RVTI QUESTIONS AND CORRECT
DETAILED ANSWERS WITH
RATIONALES|ALREADY GRADED A+
where is the regulator in relation to the container? - ANSWERDownstream
what does the first stage of the regulator reduce the pressure to? -
ANSWERapproximately 10
lb/in2 gauge (PSIG)
what does the second stage of the regulator reduce the pressure too? - ANSWER11 in
WC
each magnet on a trailer brae system should draw how many amps? - ANSWER3.2
amps max
what kind of lube should be used for slideouts? - ANSWERdry lube
a class II hitch is rated for? - ANSWERClass II hitches are weight carrying (WC) hitches
rated up to 3500 lbs. gross trailer weight (GTW) with a maximum trailer tongue weight
(TW) of 300 lbs.
when performing a lockup test where should you put the manometer? -
ANSWERbarbed fitting on the test device
what position should the sweep seal be in? - ANSWERna Inspect for proper contact
with slide-out wall, roof, and floor; verify good contact with each sealing surface; no
rotting or cracks and tears in rubber components
to operate the leveling system what position should the brakes be in? -
ANSWERparking brake
should you use vise grips on propane tanks - ANSWERno
where is the automatic change over regulator found? - ANSWERinbetween two propane
containers
on a new trailer the drums are seated after how many braking applications? -
ANSWERafter the first 200 miles of operation
What is the purpose of a propane regulator? - ANSWERto reduce the pressure of the
propane
, What does it mean when you have a grid pattern on a laminated sidewall? -
ANSWERMeans it's a hung wall
Fiberglass is glued to the stud work
where should a motorhomes exhaust pipes be in relation to the back of the motorhome?
- ANSWERSticking out slightly past the back of the home
Why should you purge a new propane container - ANSWERNew propane containers
could have air and water contaminants creating false pressure
DT3.5 mean what? - ANSWERDip tube length 3.5
what is a contaminant of hydrofluid? is it air? - ANSWERwater
who regulates the propane safety NFPA? or AGA? - ANSWERDOT for the cylinders
Asme tanks
what is the fuction of a stabilizer jack - ANSWERjust keep the rv from rocking
How do you test for propane overfill? - ANSWER
What sealant is not to be used for roofs - ANSWERNot silicone
what are all the possible ways you can start a generator - ANSWERusually the
compartent on the generator controls
• multuple remote panels
Automatic Transfer Panels
•
RV Converter Control
•
RV Master Control Panel
•
Key Fob Wi-Fi Start
•
Others
what is the common term to refer to all tanks? - ANSWERcontainers when referring to
ALL
Tanks for same
Cylinders for cylinders
what kind of battery cable comes from the positive terminal of the battery to the
generator? - ANSWERStranded
DETAILED ANSWERS WITH
RATIONALES|ALREADY GRADED A+
where is the regulator in relation to the container? - ANSWERDownstream
what does the first stage of the regulator reduce the pressure to? -
ANSWERapproximately 10
lb/in2 gauge (PSIG)
what does the second stage of the regulator reduce the pressure too? - ANSWER11 in
WC
each magnet on a trailer brae system should draw how many amps? - ANSWER3.2
amps max
what kind of lube should be used for slideouts? - ANSWERdry lube
a class II hitch is rated for? - ANSWERClass II hitches are weight carrying (WC) hitches
rated up to 3500 lbs. gross trailer weight (GTW) with a maximum trailer tongue weight
(TW) of 300 lbs.
when performing a lockup test where should you put the manometer? -
ANSWERbarbed fitting on the test device
what position should the sweep seal be in? - ANSWERna Inspect for proper contact
with slide-out wall, roof, and floor; verify good contact with each sealing surface; no
rotting or cracks and tears in rubber components
to operate the leveling system what position should the brakes be in? -
ANSWERparking brake
should you use vise grips on propane tanks - ANSWERno
where is the automatic change over regulator found? - ANSWERinbetween two propane
containers
on a new trailer the drums are seated after how many braking applications? -
ANSWERafter the first 200 miles of operation
What is the purpose of a propane regulator? - ANSWERto reduce the pressure of the
propane
, What does it mean when you have a grid pattern on a laminated sidewall? -
ANSWERMeans it's a hung wall
Fiberglass is glued to the stud work
where should a motorhomes exhaust pipes be in relation to the back of the motorhome?
- ANSWERSticking out slightly past the back of the home
Why should you purge a new propane container - ANSWERNew propane containers
could have air and water contaminants creating false pressure
DT3.5 mean what? - ANSWERDip tube length 3.5
what is a contaminant of hydrofluid? is it air? - ANSWERwater
who regulates the propane safety NFPA? or AGA? - ANSWERDOT for the cylinders
Asme tanks
what is the fuction of a stabilizer jack - ANSWERjust keep the rv from rocking
How do you test for propane overfill? - ANSWER
What sealant is not to be used for roofs - ANSWERNot silicone
what are all the possible ways you can start a generator - ANSWERusually the
compartent on the generator controls
• multuple remote panels
Automatic Transfer Panels
•
RV Converter Control
•
RV Master Control Panel
•
Key Fob Wi-Fi Start
•
Others
what is the common term to refer to all tanks? - ANSWERcontainers when referring to
ALL
Tanks for same
Cylinders for cylinders
what kind of battery cable comes from the positive terminal of the battery to the
generator? - ANSWERStranded
