RVTI Level 1 Final Exam Questions with Correct Answers | 100% Guaranteed Pass| Updated| Newest Version

RVTI Level 1 Final Exam Questions with Correct Answers | 100% Guaranteed Pass| Updated| Newest Version 1. To measure current with a VOM connect the VOM in _______ with the source - ANSWER Series 2. To measure for voltage connect the meter in ______ with the load - ANSWER Parallel 3. Connecting batteries in ______ the positive of the 1st battery connects to the negative of the second, and the positive of the second connects to the negative of the 3rd and so forth. The negative of the 1st battery and the positive of the last battery both connect to the inverter. - ANSWER Series 4. To connect batteries in ______ the positive of the 1st battery connects to the positive of the second battery while negative connects to negative. Negative of the 1st battery and positive of the last battery connection to inverter - ANSWER Parallel 5. Connecting the meter in parallel with a load tests for? - ANSWER Voltage 6. Connecting a VOM in series with a source tests for? - ANSWER Current 7. What is the function of refrigerant - ANSWER Extracts heat and moisture 8. The refrigerators are compression driven - ANSWER Residential RV refrigerator 9. Most commonly used fridge in Rvs - ANSWER Absorption refrigerator 10.During propane pressure test at fridge use what tool? - ANSWER Manometer 11.This heats water as it passes through a heated coil - ANSWER Instantaneous water heater 12.Propane flow will be prevented as a result of ________ not preforming well - ANSWER Thermocouple 13.This is a cooktop with an oven - ANSWER Range 14.What is located in burner box of a range - ANSWER Data plate 15.When testing ovens set temperature to what? - ANSWER 300 degrees F 16.2 main types of microwaves - ANSWER Standard Convection 17.On a pdi of microwave document 3 things - ANSWER Make Model Serial number 18.To test microwave: - ANSWER Place cup of water for one minute 19.What is the most common function of all hydronic heating systems? - ANSWER Interior heating 20.Boiler tank in hydronic heating system is heated in 3 ways - ANSWER 1. When unit plugged in 21.2. Vehicle running 22.3. Through burner using diesel or propane 23.This tool is used when preforming a propylene glycol level test - ANSWER Refractometer 24.When inspecting roof/ducted AC be sure to - ANSWER Test fan speed and operation of vents 25.3 controls on an AC - ANSWER Mode selector Volume control lever Temperature control 26.This ultimately determines if the AC is functioning properly - ANSWER Delta temp 27.During a 12-24 hr test on fridge the thermometer should read? - ANSWER 40-43 degrees F 28.2 types of furnaces - ANSWER Forced air 29.Hydronic 30.When conducting pdi on furnaces the thermostat should be set where? - ANSWER Highest setting 31.To know a furnace is working properly airflow should be warmer than _______ - ANSWER Ambient temperature 32.3 types of Air conditioner - ANSWER Roof top unit 33.Basement unit 34.Window unit 35.When ac is running it should be 20 degree cooler than outside temp. This is known as - ANSWER Delta T 36.Common unit of measurement for appliances is: - ANSWER BTU (British thermal unit) 37.This furnace uses outside wire through sealed combustion chamber assembly to heat - ANSWER Forced air furnace 38.This furnace uses a heat surface to heat water distributed to radiators - ANSWER Hydronic system 39.4 types of water heaters are electric, instantaneous, direct spark ignition and _____ - ANSWER Manual pilot ignition 40.This is the more common water heater - ANSWER Direct spark ignition (fully automatic with switch) 41.Range is a combination of - ANSWER Oven and cook top 42.Propylene glycol test uses a refractometer to test for what? - ANSWER Freeze point of antifreeze solution. This percentage should be between 35- 50% 43.Generators can be powered by? - ANSWER Gas and propane 44.This transforms mechanical energy into electrical energy - ANSWER Generator 45.Generator need a warm up and cool down time of - ANSWER 2-5 min 46.On generator the ________ is non adjustable and epa mandated - ANSWER Carburetor 47.Always check this before starting generator - ANSWER Oil 48.The run test with a load on a generator is preformed with the generator connected to - ANSWER Vehicle circuitry 49.Generators consist of an engine and an ______ to create 120-240 VAC - ANSWER Alternator 50.Why shouldn't generators be stopped or started with a heavy load online? - ANSWER Some appliances when started take more power at the initial start than when just running and can overload the generator 51.2 methods of transferring from shoreline power to generator - ANSWER Manual method(flip breakers or switches) 52.Automatic transfer(equipped with prioritizing mechanism that chooses one source or the other) 53.When working on older generator without circuit breaker where must one be installed? - ANSWER Within 18 in of conductors