Afab 110 midterm study guide units 1- 8 Questions With Complete Solutions
Which of the following are in thin short dashes that are spaced closely together - answer-hidden line
• • Print reading involves in elements of visualization and what - answer-Interpretation
In the United States the standardization of engineering values is established through - answer-ASME
Cutting plane lines are easily identifiable due to the appearance of what on both ends - answer-Arrow
heads
Which of the following is not the types of lines used in dimensioning an object - answer-Brake lines
Engineering sheet sizes come in multiples of what - answer-8 1/2 by 11
What does the acronym C.A.G.E stand for - answer-Comercial And Government Entities
The ___ block lists the assembly or sub assembly in which the part or the assembly is to be used -
answer-Application block
Which of the following is typically not included in a basic parts list - answer-The finish
Which of the following is not one of the three regular views common in drafting education - answer-
Rear view
____ is the left to right measurement of an object from the vantage point of the front view - answer-
Width
Which of the following is not one of the three principle projection planes common in drafting education
- answer-Vertical
The ____ surface was perpendicular to one projection plane but inclined to other two projection planes
- answer-Inclined
A flat surface is inclined to all three principle projection planes is known as as what type of surface -
answer-Oblique Surface
___ is a system where parallel lines are used to project the points of the 3d object onto 2d projection
plane - answer-Orthographic projection
Molded and cast objected have rounded edges called ____ and rounds - answer-Fillets
Which of the following is not one of the three means aligned in a multi view drawing can have - answer-
Curved surface tangent to a flat surface
Which of the following are in thin short dashes that are spaced closely together - answer-hidden line
• • Print reading involves in elements of visualization and what - answer-Interpretation
In the United States the standardization of engineering values is established through - answer-ASME
Cutting plane lines are easily identifiable due to the appearance of what on both ends - answer-Arrow
heads
Which of the following is not the types of lines used in dimensioning an object - answer-Brake lines
Engineering sheet sizes come in multiples of what - answer-8 1/2 by 11
What does the acronym C.A.G.E stand for - answer-Comercial And Government Entities
The ___ block lists the assembly or sub assembly in which the part or the assembly is to be used -
answer-Application block
Which of the following is typically not included in a basic parts list - answer-The finish
Which of the following is not one of the three regular views common in drafting education - answer-
Rear view
____ is the left to right measurement of an object from the vantage point of the front view - answer-
Width
Which of the following is not one of the three principle projection planes common in drafting education
- answer-Vertical
The ____ surface was perpendicular to one projection plane but inclined to other two projection planes
- answer-Inclined
A flat surface is inclined to all three principle projection planes is known as as what type of surface -
answer-Oblique Surface
___ is a system where parallel lines are used to project the points of the 3d object onto 2d projection
plane - answer-Orthographic projection
Molded and cast objected have rounded edges called ____ and rounds - answer-Fillets
Which of the following is not one of the three means aligned in a multi view drawing can have - answer-
Curved surface tangent to a flat surface
