BNSF Roadway Worker Protection Questions And Answers With Verified Tests 100% Correct Answers

Which category of on-track safety methods must be used if a project involves equipment working in the foul? - ️️Working limits on controlled and non-controlled track. ___________________ are tracks with track centers spaced less than 25 feet apart. - ️️Adjacent tracks The FRA requires a personal fall arrest system be used by employees (working outside the rails and without handrails and walkways) on railroad bridges where the fall hazard is ___ feet or greater above the ground or water surface. - ️️12 If contractor employees are working without personal fall arrest gear over or adjacent to water that is deeper than 4 feet or where the danger of drowning exists, they must be equipped with the following: - ️️Coast Guard approved life vest. Lifesaving skiff. Coast Guard approved life ring. ALL OF THE ABOVE. At a minimum, contractor employees are required to wear the following PPE when they are on railroad property. - ️️Hard hat, safety boots, safety glasses, safety vest To initially report severe hazards, begin a radio call with: - ️️Emergency, emergency, emergency Slips, trips, and falls are common causes of injury while fouling track. Which of the following is NOT a recommended safe behavior to prevent slipping, tripping or falling? - ️️Walk on ties between the rails when you have safe sight distance. When a contractor is working for a railroad client, requirements from which agencies must be met? - ️️FRA, Railroad Client, OSHA What must an EIC do before any roadway worker fouls a track? - ️️Conduct an ontrack safety job briefing. When is an on-track safety job briefing considered complete? - ️️When each roadway worker acknowledges understanding of protection provided. A roadway worker has a "Right to Challenge". When concerned about compliance with on-track safety rules he/she must report his/her concerns to: - ️️The EIC.The method of on-track safety used depends on what factors? - ️️The work to be performed The type of track on which the work will be performed The weather and physical characteristics of the track ALL OF THE ABVOVE When using train approach warning method of on-track safety, roadway workers must ensure they can clear the track and be in a predetermined place of safety: - ️️At least 15 seconds prior to train arrival. A Watchman/Lookout is required for this type of on-track safety. - ️️Train approach warning Roadway Worker Protection training - ️️Must be renewed annually. The cardinal rule of railroading is: - ️️Always expect a train or equipment to move on any track in either direction at any time.