CWEA Collections Grade 2 Practice Tes
Questions with Detailed Verified Answers t
Why are gasoline and volatile solvents objectionable when present in a sewer? Ans:
They produce an explosion hazard
You should never attempt to install, troubleshoot, maintain, repair, or replace
electrical equipment unless: Ans: You know what you are doing, are qualified, and are
authorized.
How many different areas of traffic zones are there when working in roadways? Ans:
Five
Why should hydrogen sulfide be controlled? Ans: To protect sewers and structures
from corrosion
Personnel entering a Permit Required Confined Space must have the following training:
Ans: Entry and rescue procedures
To find proper protective gear before application of a product, you would: Ans: Look
at the MSDS (Material Safety Data Sheet)
The gas most commonly associated with septic wastewater is: Ans: Hydrogen Sulfide
(H2S)
The lack of an unpleasant odor in a structure does not always mean that dangerous
gases are not present because: Ans: Some dangerous gases have no odor
What four conditions are necessary to create an explosion? Ans: Combustible gas,
adequate oxygen, sufficient heat, and proper mixing of gas and oxygen.
What does "transition area" mean in traffic control? Ans: Moves traffic out of its
normal path
The term "transition area" is one component of a: Ans: Traffic Control Zone
, What elements should be considered to improve worker safety in High Speed
Temporary Traffic Control Zones? Ans: Rerouting traffic around the work site,
positioning of law enforcement officers in the temporary traffic control zone, and work
zone training.
What key factors would you need to address when developing an S.O.P. for Lift
Station failure? Ans: Traffic control plan, by-pass connections, and spill containment.
"Spring Blades" are a type of tool used with: Ans: Power Rodder
Porcupine, Root Saw, and a Square Bar Cork Screw are all tools used for: Ans: Sewer
rodding
What tool would you use to cut VCP pipe? Ans: Chain pipe cutter
Which conditions should a gas detection device test for? Ans: Hydrogen Sulfide,
explosive/flammable gases, oxygen.
What does "LEL" mean on a gas detection meter? Ans: Lower explosive limit
The oxygen level alarm in a gas detection meter is normally set to go off at oxygen
levels below: Ans: 19.5%
When developing an S.O.P. for scheduled maintenance of electrical equipment, what
program should be addressed as a primary safety guideline? Ans: The L.O.T.O. (Lock
Out Tag Out) Program
What document would you require to be referenced when developing an S.O.P. for
hazardous substance spill cleanup as well as spill containment? Ans: M.S.D.S.
Placement of the Blower and P.P.E. are two things you would include in developing an
S.O.P. for air monitoring in a: Ans: Permit Required Confined Space
According to a State Water Resources Control Board order, each Enrollee must
develop and implement a system-specific: Ans: Sewer System Management Plan
(SSMP)
© Get it right 2025 Getaway - Stuvia US All rights reserved
Questions with Detailed Verified Answers t
Why are gasoline and volatile solvents objectionable when present in a sewer? Ans:
They produce an explosion hazard
You should never attempt to install, troubleshoot, maintain, repair, or replace
electrical equipment unless: Ans: You know what you are doing, are qualified, and are
authorized.
How many different areas of traffic zones are there when working in roadways? Ans:
Five
Why should hydrogen sulfide be controlled? Ans: To protect sewers and structures
from corrosion
Personnel entering a Permit Required Confined Space must have the following training:
Ans: Entry and rescue procedures
To find proper protective gear before application of a product, you would: Ans: Look
at the MSDS (Material Safety Data Sheet)
The gas most commonly associated with septic wastewater is: Ans: Hydrogen Sulfide
(H2S)
The lack of an unpleasant odor in a structure does not always mean that dangerous
gases are not present because: Ans: Some dangerous gases have no odor
What four conditions are necessary to create an explosion? Ans: Combustible gas,
adequate oxygen, sufficient heat, and proper mixing of gas and oxygen.
What does "transition area" mean in traffic control? Ans: Moves traffic out of its
normal path
The term "transition area" is one component of a: Ans: Traffic Control Zone
, What elements should be considered to improve worker safety in High Speed
Temporary Traffic Control Zones? Ans: Rerouting traffic around the work site,
positioning of law enforcement officers in the temporary traffic control zone, and work
zone training.
What key factors would you need to address when developing an S.O.P. for Lift
Station failure? Ans: Traffic control plan, by-pass connections, and spill containment.
"Spring Blades" are a type of tool used with: Ans: Power Rodder
Porcupine, Root Saw, and a Square Bar Cork Screw are all tools used for: Ans: Sewer
rodding
What tool would you use to cut VCP pipe? Ans: Chain pipe cutter
Which conditions should a gas detection device test for? Ans: Hydrogen Sulfide,
explosive/flammable gases, oxygen.
What does "LEL" mean on a gas detection meter? Ans: Lower explosive limit
The oxygen level alarm in a gas detection meter is normally set to go off at oxygen
levels below: Ans: 19.5%
When developing an S.O.P. for scheduled maintenance of electrical equipment, what
program should be addressed as a primary safety guideline? Ans: The L.O.T.O. (Lock
Out Tag Out) Program
What document would you require to be referenced when developing an S.O.P. for
hazardous substance spill cleanup as well as spill containment? Ans: M.S.D.S.
Placement of the Blower and P.P.E. are two things you would include in developing an
S.O.P. for air monitoring in a: Ans: Permit Required Confined Space
According to a State Water Resources Control Board order, each Enrollee must
develop and implement a system-specific: Ans: Sewer System Management Plan
(SSMP)
© Get it right 2025 Getaway - Stuvia US All rights reserved
