Osha Exam Questions and Answers 100% Pass

Osha Exam Questions and Answers 100% Pass Which of the following answer options are potential benefits of a safety and health program? - all of the above Sebastian manages a team of healthcare professionals in a critical care unit. Recently, he worked with other management to revise the safety and health programs for his team's section of the hospital. To make sure these revisions are successful, Sebastian has posted a copy of their safety and health policy statement with his and other managers' signatures on it in each of the nurses' stations on their floor. He also has been letting the healthcare professionals under him know the team's health and safety goals for the upcoming months and what the team's roles will be to reach that goal, including his own. What element would best describe Sebastian's actions toward a successful safety and health program? - Management Leadership. Cora works for a large supermarket primarily as a stocker, but she also is a cashier when needed. She and her coworkers use a system for reporting any injuries, near misses, or other safety and health concerns while she is on the job. Cora and her 2100% Pass Guarantee Katelyn Whitman, All Rights Reserved © 2025 coworkers also discuss any safety and health issues with their supervisors or managers whenever there is an issue, because a few months ago the management implemented an open-door policy for discussing safety and health problems that Cora and her co- workers might see. A lot of these changes are the result of Cora being involved with the development of the supermarket's safety and health program, where she brought forward some of the hazards she saw in the stock room and aisles of the building and trained newer employees on proper safety techniques. What element would best describe Cora's actions toward a successful safety and health program? - Worker Participation What are three methods to prevent and/or control workplace hazards? - use a hazard control plan to select and implement controls, evaluate the effectiveness of existing controls, and develop plans with measures to protect workers during emergencies and nonroutine activities. You've been assigned to inspect a mixer, so you begin by looking at the piece of equipment from all sides. You note that there is no guard on the mixer, there is no ramp present so the worker must lift vats into the mixer, the mixer post is not protected with a sleeve, the cover for the motor is missing, and there is a puddle on the floor that creates a slip hazard. Next, you watch a worker operate the mixer. The worker is not wearing earplugs around this noisy mixer, isn't wearing a respirator around the chemical fumes, and isn't wearing the proper PPE for the chemicals going into the 3100% Pass Guarantee Katelyn Whitman, All Rights Reserved © 2025 mixer. - The hazards present around the mixer are noise, pinch point, ergonomic, entanglement, and slips, trips, and falls. You're inspecting the fall protection used on a high beam at a construction site. First, you look at the setup. There isn't a shock absorber present on the life line. Next, you watch a worker use her fall protection. She unclipped too early, which left her unprotected from a fall. Then, you noticed that she wasn't wearing safety glasses, putting her at risk for eye injuries. Finally, you interviewed the worker and made these notes about what she said: - The hazards present with the fall protection are flying debris, safety, and fall. - The hazards present in this housekeeping situation are exposure from unlabeled containers of biological and/or chemical hazards and aerosol biological and chemical hazards, skin irritation, and slips, trips and falls. Select controls for emergency and non-routine operations. Is this action a part of Hazard Identification or Hazard Prevention and Control? - Hazard Prevention and Control Identify hazards associated with emergency and non-routine situations. Is this action a part of Hazard Identification or Hazard Preventi