Practice Questions and Answers Verified 100%
Correct
Entanglements are the majority of what on playgrounds? - ANSWERdeaths
Protrusions may not what? - ANSWERincrease in size from their initial surface
The angle of any vertex formed by adjacent components should not be less than? -
ANSWER55 degrees unless the lower leg of the angle is horizontal or pointed down
A designated playing surface is an elevated surface for? - ANSWERstanding, walking,
sitting or climbing
A designated play surface is any flat surface that is what dimension? - ANSWER2x2
feet
Critical Dimensions and clearances for Rotating Swings are measured by? -
ANSWERY+30
Y is the distance from the pivot to the top of the seat
On a track ride, how far above the surface does the hand grip have to be? -
ANSWER64-78 inches
Each new piece of equipment must have two labels. What are they? -
ANSWERManufacturers label and warning labels
Which dowel probe should be used for a common pinch and crush? - ANSWER0.62
inches or 5/8 of an inch
The use zone is... - ANSWERthe surface under and around a piece of play equipment
onto which a child may fall.
IAS HIC bench mark is... - ANSWERLess than 1000-HIC
The G-Max benchmark is... - ANSWERless than 200 G's
Critical height is property of? - ANSWERI.A.S.
The use zone for stationary equipment is? - ANSWER6 ft in all directions from the
equipment perimeter
The front to rear use zone where swing motion occurs can not what? -
ANSWEROverlap
, A slide can have a maximum depth of what in its use zone? - ANSWER96 inches
Fall height is the... - ANSWERvertical distance from a designated play surface and the
protective surfacing beneath it
The accessible route must not exceed a slope of... - ANSWER1:20
A change in what can be a barrier for a wheelchair? - ANSWER1/2 inch
Landings must have a minimum width of _______ in. - ANSWER60 in
Which documents provide physical standards for accessibility? - ANSWER1487 ASTM
The accessible route must be... - ANSWERFirm, stable and slip resistant
What is the purpose of an audit? - ANSWERto identify any conditions not in compliance
with the standards
Inspection should be based upon... - ANSWERfrequency of use
how do you determine the frequency? - ANSWERby the ages
What is the primary function of playground inspection and maintenance? - ANSWERto
keep the playground safe for all users
Are bike helmets allowed on playgrounds? Why? - ANSWERNo, because it can cause
strangulation
CPSC says that you should gibe priority to lead pain that equals or exceeds what
amount on a play structure? - ANSWER0.5%
Critical height is... - ANSWERthe approximation of the max fall heights from which a life
threatening head injury would not be expected to occur
What are the two acceptable surface materials? - ANSWERUnitary and Loose Fill
Identify unitary materials. - ANSWERThey are generally rubber mats or a combination
of rubber like materials.
Identify Loose Fill materials. - ANSWERThey consist of sand, gravel, and shredded
wood products.
What was the first piece of equipment removed in 1937? - ANSWERThe Giant Stride
Should you pass no compliant equipment to other facilities? - ANSWERNO