FL State Firefighter Test QUESTIONS &
ANSWERS 2025 LATEST UPDATE
what is the mission of the fire service?
a) to provide a variety of services
b) to determine how fire loss occurs
c) to save lives and protect property
d) to regulate training of emergency responders - ANSWER c) to save lives and protect
property
What NFPA standard establishes basic training criteria for Firefighter I and Firefighter
II?
a) 1001
b) 1002
c) 1021
d) 1582 - ANSWER a) 1001
A(an) ___ is a collection of rules enacted by law in a particular jurisdiction.
a) code
b) policy
c) standard
d) procedure - ANSWER a) code
which of the following BEST describes the action first taken after an alert to the station?
a) recording of incident information
b) processing of postincident paperwork
c) dispatching of emergency services responders
d) training of emergency responders for annual certification - ANSWER c) dispatching of
emergency services responders
the use of ten-codes in radio transmissions was replaced when agencies began to
adopt which of the following?
a) incident action plan (IAP)
b) incident command system (ICS)
c) national fire protection association (NFPA)
d) national incident management system (NIMS) - ANSWER d) national incident
management (NIMS)
What task may a telecommunications center be assigned during a progress report?
a) requesting multiple or special alarms
b) providing periodic time transmissions
c) warning personnel of impending hazard on scene
d) giving command in the absence of command staff - ANSWER b) providing periodic
time transmissions
,which of the following BEST describes when an SCBA cylinder needs to be replaced?
a) after first use of cylinder
b) when the cylinder becomes completely empty
c) while performing short-term work in emergency operations
d) during inspection if cylinder contains less than 90% of capacity - ANSWER d) during
inspection if cylinder contains less than 90% of capacity
In the OATH method of signaling on a search line, two tugs represents:
a) O - ok
b) H - help
c) A - advance
d) T - take-up slack - ANSWER c) A - advance
which of the following is an example of a push /pull tool?
a) hux bar
b) pike pole
c) drywall saw
d) battering ram - ANSWER b) pike pole
cutting edges on axes should be inspected for:
a) wetness or swelling
b) rust, tarnish, or dirt
c) chips, cracks, or spurs
d) cracks, blisters, or splinters - ANSWER c) chips, cracks, or spurs
What should a firefighter do before stepping off a ladder, parapet wall, or other place of
safety onto the roof of a burning building, especially if the roof surface is obscured by
smoke or darkness?
a) ensure the safety of all personnel who are assisting
b) direct a fire stream into an existing vertical exhaust opening
c) sound the roof for structural integrity by striking with an axe
d) direct a fire stream into an existing horizontal exhaust opening - ANSWER c) sound
the roof for structural integrity by striking with an axe
What type of hose is designed for drafting water from static water supplies or
connecting to a fire hydrant?
a) soft sleeve hose
b) hard-suction hose
c) double-jacket hose
d) suction supply hose - ANSWER b) hard-suction hose
what type of fire hose damage can weaken the jacket which can lead to ruptures under
pressure?
a) organic damage
, b) thermal damage
c) chemical damage
d) mechanical damage - ANSWER a) organic damage
which of the following equipment is necessary for service testing?
a) hose clamps
b) chaffing blocks
c) a hose-washing machine
d) nozzles with shutoff valves - ANSWER d) nozzles with shutoff valves
the test site for service testing should be:
a) on a gravel area
b) on a slight grade
c) as close to the station as possible
d) large enough to lay out hose with multiple kinks - ANSWER b) on a slight grade
which of the following procedures should be followed when service testing fire hose?
a) close all valves as quickly as possible
b) pick up all large-diameter hose before charging it
c) stand away from the discharge valve connection when charging hose
d) connect the hose to discharges on the pump panel side of the apparatus - ANSWER
c) stand away from the discharge valve connection when charging hose
which of the following statements about Class A foam concentrates is MOST accurate?
a) Class A foam is used for structural fires, but is not suitable for wildland fires
b) Class A foam is used to prevent ignition of fires involving flammable and combustible
liquids
c) Class A foam reduces the surface tension of water, allowing better water penetration
into the fuel
d) Class A foam concentrate coats and protects application equipment; equipment
should not be flushed after use - ANSWER c) Class A foam reduces the surface tension
of water, allowing better water penetration into the fuel
Flammable liquids that mix readily with water are:
a) polar solvents
b) viscous liquids
c) fluorosurfactants
d) hydrocarbon fuels - ANSWER a) polar solvents
Which foams are required to extinguish fires of ethanol or ethanol-based fuels?
A. Class A foams
B. Synthetic foams
C. Protein-based foams
D. Alcohol-resistant foams - ANSWER D) alcohol-resistant foams
which of the following statements about foam proportioning is MOST accurate?
