SOS BRAKE & BRAKING SYSTEM ACTUAL 2025/2026 QUESTIONS AND 100% CORRECT ANSWERS

SOS BRAKE & BRAKING SYSTEM ACTUAL 2025/2026 QUESTIONS AND 100% CORRECT ANSWERS In a single anchor bendix drum type rear brake - Answer -the secondary lining is longer than the primary Compared to the secondary shoe lining areas of drum brakes, the primary shoe lining area is: - Answer -smaller and goes toward the front of the car During a brake overhaul, you notice that the brake fluid seems to be very dirty and dark in color. What should you do? - Answer -flush the system before the new parts are installed In order to bleed the system on a vehicle equipped with power brakes: - Answer -None of the above Which of the following could be a symptom of over-torqued lug nuts? - Answer -A brake pedal pulsation during braking. Which of the following describes the proper sequence to bleed brake lines on most rear wheel drive vehicles: - Answer -RR, LR, RF, LF In disc brake caliper assemblies, the "square cut seal" is usually located: - Answer -In the caliper piston boreWhen performing a caliper overhaul, what would you use to remove the pistons from the calipers? - Answer -Compressed air Sliding caliper disc brake pads are kept in adjustment by the - Answer - Square cut piston seal A cracked or torn vacuum diaphragm in a power booster would likely cause: - Answer -Hard pedal with very high effort required When the brakes are applied on a car with disc-drum brakes, a vibration or pulsating movement is felt. What can cause this problem? - Answer - A rotor thickness variation While test driving a car, the mechanic finds that the right front brake "grabs". The most likely cause of this problem is: - Answer -Brake fluid or grease on the brake linings. During a road test, you find that when normal breaking pressure is applied the pedal slowly goes to the floor. What is the likely cause of this problem? - Answer -A leaking master cylinder primary piston seal. A rattle is a single piston disc brake assembly which goes away when the brakes are applied is most likely a result of: - Answer -Loose pads in the caliper Which of the following would m