11/5/2025, 7:47pm MSSC - Quality Certification 2025//Comprehensive questions and 100%
corrected answers/accurate solutions// Already graded A+ //Get it!!
MSSC - Quality Certification
2025//Comprehensive questions and 100%
corrected answers/accurate solutions//
Already graded A+ //Get it!!
STRETCH YOUR BRAIN BEFORE YOUR FIRST STUDY SESSION
Nice work you are crushing it!!!
Terms in this set (90)
Original set
Which is NOT one of the steps used in the glass box method?
rotate object in glass box
The three standard views of an object are ______.
, 11/5/2025, 7:47pm MSSC - Quality Certification 2025//Comprehensive questions and 100%
corrected answers/accurate solutions// Already graded A+ //Get it!!
top, front, right side
What is the order of precedence of lines in a drawing?
object, hidden, center
What type of feature is parallel to the surface being dimensioned?
dimension line
A ______ dimension is described in inches per foot.
shaft taper
To establish on a drawing that 1/4 inch equals 1 inch, the designer
would write ______.
1/4 = 1
Section lines on a blueprint include _______.
a surface that has been cut
In a threaded fastener assembly what is designed to protect the
threads?
shank
The minor diameter of a screw thread is measured at the ______.
root of screw thread
The minor diameter of a threaded fastener is ______.
the major diameter minus the thread height
How do you determine the grade of a bolt?
number of lines on the head +2 indicates the grade
corrected answers/accurate solutions// Already graded A+ //Get it!!
MSSC - Quality Certification
2025//Comprehensive questions and 100%
corrected answers/accurate solutions//
Already graded A+ //Get it!!
STRETCH YOUR BRAIN BEFORE YOUR FIRST STUDY SESSION
Nice work you are crushing it!!!
Terms in this set (90)
Original set
Which is NOT one of the steps used in the glass box method?
rotate object in glass box
The three standard views of an object are ______.
, 11/5/2025, 7:47pm MSSC - Quality Certification 2025//Comprehensive questions and 100%
corrected answers/accurate solutions// Already graded A+ //Get it!!
top, front, right side
What is the order of precedence of lines in a drawing?
object, hidden, center
What type of feature is parallel to the surface being dimensioned?
dimension line
A ______ dimension is described in inches per foot.
shaft taper
To establish on a drawing that 1/4 inch equals 1 inch, the designer
would write ______.
1/4 = 1
Section lines on a blueprint include _______.
a surface that has been cut
In a threaded fastener assembly what is designed to protect the
threads?
shank
The minor diameter of a screw thread is measured at the ______.
root of screw thread
The minor diameter of a threaded fastener is ______.
the major diameter minus the thread height
How do you determine the grade of a bolt?
number of lines on the head +2 indicates the grade
