1/12/25, 6:08 PM MWS CCRE |2025 Update|Complete Frequently Tested Questions And Verified Answers|100% Accurate Answers | Already Gr…
MWS CCRE |2025 Update|Complete Frequently
Tested Questions And Verified Answers|100%
Accurate Answers | Already Graded A+|Get it
right!!
Terms in this set (96)
Evaluate how quickly the priming device can create
The purpose of the
a vacuum to bring water through a pumpto the
priming device test is to:
discharge hose.
Identify TWO items that Coolant levels
should be included on
daily MWS apparatus
records.
Traveling at high speeds Leave the road surface and roll over.
on a curvy road may
cause an MWS apparatus
to:
Identify the THREE steps 1. Check the side and rear view mirrors.
for changing to the left 2. Activate the turn signal.
lane on a limited access 3. Move the apparatus safely to the left lane.
highway.
Identify the FOUR steps 1. Maintain apparatus speed.
for passing through a 2. Check the side streets or roads.
straight section of a road 3. Check the side and rear view mirrors.
or highway. 4. Check for oncoming traffic.
When performing the Should only travel in one direction, without striking
serpentine exercise, you: the obstruction.
https://quizlet.com/992073591/mws-ccre-2025-updatecomplete-frequently-tested-questions-and-verified-answers100-accurate-answers-already-… 1/13
, 1/12/25, 6:08 PM MWS CCRE |2025 Update|Complete Frequently Tested Questions And Verified Answers|100% Accurate Answers | Already Gr…
All of the following Use the appropriate turn signal.
statements about driving
an MWS apparatus
through areas of
restricted horizontal and
vertical clearances are
true EXCEPT:
The best type of strainer Floating strainer.
to use in a shallow stream
is a:
NFPA rates all fire pumps 10 feet of lift.
to meet their capacity
from a draft at:
Which equation is used EP = 0.5x20
to determine the
elevation pressure loss
for resupplying a pumper
located approximately 20
feet above the location
of the MWS?
The best definition of Force of water per unit area.
water pressure is the:
All of the following Pump pressure loss
factors must be included
when determining the
total pressure loss (TPL)
EXCEPT:
The hand method can be 2 1/2 inches
used for estimating the
friction loss in a hoseline
with a diameter of:
Large diameter hoses are 4-6 inches.
generally defined as
hoses with a diameter
between:
https://quizlet.com/992073591/mws-ccre-2025-updatecomplete-frequently-tested-questions-and-verified-answers100-accurate-answers-already-… 2/13
MWS CCRE |2025 Update|Complete Frequently
Tested Questions And Verified Answers|100%
Accurate Answers | Already Graded A+|Get it
right!!
Terms in this set (96)
Evaluate how quickly the priming device can create
The purpose of the
a vacuum to bring water through a pumpto the
priming device test is to:
discharge hose.
Identify TWO items that Coolant levels
should be included on
daily MWS apparatus
records.
Traveling at high speeds Leave the road surface and roll over.
on a curvy road may
cause an MWS apparatus
to:
Identify the THREE steps 1. Check the side and rear view mirrors.
for changing to the left 2. Activate the turn signal.
lane on a limited access 3. Move the apparatus safely to the left lane.
highway.
Identify the FOUR steps 1. Maintain apparatus speed.
for passing through a 2. Check the side streets or roads.
straight section of a road 3. Check the side and rear view mirrors.
or highway. 4. Check for oncoming traffic.
When performing the Should only travel in one direction, without striking
serpentine exercise, you: the obstruction.
https://quizlet.com/992073591/mws-ccre-2025-updatecomplete-frequently-tested-questions-and-verified-answers100-accurate-answers-already-… 1/13
, 1/12/25, 6:08 PM MWS CCRE |2025 Update|Complete Frequently Tested Questions And Verified Answers|100% Accurate Answers | Already Gr…
All of the following Use the appropriate turn signal.
statements about driving
an MWS apparatus
through areas of
restricted horizontal and
vertical clearances are
true EXCEPT:
The best type of strainer Floating strainer.
to use in a shallow stream
is a:
NFPA rates all fire pumps 10 feet of lift.
to meet their capacity
from a draft at:
Which equation is used EP = 0.5x20
to determine the
elevation pressure loss
for resupplying a pumper
located approximately 20
feet above the location
of the MWS?
The best definition of Force of water per unit area.
water pressure is the:
All of the following Pump pressure loss
factors must be included
when determining the
total pressure loss (TPL)
EXCEPT:
The hand method can be 2 1/2 inches
used for estimating the
friction loss in a hoseline
with a diameter of:
Large diameter hoses are 4-6 inches.
generally defined as
hoses with a diameter
between:
https://quizlet.com/992073591/mws-ccre-2025-updatecomplete-frequently-tested-questions-and-verified-answers100-accurate-answers-already-… 2/13
