Journeyman Oil burner Test 2026-2027
Frequently Tested Exam Questions With
Verified Multiple Choice and Conceptual
Actual 100% Correct Detailed Answers
Guaranteed Pass!!Current Update!!
1. A fuel oil storage tank cannot be installed: - ANSWER In the furnace
room 5 feet within heating unit
2. What temperature does a thermal wheel automatically activate at -
ANSWER 165°F
3. Who inspects an oil burner installation - ANSWER State fire marshal
4. Any valve used on a oil burner install must be: - ANSWER Fusible valve
5. What form is used to pull an oil burner permit - ANSWER CMR.4
6. What size pipe is used to CrossConnect tank outlet piping - ANSWER 1/2
inch
7. When is an oil safety valve used - ANSWER On an existing installation
when a burner boiler furnace or tank is replaced.
, 8. When must you install a draft regulator - ANSWER When not exempt by
manufacturer
9. What type of boiler must be equipped with a low water cut off - ANSWER
Water boilers over 500,000 BTUs & all steam boilers
10.All new oil burner controls must be: - ANSWER Interrupted ignition
11.How far must continuous concrete slab extend beyond the tank perimeter -
ANSWER 8 inches
12.All protective control and emergency devices shall be series connected from
the electrical distribution panel: - ANSWER Through the emergency
switch, through the terminal switch, to the service switch in the
ungrounded line conductor
13.If the ceiling above the burner boiler or burner furnace exceeds 12 feet in
height, and additional thermal switch shall be installed at a height
of_______ and connected in series with the lower switch. - ANSWER 10
feet
14.An oil safety valve can perform the following functions: - ANSWER
Reduce pressure from its inlet to its outlet & prevent gravity flow
Frequently Tested Exam Questions With
Verified Multiple Choice and Conceptual
Actual 100% Correct Detailed Answers
Guaranteed Pass!!Current Update!!
1. A fuel oil storage tank cannot be installed: - ANSWER In the furnace
room 5 feet within heating unit
2. What temperature does a thermal wheel automatically activate at -
ANSWER 165°F
3. Who inspects an oil burner installation - ANSWER State fire marshal
4. Any valve used on a oil burner install must be: - ANSWER Fusible valve
5. What form is used to pull an oil burner permit - ANSWER CMR.4
6. What size pipe is used to CrossConnect tank outlet piping - ANSWER 1/2
inch
7. When is an oil safety valve used - ANSWER On an existing installation
when a burner boiler furnace or tank is replaced.
, 8. When must you install a draft regulator - ANSWER When not exempt by
manufacturer
9. What type of boiler must be equipped with a low water cut off - ANSWER
Water boilers over 500,000 BTUs & all steam boilers
10.All new oil burner controls must be: - ANSWER Interrupted ignition
11.How far must continuous concrete slab extend beyond the tank perimeter -
ANSWER 8 inches
12.All protective control and emergency devices shall be series connected from
the electrical distribution panel: - ANSWER Through the emergency
switch, through the terminal switch, to the service switch in the
ungrounded line conductor
13.If the ceiling above the burner boiler or burner furnace exceeds 12 feet in
height, and additional thermal switch shall be installed at a height
of_______ and connected in series with the lower switch. - ANSWER 10
feet
14.An oil safety valve can perform the following functions: - ANSWER
Reduce pressure from its inlet to its outlet & prevent gravity flow
