Enphase Storage design certification Training Exam Questions And Answers (Guaranteed A+)

©FYNDLAY EXAM SOLUTIONS 2024/2025 ALL RIGHTS RESERVED. 1 | P a g e Enphase Storage design certification Training Exam Questions And Answers (Guaranteed A+) Which component of the Ensemble system detects a grid failure? A. Envoy B. Enpower C. Encharge - answerB. Enpower True or false: PV systems with Energy storage but without backup power do not require Enpower. - answerTrue Where do the hot conductors between Encharge and Enpower terminate? A. In the IQ Combiner box B. At the DER (distributed energy resource) input terminals C. On the Encharge circuit breaker terminals D. On the PV circuit breaker terminals Clear my choice - answerB. At the DER (distributed energy resource) input terminals ©FYNDLAY EXAM SOLUTIONS 2024/2025 ALL RIGHTS RESERVED. 2 | P a g e What is the maximum amount of PV and storage that can be connected to the Enpower smart switch? A. 80A of PV and 80A of storage for a total of 160A B. 80A of PV or 80A of storage for a total of 80A C. 40A of PV and 40A of storage for a total of 80A D. 0A, PV and Storage is landed in a backup loads panel - answerA. 80A of PV and 80A of storage for a total of 160A Do we need to install an additional service disconnect if the Enpower main service breaker has been installed as the main service disconnect? A. No, it is not necessary to install an additional disconnect B. It depends on the use case C. Yes, it has to be redundant and serve as a rapid shutdown initiation device - answerA. No, it is not necessary to install an additional disconnect Why does Enpower need a Neutral Forming Transformer to operate during the grid outage? A. Because NEC 2017 requires a transformer to have reference to Neutral B. Because Encharge batteries operate 240 VAC line to line and split phase power systems require a neutral ©FYNDLAY EXAM SOLUTIONS 2024/2025 ALL RIGHTS RESERVED. 3 | P a g e C. Because when the grid is down the micro inverters operate on 120 VA - answerB. Because Encharge batteries operate 240 VAC line to line and split phase power systems require a neutral The above system was initially estimated to require three Encharge 3 equivalent to one Encharge 10 and no soft starter. After the site survey, they found that the largest single load in the backup load center, is going to be a 3 kVA electric motor with a start current of 32 Amps at 240 VAC for 3 seconds. Is the estimated size of one Encharge 10 going to be enough to comply with NEC 2017 710.15 (A) without using a soft starter? A. Yes, one Encharge 10 will comply B. One Encharge 10 is ok because NEC 2017 710.5(A) only applies to whole home backup C. No, it requires a minimum of 4 Encharge 3 to comply - answerC. No, it requires a minimum of 4 Encharge 3 to comply For partial home backup the guidelines in the Ensemble planning guide recommend the size of the energy storage system to be the largest of: -- Largest single load in the essential loads subpanel -- Result of load analysis of power, surge and reactive power For whole home backup what is added to the partial home backup list of items to extract the largest? A. No items are added, the guidelines for whole home are the same as for partial home backup B. Soft starters