WELDING RED SEAL QUESTIONS AND ANSWERS
18 gauge - Answer -what is the maximum material thickness that can be successfully
cut with tin snips?
118 degrees - Answer -what is the included angle on a drill bit designed for use on mild
steel?
shade 14 - Answer -what shade filter lens would you use at 500 amps?
welding helmet down with flip front up - Answer -what would be the best way to protect
yourself while chipping slag?
8-12 degrees - Answer -what is the lip clearance on a drill bit used for mild steel?
top two - Answer -you should not step on the top ________ rungs of a ladder
over 3 meters (10ft) - Answer -at what height must you use fall protection on a ladder?
4:1 - Answer -what is the height to base ratio when setting up a ladder?
by length, shape and cut - Answer -how are files identified?
excessive pressure on the cutting wheels - Answer -what would cause a burr to form
when cutting copper tubing with a cold cutter?
everyday - Answer -how often should you oil a pneumatic grinder?
No - Answer -should band saw blade speed be increased for harder material?
soft materials (aluminum) - Answer -what type of materials require wider tooth spacing
and higher speeds?
material thickness - Answer -what determines the pitch of a band saw blade?
30 degrees - Answer -when using a bridal hitch, at what sling angle does the load on
each sling become equal to the weight of the load?
if the included angle of your sling assembly exceeds 120 degrees - Answer -when
should you use a spreader bar with slings?
10 to 1 - Answer -when selecting rigging for hoisting personnel, what safety factor must
be used?
18 gauge - Answer -what is the maximum material thickness that can be successfully
cut with tin snips?
118 degrees - Answer -what is the included angle on a drill bit designed for use on mild
steel?
shade 14 - Answer -what shade filter lens would you use at 500 amps?
welding helmet down with flip front up - Answer -what would be the best way to protect
yourself while chipping slag?
8-12 degrees - Answer -what is the lip clearance on a drill bit used for mild steel?
top two - Answer -you should not step on the top ________ rungs of a ladder
over 3 meters (10ft) - Answer -at what height must you use fall protection on a ladder?
4:1 - Answer -what is the height to base ratio when setting up a ladder?
by length, shape and cut - Answer -how are files identified?
excessive pressure on the cutting wheels - Answer -what would cause a burr to form
when cutting copper tubing with a cold cutter?
everyday - Answer -how often should you oil a pneumatic grinder?
No - Answer -should band saw blade speed be increased for harder material?
soft materials (aluminum) - Answer -what type of materials require wider tooth spacing
and higher speeds?
material thickness - Answer -what determines the pitch of a band saw blade?
30 degrees - Answer -when using a bridal hitch, at what sling angle does the load on
each sling become equal to the weight of the load?
if the included angle of your sling assembly exceeds 120 degrees - Answer -when
should you use a spreader bar with slings?
10 to 1 - Answer -when selecting rigging for hoisting personnel, what safety factor must
be used?
