VIRGINIA HIC TEST WITH COMPLETE SOLUTIONS 2025/2026 NEW PDATE

VIRGINIA HIC TEST WITH COMPLETE SOLUTIONS 2025/2026 NEW PDATE The MOST specific information about the size and location of windows would be found in a - correct answer-Floor plan What direction does heat flow? - correct answer-Hot to cold What are batter boards - correct answer-takes and ledger boards marking building lines What is the MAXIMUM distance between a ventilating opening in an underfloor space and each corner of the building? - correct answer-3 feet What is NOT required in exterior nonbearing walls? - correct answer-Loadbearing headers A lengthwise grain separation between or through the growth rings of lumber is called a - correct answer-Shake (c 326) The abbreviation "d" in "16d" means - correct answer-Penny Notches may not be located in the ____________ of a joist span - correct answer Middle 1/3 How should board and batten be installed? - correct answer-1 inch overlap 10d nails What is the maximum allowable notch in ceiling joists - correct answer 1/6 the depth of the member How MUST rafters be framed to each other - correct answer-Gusset plate (R802.3) What is used to prevent buckling at points of high stress? - correct answer Squash blocks Prior to the installation of wood floor how long for acclimation? - correct answer-4- 5 days Where do you start laying parquet flooring - correct answer-Centerline What is the first step in carpet installation? - correct answer-Tackles strip What type of nail is used in floor installation - correct answer7d or 8d threaded/Cut steel What should be applied to crevices in wood flooring? - correct answer-Filling What is the best nail for hardwood - correct answer-Ring shank nail What is the maximum size of a floor frame opening? - correct answer5 sq ft (62) (R310.2.1)/ 4 ft header joist (130) (R502.10) When installing a string of wall cabinets, the cabinets should - correct answer-Be attached to the adjacent cabinets before to the wall What is the MINIMUM height for a stairway handrail - correct answer-34 inches A third stairway stringer should be used when the stair width exceeds correct answer-30 inches What type of nail are best for general construction? - correct answer-Smooth shank What is the MAXIMUM flame spread index for insulation materials - correct answer-25 (R302.10.1) What is the MAXIMUM dimension of the ventilation coverings for under-floor space correct answer1/4 inch (R 408.2) Flexible insulation placed in floor joists above an unheated crawl space should correct answer-Be well supported between joists/ sing a wire mesh or rigid board (c 904-5) In a crawl space how far from the floor joints do you need to place vapor retarder correct answerTop Soil Ice dam protection needs to be _________ from the edge of eaves correct answer-24 inches (R905.1.2) Where to install radiant heat barrier in attic - correct answer-Rafters What is the major advantage of icynene over poly rethane foam - correct answer Can be po red instead of sprayed In a crawl space, what kind of vapor retarder should be used? - correct answer-6 mil or 8 mil When batt insulation is installed a vapor retarder that __________ is commonly correct answer-4 mil polyethylene What is the MINIMUM amount of space that is allowed between roof sheeting and insulation to allow the passage of air? - correct answer-1 1/2 in In a ceiling batt insulation where is the vapor retarder placed? - correct answer-Against the back of ceiling finish A vapor retarder on blanket installation MUST - correct answer-Face the warm side of the wall How should radiant heat barrier be installed - correct answer-Either rafter (1st choice)/ perforated The nailing holes in al min m and vinyl siding are elongated to allow for correct answer-Expansion and contraction What is the MINIMUM lap of rabbeted horizontal lap siding - correct answer1/2 inches (R703.5.3) In a Vinyl soffit installation what type of accessory is used - correct answer-J or F Channel (c 677) What kind of siding can be vertically installed - correct answer-Board and Batten/Plywood Fiber cement siding for exterior weather wall, the MINIMUM thickness should be correct answer5/16 inches (R703.3) What is the clearance for an exterior wood siding and finish grade where the wood is untreated - correct answer-8 inches How is furring installed on horizontal vinyl siding? - correct answer-Strips should be installed vertically and completely around doors and windows What is not a siding accessory? - correct answer-Z-channel The MINIM N length drywall screw for installing 1/2-inch gyps m board to wood studs is - correct answer-1 1/4 inches (362 IRC18) What is the MAXIMUM recommended spacing for 5/8-inch drywall installed on a wall at right angles to framing members - correct answer-24 inches what type of gyps m is used in veneer plaster system - correct answer-Blueboard When installing ceiling drywall, end butt joints should - correct answer-Not be butted tightly/taped What kind of drywall is used that is fire resistant to ceilings? - correct answer-Type C/X (c 917) In which direction should drywall be fastened to steel studs? - correct answer-In one direction only How far should the screws be placed on a 3/8 ceiling drywall Applica adhesive? correct answer-16 Where does one start with the installation of drywall? - correct answer-Ceiling Screws used to fasten drywall MUST be - correct answer-Type W or Type S MINIMUM distance between screws on 1/2-inch drywall - correct answer12 inches (c 924) When installing shoe molding on a base board over hard wood floor, the shoe mold should be? - correct answer-Nailed to the base board only (c 982)