Masonry Level 1 : Module 2 Q&A
The two types of accident cots are _____________. - =insuared and uninsured
signs that provide general instructions and suggestions about safety measures are
______________. - =safety signs
on a construction site, exposed rebar, slippery floors, and improperly stacked materials are
considered _____________. - =hazards
when working indoors, never place oily rags in anything other than approved _____________. -
=self-closing metal containers
the basic ingredient of mortar is _____________. - =portland cement
flammable liquids should never be used near ___________. - =fire or flame
the best protection for your eyes from all directions is provided by ____________. - =safety
googles
pain is not always felt when an injury happens to the _______________. - =ears
gloves should be exchanged for new ones when they are worn, damage, or ___________. -
=contaminated on the outside
an example of a scenario in which respiratory protection is not required on a masonry job site is
__________________. - =when mixing mortar, grout, or concrete
fall protection is required when workers are at risk of falling from works areas that are elevated
at least ________________. - =6 feet
, the vertical distance a worker moves after a fall before a deceleration device is activated is called
____________________. - =free-fall distance
OSHA defines the weight-bearing capacity of a scaffold and its components as the ability to
support, without failure, the scaffold's own weight plus at least an increase of the maximum
intended load of at least ______________. - =four times
when working on scaffold, the minimum distance that materials other than masonry and mortar
can can be stored from the working edges of a guardrail system is ________________. - =6 feet
mortar can make a tool unusable if its allowed to ____________. - =harden
when fueling gasoline-powered equipment such as saws, OSHA requires that the equipment first
be ____________. - =turned off
to empty mortar from a mortar mixer, use the mixer's dump handle and ______________. -
=drum release
when operating a tuckpoint grinder, move the grinder along the wall using ___________. -
=smooth, straight strokes
the most common cause of forklift accidents is _________________. - =mechanical and
hydraulic problems
in a tree-wire system, the green wire is connected to ______________. - =a circuit breaker
the gunpowder cartridges that powder-actuated fastening tools use to drive specially designed
fasteners into masonry and steel are called ___________________. - =boosters
when stockpiling loose brick in pile, the pile should be tapered back _______________. - =2
inches for every foot of height above the 4-foot level
The two types of accident cots are _____________. - =insuared and uninsured
signs that provide general instructions and suggestions about safety measures are
______________. - =safety signs
on a construction site, exposed rebar, slippery floors, and improperly stacked materials are
considered _____________. - =hazards
when working indoors, never place oily rags in anything other than approved _____________. -
=self-closing metal containers
the basic ingredient of mortar is _____________. - =portland cement
flammable liquids should never be used near ___________. - =fire or flame
the best protection for your eyes from all directions is provided by ____________. - =safety
googles
pain is not always felt when an injury happens to the _______________. - =ears
gloves should be exchanged for new ones when they are worn, damage, or ___________. -
=contaminated on the outside
an example of a scenario in which respiratory protection is not required on a masonry job site is
__________________. - =when mixing mortar, grout, or concrete
fall protection is required when workers are at risk of falling from works areas that are elevated
at least ________________. - =6 feet
, the vertical distance a worker moves after a fall before a deceleration device is activated is called
____________________. - =free-fall distance
OSHA defines the weight-bearing capacity of a scaffold and its components as the ability to
support, without failure, the scaffold's own weight plus at least an increase of the maximum
intended load of at least ______________. - =four times
when working on scaffold, the minimum distance that materials other than masonry and mortar
can can be stored from the working edges of a guardrail system is ________________. - =6 feet
mortar can make a tool unusable if its allowed to ____________. - =harden
when fueling gasoline-powered equipment such as saws, OSHA requires that the equipment first
be ____________. - =turned off
to empty mortar from a mortar mixer, use the mixer's dump handle and ______________. -
=drum release
when operating a tuckpoint grinder, move the grinder along the wall using ___________. -
=smooth, straight strokes
the most common cause of forklift accidents is _________________. - =mechanical and
hydraulic problems
in a tree-wire system, the green wire is connected to ______________. - =a circuit breaker
the gunpowder cartridges that powder-actuated fastening tools use to drive specially designed
fasteners into masonry and steel are called ___________________. - =boosters
when stockpiling loose brick in pile, the pile should be tapered back _______________. - =2
inches for every foot of height above the 4-foot level
