Basic Wastewater Operator Practice Exam
Study online at https://quizlet.com/_hrxmf2
1. What is the predominant organism in a healthy activated sludge treatment
plant?
A. Stalked ciliates
B. rotifers
C. nematodes
D. amoebas: A. Stalked Ciliates
2. A composite sample must be?
A. sporadically collected in the treatment plant
B. taken at one time
C. analyzed immediately
D. representative and sub-samples time spaced over 15 minutes apart: D. repre-
sentative and sub-samples time spaced over 15 minutes apart
3. What is the standard volume for a BOD sample bottle?
A. 150 mL
B. 200 mL
C. 300 mL
D. 500 mL: c. 300 mL
4. If you have a lime slurry feed line, what is the best valve to use?
A. plug valve
B. butterfly valve
C. RPZ dual check valve
D. gate valve: A. plug valve
5. 5. If you notice a predominance of rotifers in your activated sludge sample
while looking at it under a microscope, what does this indicate?
A. healthy sludge
B. young sludge
C. old sludge
D. middle age sludge: C. old sludge
, Basic Wastewater Operator Practice Exam
Study online at https://quizlet.com/_hrxmf2
6. Calculate the BOD using the given information:
Initial DO: 8.3
Final DO: 5.9
Milliliters of sample used: 2
a. 360 mg/L
b. 210 mg/L
c. 856 mg/L
d. 36 mg/L: a. 360 mg/L
7. If your activated sludge plant begins to nitrify, what conditions would you
expect to decrease?
A. settling in clarifiers
B. chlorine demand
C. BOD effluent
D. TSS in effluent: a. settling in the clarifiers
8. How do you calibrate a chemical feed pump?
A. by measuring the pump output
B. using the SWAG method
C. jar test
D. with a microscope: A. by measuring the pump output
9. What is the chemical formula for sulfuric acid?
a. HNO3
b. HCl
c. NaOH
d. H2SO4: d. H2SO4
10. What is the most common type of activated sludge package plants?
a. extended aeration
b. sequential batch reactor
, Basic Wastewater Operator Practice Exam
Study online at https://quizlet.com/_hrxmf2
c. oxidation ditch
d. bardenpho: a. extended aeration
11. What is the most appropriate method of reducing the F:M ratio?
A. increase wasting
b. decrease wasting
c. reduce BOD from influent flow
D. add polymer to RAS to increase settling: b. decrease wasting
12. An operator notices a portion of the aeration tank with large bubbles rising
up. What is the most likely problem?
a. equal air distribution
b. unequal air distribution caused by a blown/clogged diffuser
c. normal operation
d. reason to believe the air filter in the blower is clogged: b. unequal air distribution caused
by a blown diffuser
13. What is suction lift?
a. a team approach to lifting heavy objects
b. the pressure on the suction side of the pump
c. the measurement of liquid pressure at the pump
d. the measure of how bad your workers lift heavy objects: b. the pressure on the suction
side of the pump
14. The primary effluent to a RBC system is 350 mg/L BOD. The primary unit
removes 83% the secondary unit removes 50% and the final unit removes 25%.
What is the BOD leaving the final unit of the RBC train?
A. 290 mg/L
b. 60 mg/L
c. 30 mg/L
d. 22.5 mg/L: d. 22.5 mg/L
Study online at https://quizlet.com/_hrxmf2
1. What is the predominant organism in a healthy activated sludge treatment
plant?
A. Stalked ciliates
B. rotifers
C. nematodes
D. amoebas: A. Stalked Ciliates
2. A composite sample must be?
A. sporadically collected in the treatment plant
B. taken at one time
C. analyzed immediately
D. representative and sub-samples time spaced over 15 minutes apart: D. repre-
sentative and sub-samples time spaced over 15 minutes apart
3. What is the standard volume for a BOD sample bottle?
A. 150 mL
B. 200 mL
C. 300 mL
D. 500 mL: c. 300 mL
4. If you have a lime slurry feed line, what is the best valve to use?
A. plug valve
B. butterfly valve
C. RPZ dual check valve
D. gate valve: A. plug valve
5. 5. If you notice a predominance of rotifers in your activated sludge sample
while looking at it under a microscope, what does this indicate?
A. healthy sludge
B. young sludge
C. old sludge
D. middle age sludge: C. old sludge
, Basic Wastewater Operator Practice Exam
Study online at https://quizlet.com/_hrxmf2
6. Calculate the BOD using the given information:
Initial DO: 8.3
Final DO: 5.9
Milliliters of sample used: 2
a. 360 mg/L
b. 210 mg/L
c. 856 mg/L
d. 36 mg/L: a. 360 mg/L
7. If your activated sludge plant begins to nitrify, what conditions would you
expect to decrease?
A. settling in clarifiers
B. chlorine demand
C. BOD effluent
D. TSS in effluent: a. settling in the clarifiers
8. How do you calibrate a chemical feed pump?
A. by measuring the pump output
B. using the SWAG method
C. jar test
D. with a microscope: A. by measuring the pump output
9. What is the chemical formula for sulfuric acid?
a. HNO3
b. HCl
c. NaOH
d. H2SO4: d. H2SO4
10. What is the most common type of activated sludge package plants?
a. extended aeration
b. sequential batch reactor
, Basic Wastewater Operator Practice Exam
Study online at https://quizlet.com/_hrxmf2
c. oxidation ditch
d. bardenpho: a. extended aeration
11. What is the most appropriate method of reducing the F:M ratio?
A. increase wasting
b. decrease wasting
c. reduce BOD from influent flow
D. add polymer to RAS to increase settling: b. decrease wasting
12. An operator notices a portion of the aeration tank with large bubbles rising
up. What is the most likely problem?
a. equal air distribution
b. unequal air distribution caused by a blown/clogged diffuser
c. normal operation
d. reason to believe the air filter in the blower is clogged: b. unequal air distribution caused
by a blown diffuser
13. What is suction lift?
a. a team approach to lifting heavy objects
b. the pressure on the suction side of the pump
c. the measurement of liquid pressure at the pump
d. the measure of how bad your workers lift heavy objects: b. the pressure on the suction
side of the pump
14. The primary effluent to a RBC system is 350 mg/L BOD. The primary unit
removes 83% the secondary unit removes 50% and the final unit removes 25%.
What is the BOD leaving the final unit of the RBC train?
A. 290 mg/L
b. 60 mg/L
c. 30 mg/L
d. 22.5 mg/L: d. 22.5 mg/L
