase Brakes A5 Test 
(Exam 2) All In One Perfect Studypack 
Updated 2023 With Detailed Rationales
Exam (elaborations)
Ase Brakes A5 Test (Exam 1), Ase A5 Brakes, Ase Brakes A5 (Exam 3), Ase Brakes A5 Test (Exam 2) All In One Perfect Studypack Updated 2023 With Detailed Rationales
Ase Brakes A5 Test (Exam 1), Ase A5 Brakes, 
Ase Brakes A5 (Exam 3), Ase Brakes A5 Test 
(Exam 2) All In One Perfect Studypack 
Updated 2023 With Detailed Rationales
Exam (elaborations)
Chapter 92,, Braking System Components And Performance Standads Questions And Answers
1.	1. Disc brakes use replaceable friction material called 	. 
a.	Linings 
b.	Pads 
c.	Core 
d.	Web: b. Pads 
2.	2. Drum brakes use replaceable friction material called 	. 
a.	Shoes 
b.	Pads 
c.	Core 
d.	Web: a. Shoes 
3.	3. Technician A says that a power-assisted brake reduces stoping distances compared with nonpower-assisted brake system. Technician B says that the power-assisted brake system reduces the force that the driver must exert on the brake pedal. Which technician is correct? 
a.	Tech...
Exam (elaborations)
Ase Brakes A5 Test ( Exam 1 ) Questions And Answers
1.	A drum is chattering on the brake lathe. This could be a result of 
a.	failure to install the dampening belt 
b.	cutting too slowly 
c.	dull cutting blades 
d.	cutting speed too fast 
 
 
 
 
 
 
 
2.	A vehicle equipped with a hydro-boost brake system has a hard pedal with little braking action. Which of the following could be the cause? 
a.	low brake fluid 
b.	air in the brake fluid 
c.	low power steering fluid 
d.	an overtightened power steering belt 
3.	Which of the following could cause e...
Exam (elaborations)
Ase Brakes Exam Questions And Answers
drum is chattering on the brake lathe. This could be the result of: 
A missing dampening belt could cause the drum to vibrate while on the lathe. This vibration can cause the drum to bounce on the cutting tip and make a chattering noise. 
 
 
A vehicle equipped with a hydro-boost brake system has a hard pedal with little braking action. Which of the following could be the cause? 
Low power steering fluid can cause the booster to provide very little if any boost. 
 
 
10 Must-Have Accessories for...
Exam (elaborations)
Ase Brakes Exam 3
A - Answer- The goal of burnishing the brakes after a complete brake service is to: 
A. Heat the brake assembly. 
B. Cool the brake assembly. 
C. Set the wheel bearings. 
D. Stretch the brake shoes to match the drum. 
 
A - Answer- Which of the following is true concerning master cylinder pushrod adjustment? 
A. There should be a slight gap between the pushrod and master cylinder piston. 
B. It should be adjusted until the piston is pushed in slightly. 
C. It should keep a slight pressure in th...
Exam (elaborations)
Ase Brakes Exam 2 Q&A
A - Answer- The brakes are dragging on a vehicle. This could be caused by: 
A. Overfilled master cylinder reservoir. 
B. Low vacuum to the booster. 
C. Bypassing master cylinder. 
D. Quick take-up valve stuck open. 
 
B - Answer- The brake pads are worn at an angle on a vehicle with a sliding brake caliper system. Which of the following is the most likely cause? 
A. Worn caliper piston 
B. Worn caliper bushings 
C. Leaking caliper seal 
D. Leaking caliper boot 
 
C - Answer- A diagnostic troubl...
Exam (elaborations)
Ase Brakes Exam Questions And Answers
On a car with disc/drum brakes, the front brakes grab quickly when light pedal pressure is applied. this problem could be caused by a bad: 
A: proportioning valve 
B: Pressure safety switch 
C: metering valve 
D: Residual check valve - Answer- C: metering valve 
 
The driver of a vehicle with power disc/drum brakes says the brake pedal moves slowly to the floor while maintaining pedal pressure at a stoplight. What could cause this problem? 
A: leaking primary piston cup in master cylinder 
B: l...
Exam (elaborations)
Ase Brakes Exam Questions And Answers
Disc brakes use replaceable friction material called __________. - Answer- Pads 
 
Drum brakes use replaceable friction material called ________. - Answer- Shoes 
 
Technician A says that a power-assisted brake reduces stopping distances compared with a non-power-assisted brake system. Technician B says that the power-assisted brake system reduces the force that the driver must exert on the brake pedal. Which technician is correct? - Answer- Technician B only 
 
A locked wheel __________________...
Exam (elaborations)
Ase Brakes Exam Questions And Answers
1) The brake pedal feels soft after the master cylinder has been replaced. 
Technician A says that a leaking power booster could be the cause. 
Technician B says that air in the hydraulic system could be the cause. 
Who is right? - Answer- B only 
 
Explanation: A leaking power brake booster will cause the brake pedal to be hard. Technician A's statement is false. Air in the hydraulic system may cause the pedal to be soft. Technician B's statement is true. The correct answer is B. 
 
2) A vehi...
Exam (elaborations)
ASE Brakes Test
On a vehicle with single piston floating caliper front disc brakes, the brake pads on the left side of the vehicle are almost completely worn while the right side is almost new. Technician A says that too much rotor runout could be the cause. Technician B says that a binding caliper piston could be the cause. Who is right? - Answer- Technician B only 
 
A customer complains that their vehicle pulls to the right when the brakes are applied. Technician A says a restricted brake line to the left ca...
Exam (elaborations)
ASE BRAKES Exam 1 Questions and Answers Rated A
A drum is chattering on the brake lathe. This could be the result of: 
A. Failure to install the dampening belt. 
B. Cutting too slowly. 
C. Dull cutting blades. 
D. Cutting speed too fast. A 
A vehicle is equipped with a hydro-boost brake system has a hard pedal with little braking 
action. Which of the following could be the cause? 
A. Low brake fluid 
B. Air in the brake fluid 
C. Low power steering fluid 
D. An overtightened power steering belt C 
Which of the following could cause excessive...
Exam (elaborations)
Ase Brakes A5 Test (Exam 1), Ase A5 Brakes, Ase Brakes A5 (Exam 3), Ase Brakes A5 Test (Exam 2) All In One Perfect Studypack Updated 2023 With Detailed Rationales
Ase Brakes A5 Test (Exam 1), Ase A5 Brakes, 
Ase Brakes A5 (Exam 3), Ase Brakes A5 Test 
(Exam 2) All In One Perfect Studypack 
Updated 2023 With Detailed Rationales