1|Page
NCCCO TSS MANITEX EXAM 2025 ACTUAL EXAM
COMPLETE ACCURATE EXAM QUESTIONS WITH
DETAILED VERIFIED ANSWERS WITH RATIONALES
(100% CORRECT ANSWERS) /ALREADY GRADED A+/
LATEST EXAM!!!
Which area do truck cranes without a 5th outrigger
generally have no lifting capacity unless the manufacturer
states otherwise? - Answer-The front
What is the definition of "operating radius?" - Answer-The
distance from the center of rotation of the crane to the
center of gravity of the load
What applies to the capacities below the bold line shown
on a load chart? - Answer-They are based on the stability
of the crane
In which quadrant are rough terrain crane capacities
generally greater? - Answer-Over the front
What percentage do most manufacturers requires a
crane's load chart capacity to be reduced by for duty cycle
,2|Page
operations - such as high-volume concrete placement? -
Answer-20%
From which two points should the boom be measured? -
Answer-From the boom hinge pins, to the center of the
boom tip sheave
What is the preferred method of installing wire rope from a
reel onto a hoist drum? - Answer-Running the rope from
the top of the reel, to the top of the drum.
Over which quadrant are truck crane capacities usually
greater? - Answer-Over the rear
According to OSHA, which accessible area of an operating
crane must always be barricaded? - Answer-The swing
radius of the rear of the rotating superstructure
What is the OSHA regulation governing cranes in
construction? - Answer-1926.1400
, 3|Page
According to ASME, what percentage of the
manufacturer's crane rating must not be exceeded if a
load test is done on a repaired crane? - Answer-100%
Where is the tipping axis of a crawler crane located? -
Answer-It depends if the idler or sprocket are in line or
offset from the track rollers
What should be done with materials placed under
overhead energized power lines? - Answer-NOT be lifted
by crane
What determines the amount of deduction required for an
erected jib that is not being used? - Answer-The effective
weight of the jib
What happens to ground bearing pressure if you move a
crawler crane from soft ground to harder ground? -
Answer-It increases
How should the wheels of a crane be positioned when it is
set up for working on outriggers? - Answer-Just high
enough off the ground to relieve the tires of crane weight
NCCCO TSS MANITEX EXAM 2025 ACTUAL EXAM
COMPLETE ACCURATE EXAM QUESTIONS WITH
DETAILED VERIFIED ANSWERS WITH RATIONALES
(100% CORRECT ANSWERS) /ALREADY GRADED A+/
LATEST EXAM!!!
Which area do truck cranes without a 5th outrigger
generally have no lifting capacity unless the manufacturer
states otherwise? - Answer-The front
What is the definition of "operating radius?" - Answer-The
distance from the center of rotation of the crane to the
center of gravity of the load
What applies to the capacities below the bold line shown
on a load chart? - Answer-They are based on the stability
of the crane
In which quadrant are rough terrain crane capacities
generally greater? - Answer-Over the front
What percentage do most manufacturers requires a
crane's load chart capacity to be reduced by for duty cycle
,2|Page
operations - such as high-volume concrete placement? -
Answer-20%
From which two points should the boom be measured? -
Answer-From the boom hinge pins, to the center of the
boom tip sheave
What is the preferred method of installing wire rope from a
reel onto a hoist drum? - Answer-Running the rope from
the top of the reel, to the top of the drum.
Over which quadrant are truck crane capacities usually
greater? - Answer-Over the rear
According to OSHA, which accessible area of an operating
crane must always be barricaded? - Answer-The swing
radius of the rear of the rotating superstructure
What is the OSHA regulation governing cranes in
construction? - Answer-1926.1400
, 3|Page
According to ASME, what percentage of the
manufacturer's crane rating must not be exceeded if a
load test is done on a repaired crane? - Answer-100%
Where is the tipping axis of a crawler crane located? -
Answer-It depends if the idler or sprocket are in line or
offset from the track rollers
What should be done with materials placed under
overhead energized power lines? - Answer-NOT be lifted
by crane
What determines the amount of deduction required for an
erected jib that is not being used? - Answer-The effective
weight of the jib
What happens to ground bearing pressure if you move a
crawler crane from soft ground to harder ground? -
Answer-It increases
How should the wheels of a crane be positioned when it is
set up for working on outriggers? - Answer-Just high
enough off the ground to relieve the tires of crane weight
