MSSC Quality Systems Exam Questions Complete Solutions New Update (Verified Answers)

MSSC Quality Systems Exam Questions Complete Solutions New Update (Verified Answers) Automated part inspection commonly uses __________. - vision systems Parts labeled ______ should be inspected to determine if they should be reworked or scrapped. - hold _____________ inspections assure that the equipment, personnel and processes being used are providing the desired results and allow systems to be pinpointed and solutions implemented before the problem can escalate. - In-process When parts need further inspection they should be labeled as ______. - Hold Red tags are typically attached to parts that are __________. - scrapped The cost of a product's raw materials does not typically determine if __________. - the product is non- conforming Parts that are labeled as ok To ship must _________. - meet compliance Measurement of product quality attributes can be assisted by performing __________. - daily quality and equipment checks The sampling plan uses a(n) _________ chart that indicates to an inspector the number of parts to inspect based on the size of the product batch. - frequency 2 | P a g e Katelyn Whitman© 2025, All Rights Reserved. Certain characteristics of parts are essential for its proper operation. Identifying these characteristics as _______ helps set up a meaningful quality inspection program. - critical An engineering change notice (ECN) is used to notify changes to __________. - a product drawing The review of audit procedures and instructions are control and planning functions within a(n) __________. - traceability program A ___________ is used to verify that the proper procedures and processes are being adhered to by plant personnel. - quality audit program Instrument reliability is examined to determine _____________________. - calibration intervals The calibration of instruments and measurement devices is typically checked as a part of a _______________. - quality audit Machine time, task time, and quality requirements are information needed to __________. - document each process Manufacturers would typically have a _______________ performed to make sure its quality system is being maintained effectively. - quality system audit A(n) ________ should always be someone outside the organization. - third party audit group Auditors should always _____________ if the problem has been corrected. - include the problem in their report The main objective of a _____________ is to make sure corrective action is taken to eliminate problems permanently. - Material Review Board (MRB) Electrical equipment should only be worked on ____________. - after someone has inspected and tested the equipment to ensure that is has been properly de-energized 3 | P a g e Katelyn Whitman© 2025, All Rights Reserved. Results are more uniform if a(n) _____________ is used during an in-process audit. - checklist The quality of the outgoing product can be measured directly with what kind of audit? - end item product Companies use _________ to show data about the progress of production. - job status reports The principles of ____________ help reduce product costs by managing inventory. - Just-in-time (JIT) Machine time, quality requirements, and task time are __________. - required to document a process Only the supervisor or a person in the quality assurance department c