MSSC Quality Exam Questions Correct Answers Current Update (Verified A+ Pass)

MSSC Quality Exam Questions Correct Answers Current Update (Verified A+ Pass) true, because the auditor is responsible for an accurate report of all findings - CPT Quality and Measurement Consider the statement "Even if corrective action is taken immediately for a finding during the audit, all significant deficiencies should be detailed in the written report" This statement is Ensure that procedures and processes are followed - The purpose of a quality audit program is Measurement and calibration - While on the production floor which of the following is audited obtain relatively uniform results - One of the most important reasons for a checklist in an "in process" audit is to The audit time should be cut in half to every three months - A Corrective Action Report was submitted to prevent using the wrong ink in a marking process. This has been a recurring problem. The normal audit time in this department is usually every six months. What should be done in this situation? Ask for help - A worker is filling in while the supervisor is on vacation, and is responsible for keeping track of a pH level of a cleaning process The worker does not understand one of the items to be filed in. What should he/she do? Someone outside of the organization - A basic requirement of a third party audit organization is that it is conducted by 2 | P a g e Katelyn Whitman© 2025, All Rights Reserved. number of defects - The specific effect of a quality assurance system on a manufacturing department can be measured by quality and capability of production - End-item product audits will directly measure the the date the tool is due for calibration - What is the most important item to appear on the calibration label of a tool that is used to measure and test equipment as dictated by company standards - In general, how often should a surface finish gage be mastered/calibrated? calibrated - To ensure continued accuracy, inspection devices must be periodically calibration - Adjusting an instrument or device to a standard is called reliability - Which of the following is the basis for establishing calibration intervals:? continuous improvement policies and procedures - Quality assurance systems include many important components, including problem analysis tools - Brainstorming, cause and effect diagrams, and root cause analysis are all use all available information resources - When investigating a problem it is best to customer - The most important measure of external quality is product performance as viewed by the establish measurements for process improvements - Within a company, a quality metric is used to standards and specifications for conformance and results of the inspection - Inspection Documentation Forms include the following information: Check the tool with a 2.000 inch gage block to ensure that it is still set properly. - A special toot that is pre-set with a 2.00 inch gage block fell off the surface plate but it did not appear to be damaged. It is used for a "hot" job that needs ot be shipped in the afternoon. What should be done? 3 | P a g e Katelyn Whitman© 2025, All Rights Reserved. 3.115 (need to add photo) - The indicator shown has been mastered using a part that measures 3.100 inches in length. What is the actual length of the part? micrometer - Identify a device that measures length to an accuracy of .0001 inch calibrated torque wrench - Which of the following instruments is used for measuring proper torque? gauge block - To eliminate indicator measurement error a device called a _________ is used as the reference part. used as a reference surface - A surface plate is always put a hold tag on the shipment and inform purchasing immediately - A shipment of plated fasteners has been received from a familiar vendor, but there was no certification with the shipment. The receiving inspector should tolerance - A _____________ is the total amount by which a specified dimension is allowed to vary and still be a good part. as early as possible in the design process - Design Failure Mode and Effect Analysis (DFMEA) should be conducted What were the results? - Of four questions answere on a Corrective Action Report, which answer is used to determine if a corrective actin has taken place? require additional inspection - Parts that are labeled with a red tag - "HOLD" data that demonstrates the effectiveness of the action - In a Corrective Action Report, the answer to "What Were the Results?" must include