ANSWERS 2025 LATEST UPDATE
what is the mission of the fire service?
a) to provide a variety of services
b) to determine how fire loss occurs
c) to save lives and protect property
d) to regulate training of emergency responders - ANSWER c) to save lives and protect
property
What NFPA standard establishes basic training criteria for Firefighter I and Firefighter
II?
a) 1001
b) 1002
c) 1021
d) 1582 - ANSWER a) 1001
A(an) ___ is a collection of rules enacted by law in a particular jurisdiction.
a) code
b) policy
c) standard
d) procedure - ANSWER a) code
which of the following BEST describes the action first taken after an alert to the station?
a) recording of incident information
b) processing of postincident paperwork
c) dispatching of emergency services responders
d) training of emergency responders for annual certification - ANSWER c) dispatching of
emergency services responders
the use of ten-codes in radio transmissions was replaced when agencies began to
adopt which of the following?
a) incident action plan (IAP)
b) incident command system (ICS)
c) national fire protection association (NFPA)
d) national incident management system (NIMS) - ANSWER d) national incident
management (NIMS)
What task may a telecommunications center be assigned during a progress report?
a) requesting multiple or special alarms
b) providing periodic time transmissions
c) warning personnel of impending hazard on scene
d) giving command in the absence of command staff - ANSWER b) providing periodic
time transmissions
,which of the following BEST describes when an SCBA cylinder needs to be replaced?
a) after first use of cylinder
b) when the cylinder becomes completely empty
c) while performing short-term work in emergency operations
d) during inspection if cylinder contains less than 90% of capacity - ANSWER d) during
inspection if cylinder contains less than 90% of capacity
In the OATH method of signaling on a search line, two tugs represents:
a) O - ok
b) H - help
c) A - advance
d) T - take-up slack - ANSWER c) A - advance
which of the following is an example of a push /pull tool?
a) hux bar
b) pike pole
c) drywall saw
d) battering ram - ANSWER b) pike pole
cutting edges on axes should be inspected for:
a) wetness or swelling
b) rust, tarnish, or dirt
c) chips, cracks, or spurs
d) cracks, blisters, or splinters - ANSWER c) chips, cracks, or spurs
What should a firefighter do before stepping off a ladder, parapet wall, or other place of
safety onto the roof of a burning building, especially if the roof surface is obscured by
smoke or darkness?
a) ensure the safety of all personnel who are assisting
b) direct a fire stream into an existing vertical exhaust opening
c) sound the roof for structural integrity by striking with an axe
d) direct a fire stream into an existing horizontal exhaust opening - ANSWER c) sound
the roof for structural integrity by striking with an axe
What type of hose is designed for drafting water from static water supplies or
connecting to a fire hydrant?
a) soft sleeve hose
b) hard-suction hose
c) double-jacket hose
d) suction supply hose - ANSWER b) hard-suction hose
what type of fire hose damage can weaken the jacket which can lead to ruptures under
pressure?
a) organic damage
, b) thermal damage
c) chemical damage
d) mechanical damage - ANSWER a) organic damage
which of the following equipment is necessary for service testing?
a) hose clamps
b) chaffing blocks
c) a hose-washing machine
d) nozzles with shutoff valves - ANSWER d) nozzles with shutoff valves
the test site for service testing should be:
a) on a gravel area
b) on a slight grade
c) as close to the station as possible
d) large enough to lay out hose with multiple kinks - ANSWER b) on a slight grade
which of the following procedures should be followed when service testing fire hose?
a) close all valves as quickly as possible
b) pick up all large-diameter hose before charging it
c) stand away from the discharge valve connection when charging hose
d) connect the hose to discharges on the pump panel side of the apparatus - ANSWER
c) stand away from the discharge valve connection when charging hose
which of the following statements about Class A foam concentrates is MOST accurate?
a) Class A foam is used for structural fires, but is not suitable for wildland fires
b) Class A foam is used to prevent ignition of fires involving flammable and combustible
liquids
c) Class A foam reduces the surface tension of water, allowing better water penetration
into the fuel
d) Class A foam concentrate coats and protects application equipment; equipment
should not be flushed after use - ANSWER c) Class A foam reduces the surface tension
of water, allowing better water penetration into the fuel
Flammable liquids that mix readily with water are:
a) polar solvents
b) viscous liquids
c) fluorosurfactants
d) hydrocarbon fuels - ANSWER a) polar solvents
Which foams are required to extinguish fires of ethanol or ethanol-based fuels?
A. Class A foams
B. Synthetic foams
C. Protein-based foams
D. Alcohol-resistant foams - ANSWER D) alcohol-resistant foams
which of the following statements about foam proportioning is MOST accurate?
