NCCER Module 3 Questions and Correct Answers

1




NCCER Module 3 Questions and Correct
Answers

Question: Which of the following types of hammers is a welder most
likely to have in their toolbox?
Answer: Ball Peen


Question: The cracked wooden handle of a hammer can be repaired by
applying tape around the damaged area
Answer: False


Question: The length of a wrecking bar is up to ...
Answer: 36 inches


Question: What nail puller is used to pull nails below or flush with the
surface of the wood?
Answer: Cat's Paw


Question: The chisel designed for forming flutes and channels is the ...
Answer: Half-round


Question: What should be used to strike a wood chisel?
Answer: Mallet


Question: Which type of screwdriver is characterized by an hourglass-
shaped tip?
Answer: Clutch-drive


Question: Which type of screwdriver works with screws that can also be
operated with hex keys?
Answer: Allen

Pretest - Stuvia US

, 2



Question: Which type of pliers is used for working in tight places?
Answer: Needle-nose


Question: Which type of pliers is used to cut large-gauge wire?
Answer: Lineman


Question: All of the following wrenches are non-adjustable except..
Answer: Pipe


Question: A slugging wrench is a type of open-end wrench.
Answer: False


Question: How many gripping points do most sockets have?
Answer: 6 or 12


Question: It is acceptable to place a piece of pipe over a ratchet to
lengthen it for increased leverage.
Answer: False


Question: The torque specification for a small fastener is usually stated
in...
Answer: inch-pounds


Question: Torque wrenches often give an audible indication when the
correct torque is achieved.
Answer: True


Question: A wooden folding rule is usually marked in...
Answer: Sixteenths of an inch




Pretest - Stuvia US