Z-51 EXAM 5 QUESTIONS WITH 100%
CORRECT ANSWERS!!
the efficiency of the refrigerant cycle is affected by the operation of the condenser. Of the
following, a more efficient centrifugal compressor operation results from
lowering the condenser pressure
In most semi hermetic compressors, the suction vapor is used for
cools the motor
The amount of refrigerant that flows through the orifices of an economizer is determined
by the
difference between the high side and the low side pressure
the instalation of an inline refrigerant cleaning system is advisable
to remove impurities from the system
a refrigerant engineer verifies that a condenser pump is cavitation of the following the most
likely cause for this condition is:
a faulty cooling tower water level controller
when an expansion valve is operating properly, at the end of the evaporator will contain
only superheated vapor
a centrifugal water pump is considered to be fully primed when
the pump is full of liquid
A refrigeration compressor has failed to turn on. the engineer on duty verifies the electrical
circuit to the motor, including all switches and circuit breakers is complete, according to
recomended service practice, the next item to be checked would likely be the:
temperature and pressure controls
, Refrigerants are characterized by their physical properties including Flashpoint,
refrigeration effect and others, of the refrigerants in commercial and industrial the highest
latent heat and refrigerant effect is:
ammonia
which of the following ashrae refrigerant safety classification is the most toxic
b3
which of the following ashrae refrigerant safety classification is the most flammable
a3
in q indirect refrigeration system,of the following, the one that would not be used as a
cooling medium for building spaces being cooled is
r 22 (cooling medium= glycol or any brine solution)
the primary way of achieving capacity control of a an centrifugal compressor is by:
adjustment to the inlet impeller pre rotation vanes
regarding the functioning of a steam turbine, why is it advisable to keep moisture in the
inlet low as possible
keeps turbine blades wear to minimum
a water chiller is equipped with a reciprocating compressor, a thermostatic expansion valve
and a an air cooled condenser. A restriction in the refrigerant line would result in
high suction super heat
the process by which refrigerant is extracted and cleaned for reuse without requirements
for reclamation is called
recycle
the purpose of wear rings in a centrifugal pump is to
prevent wearing of the pump housing and impeller
CORRECT ANSWERS!!
the efficiency of the refrigerant cycle is affected by the operation of the condenser. Of the
following, a more efficient centrifugal compressor operation results from
lowering the condenser pressure
In most semi hermetic compressors, the suction vapor is used for
cools the motor
The amount of refrigerant that flows through the orifices of an economizer is determined
by the
difference between the high side and the low side pressure
the instalation of an inline refrigerant cleaning system is advisable
to remove impurities from the system
a refrigerant engineer verifies that a condenser pump is cavitation of the following the most
likely cause for this condition is:
a faulty cooling tower water level controller
when an expansion valve is operating properly, at the end of the evaporator will contain
only superheated vapor
a centrifugal water pump is considered to be fully primed when
the pump is full of liquid
A refrigeration compressor has failed to turn on. the engineer on duty verifies the electrical
circuit to the motor, including all switches and circuit breakers is complete, according to
recomended service practice, the next item to be checked would likely be the:
temperature and pressure controls
, Refrigerants are characterized by their physical properties including Flashpoint,
refrigeration effect and others, of the refrigerants in commercial and industrial the highest
latent heat and refrigerant effect is:
ammonia
which of the following ashrae refrigerant safety classification is the most toxic
b3
which of the following ashrae refrigerant safety classification is the most flammable
a3
in q indirect refrigeration system,of the following, the one that would not be used as a
cooling medium for building spaces being cooled is
r 22 (cooling medium= glycol or any brine solution)
the primary way of achieving capacity control of a an centrifugal compressor is by:
adjustment to the inlet impeller pre rotation vanes
regarding the functioning of a steam turbine, why is it advisable to keep moisture in the
inlet low as possible
keeps turbine blades wear to minimum
a water chiller is equipped with a reciprocating compressor, a thermostatic expansion valve
and a an air cooled condenser. A restriction in the refrigerant line would result in
high suction super heat
the process by which refrigerant is extracted and cleaned for reuse without requirements
for reclamation is called
recycle
the purpose of wear rings in a centrifugal pump is to
prevent wearing of the pump housing and impeller
