MQM 227 Ch. 13 Questions and Answers 100% Correct
A rule of thumb when setting up a p-chart is to make the sample large
enough to expect to count the attribute ____ in each sample. -
✔✔twice
Acceptance sampling is executed through a _____ _____ -
✔✔sampling
plan
Acceptance sampling is performed on goods that already _____to
determine what percentage of products conform to specifications.
Listen to the complete question - ✔✔exist
According to Genichi Taguchi, from the customer's view, there is often
practically no difference between a product just _____specifications
and a product just ______ . - ✔✔inside
outside
According to Genichi Taguchi,as customers get more demanding,
there is pressure to reduce _____ - ✔✔variability
alpha - ✔✔the probability associated with accepting a high-quality lot
beta - ✔✔the probability associated with accepting a low-quality lot
, Defined as the difference between the highest and lowest numbers in
a sample? - ✔✔Range
Designers establish specifications that define not only the target value
of something but also acceptable ____ about the target. - ✔✔limits
For a p-chart, if the defective rate were approximately 2 percent, a
common rule of thumb suggests the sample size should be ____ -
✔✔100
For industrial applications in process control involving the
measurement of variables, it is preferable to keep the sample size
small. Why is this? Check all that apply.
Cost
It keeps the standard deviation small
Time
The math is easier - ✔✔Cost
Time
How often to take a sample is a trade-off between the _____ of
sampling and the ____ of adjusting the system. - ✔✔cost
benefit
A rule of thumb when setting up a p-chart is to make the sample large
enough to expect to count the attribute ____ in each sample. -
✔✔twice
Acceptance sampling is executed through a _____ _____ -
✔✔sampling
plan
Acceptance sampling is performed on goods that already _____to
determine what percentage of products conform to specifications.
Listen to the complete question - ✔✔exist
According to Genichi Taguchi, from the customer's view, there is often
practically no difference between a product just _____specifications
and a product just ______ . - ✔✔inside
outside
According to Genichi Taguchi,as customers get more demanding,
there is pressure to reduce _____ - ✔✔variability
alpha - ✔✔the probability associated with accepting a high-quality lot
beta - ✔✔the probability associated with accepting a low-quality lot
, Defined as the difference between the highest and lowest numbers in
a sample? - ✔✔Range
Designers establish specifications that define not only the target value
of something but also acceptable ____ about the target. - ✔✔limits
For a p-chart, if the defective rate were approximately 2 percent, a
common rule of thumb suggests the sample size should be ____ -
✔✔100
For industrial applications in process control involving the
measurement of variables, it is preferable to keep the sample size
small. Why is this? Check all that apply.
Cost
It keeps the standard deviation small
Time
The math is easier - ✔✔Cost
Time
How often to take a sample is a trade-off between the _____ of
sampling and the ____ of adjusting the system. - ✔✔cost
benefit
