100% Verified Answers |Actual Complete Exam|
Already Graded A+
The basket slings on a gin pole perform what function? ✔Correct Answer-Support part of the
weight and vertical forces
What is the minimum force that a work positioning system anchorage must be able to withstand?
✔Correct Answer-2 times the arresting force or 3,000 lbs
What term identifies a monopole component? ✔Correct Answer-Base flange
All antennas are presumed active ✔Correct Answer-True
When using bolts or u-bolts with a slotted hole present, what order are the components installed?
✔Correct Answer-Flat washer, lock washer, then nut
If you have a 16 ft ladder leaning against a building wall, how many feet from the wall does the base
need to be to provide the correct slope? ✔Correct Answer-4 ft
For structural loading purposes the basket and bridle slings shall always be attached where?
✔Correct Answer-At a panel point around the leg
A hoist operator will respond to a stop signal from whom? ✔Correct Answer-Any source
When calculating a fall distance using a 6 foot energy absorber, what is the maximum pull out
distance? ✔Correct Answer-4 feet
How often shall all gin poles have a documented job inspection? ✔Correct Answer-Daily
What do the letters LOTO stand for? ✔Correct Answer-Lockout Tagout
What does a tag person do? ✔Correct Answer-Applied pressure on the tag rope to controls the
load
A capstan hoist is used on job sites for what purpose? ✔Correct Answer-To raise and lower loads
When operating a Capstan Hoist, or tagging the load on the Capstan, it is important to wear what?
✔Correct Answer-Gloves
What does a Ground Fault Circuit Interrupter (GFCI) do? ✔Correct Answer-Shuts off flow of
electricity, senses a short circuit, and prevents electricution
Which of the following is not a component of the gross load? ✔Correct Answer-Tag force
What motion indicates retract the boom ✔Correct Answer-Both fists in front of your body with
your thumbs pointed towards each other
, What is the heel block used for? ✔Correct Answer-To change the direction of the load, jump or tag
line from horizontal to vertical
An overhaul ball provides what function in the operations? ✔Correct Answer-Provides weight
allowing the load line to treturn the ground
If the operator and signal person cannot see each other, what other way can they communicate?
✔Correct Answer-Radios
The three main components that make up a fall arrest system are ✔Correct Answer-Anchorage,
Full body Harness, and connectors
What type of antenna is used to transmit signal from tower to tower? ✔Correct Answer-
Microwave dish
For all power lines rated 50kv, the minimum clearance between the lines and any part of the crane or
load shall be ✔Correct Answer-20 feet
All cranes must have a posted load chat visible from the operators station? ✔Correct Answer-True
How often must a fire extinguisher be inspected by a qualified person? ✔Correct Answer-Annually
What is a crown block? ✔Correct Answer-An upper sheave assembly on top of a structure
When using a fall restraint system, what is the minimum anchorage allowed? ✔Correct Answer-
1000 lbs
When using a y-lanyard attached to your back d-ring, at what height should the connection to your
anchorage take place? ✔Correct Answer-Shoulder level or above
A company's health, safety and environment policy should be a combination of labor regulation
and ? ✔Correct Answer-Industry standards
How many pounds force is one kilo Newton? ✔Correct Answer-225 lbs
Who is the third part group that approves and endorses standards? ✔Correct Answer-American
national standards institute (ANSI)
When tagging a load, who will tell you when to stop tagging? ✔Correct Answer-The capstan
operator and tower crew
The outer sheath of a synthetic endless sling is part of the slings strength ✔Correct Answer-False
What is the factor of Safety specified for rigging equipment ✔Correct Answer-5:1
If a synthetic rope has a breaking strength of 7600 lbs, what is the maximum gross load that can be
lifted? ✔Correct Answer-760lbs
An RF monitor should be worn in areas of unknown RF exposure ✔Correct Answer-True