1
CCNA/CCNA 200-125 EXAM DUMPS VERSION 4
ACTUAL TO ACTUAL EXAM 2025/26
• Which definition of a default route is true?
A. a route to the exact /32 destination address
B. a route used when a route to the destination network is missing
C. a dynamic route learned from a server
D. a route that is manually configured
• Which value must you configure on a device before EIGRP for IPv6 can start running?
A. process ID
B. loopback interface
C. public IP address
D. router ID
• Which are valid modes for a switch port used as a VLAN trunk? (Choose three.)
A. transparent
B. blocking
C. forwarding
D. desirable
E. on
F. auto
• Why will a switch never learn a broadcast address?
A. Broadcast frames are never sent to switches
B. Broadcast addresses use an incorrect format for the switching table.
C. A broadcast address will never be the source address of a frame.
D. A broadcast frame is never forwarded by a switch
E. Broadcasts only use network layer addressing.
• Which feature is configured by setting a variance that is at least two times the metric?
A. path selection
B. equal cost load balancing
C. path count
D. unequal cost load balancing
• When you troubleshoot an IPv4 connectivity issue on a router, which three router
configuration checks you must perform? (Choose three.)
A. Verify that the router firmware is up-to-date.
,2
B. Verify that a default route is configured
C. Verify that the router interface IP address is correct
D. Verify that the router and the host use the same subnet mask
E. Verify that the route appears in the routing table.
,3
F. Verify that the DNS is configured correctly.
• Which three statements about link-state routing are true? (Choose three.)
A. Updates are sent to a broadcast address
B. OSPF is a link-state protocol.
C. Routes are updated when a change in topology occurs.
D. It uses split horizon.
E. Updates are sent to a multicast address by default.
F. RIP is a link-state protocol.
• What are the possible trunking modes for a switch port? (Choose three.)
A. on
B. desirable
C. client
D. auto
E. forwarding
F. transparent
• Refer to the exhibit. Which of these statements correctly describes the state of the switch
once the boot process has been completed?<br>
A. More VLANs will need to be created for this switch.
B. The switch will need a different IOS code in order to support VLANs and STP.
C. Remote access management of this switch will not be possible without configuration change
D. As FastEthernet0/12 will be the last to come up, it will be blocked by STP.
• Which state does the port-channel interface enter when LACP is misconfigured on the interface?
A. disabled
B. errdisable
C. enabled
D. forwarding
, 4
• When an interface is configured with PortFast BPDU guard, how does the interface respond
when it receives a BPDU?
A. It goes into an errdisable state
B. It continues operating normally.
C. It goes into a down/down state
D. It becomes the root bridge for the configured VLAN
• Which two statements about MPLS are true? (Choose two.)
A. It uses labels to separate and forward customer traffic.
B. It encapsulates all traffic m an IPv4 header
C. It provides automatic authentication.
D. It can carry mutiple protocols, including IPv4 and IPv6
E. It tags customer traffic using 802.1q
• Which statement about recovering a password on a Cisco router is true?
A. It requires a secure SSLVPN connection.
B. A factory reset is required if you forget the password.
C. It requires physical access to the router
D. The default reset password is cisco.
• Refer to the exhibit.<br>
You determine that Computer A cannot ping Computer B.
A. The default gateway address for Computer B is incorrect
B. The subnet mask for Computer B is incorrect
C. The subnet mask for Computer A is incorrect
D. The default gateway address for Computer A is incorrect
• Which port state is introduced by Rapid-PVST?
A. discarding
B. listening
C. learning
CCNA/CCNA 200-125 EXAM DUMPS VERSION 4
ACTUAL TO ACTUAL EXAM 2025/26
• Which definition of a default route is true?
A. a route to the exact /32 destination address
B. a route used when a route to the destination network is missing
C. a dynamic route learned from a server
D. a route that is manually configured
• Which value must you configure on a device before EIGRP for IPv6 can start running?
A. process ID
B. loopback interface
C. public IP address
D. router ID
• Which are valid modes for a switch port used as a VLAN trunk? (Choose three.)
A. transparent
B. blocking
C. forwarding
D. desirable
E. on
F. auto
• Why will a switch never learn a broadcast address?
A. Broadcast frames are never sent to switches
B. Broadcast addresses use an incorrect format for the switching table.
C. A broadcast address will never be the source address of a frame.
D. A broadcast frame is never forwarded by a switch
E. Broadcasts only use network layer addressing.
• Which feature is configured by setting a variance that is at least two times the metric?
A. path selection
B. equal cost load balancing
C. path count
D. unequal cost load balancing
• When you troubleshoot an IPv4 connectivity issue on a router, which three router
configuration checks you must perform? (Choose three.)
A. Verify that the router firmware is up-to-date.
,2
B. Verify that a default route is configured
C. Verify that the router interface IP address is correct
D. Verify that the router and the host use the same subnet mask
E. Verify that the route appears in the routing table.
,3
F. Verify that the DNS is configured correctly.
• Which three statements about link-state routing are true? (Choose three.)
A. Updates are sent to a broadcast address
B. OSPF is a link-state protocol.
C. Routes are updated when a change in topology occurs.
D. It uses split horizon.
E. Updates are sent to a multicast address by default.
F. RIP is a link-state protocol.
• What are the possible trunking modes for a switch port? (Choose three.)
A. on
B. desirable
C. client
D. auto
E. forwarding
F. transparent
• Refer to the exhibit. Which of these statements correctly describes the state of the switch
once the boot process has been completed?<br>
A. More VLANs will need to be created for this switch.
B. The switch will need a different IOS code in order to support VLANs and STP.
C. Remote access management of this switch will not be possible without configuration change
D. As FastEthernet0/12 will be the last to come up, it will be blocked by STP.
• Which state does the port-channel interface enter when LACP is misconfigured on the interface?
A. disabled
B. errdisable
C. enabled
D. forwarding
, 4
• When an interface is configured with PortFast BPDU guard, how does the interface respond
when it receives a BPDU?
A. It goes into an errdisable state
B. It continues operating normally.
C. It goes into a down/down state
D. It becomes the root bridge for the configured VLAN
• Which two statements about MPLS are true? (Choose two.)
A. It uses labels to separate and forward customer traffic.
B. It encapsulates all traffic m an IPv4 header
C. It provides automatic authentication.
D. It can carry mutiple protocols, including IPv4 and IPv6
E. It tags customer traffic using 802.1q
• Which statement about recovering a password on a Cisco router is true?
A. It requires a secure SSLVPN connection.
B. A factory reset is required if you forget the password.
C. It requires physical access to the router
D. The default reset password is cisco.
• Refer to the exhibit.<br>
You determine that Computer A cannot ping Computer B.
A. The default gateway address for Computer B is incorrect
B. The subnet mask for Computer B is incorrect
C. The subnet mask for Computer A is incorrect
D. The default gateway address for Computer A is incorrect
• Which port state is introduced by Rapid-PVST?
A. discarding
B. listening
C. learning
