NEW 2024 ASE G1 EXAM WITH
ACCURATE ANSWERS
,NEW 2024 ASE G1 EXAM WITH
ACCURATE ANSWERS
Why are drum brakes adjusted?
a. To stop loose wheel bearings
b. To prevent brake fluid evaporation
c. To reduce fluid loss
check
d. To compensate for lining wear - CORRECT ANSWERSd. To compensate for lining wear
The starter motor was recently replaced and now makes a whining noise when starting. Which of the
following is the MOST likely cause?
a. Wrong starter installed
b. Shims left out
c. Defective solenoid
d. Defective flywheel - CORRECT ANSWERSb. Shims left out
A tight timing belt makes what type of noise? - CORRECT ANSWERSWhining
A RWD (rear wheel drive) transmission has a leaking output shaft seal on a vehicle with 25,000 miles on
the odometer. The MOST likely cause for the leakage is: - CORRECT ANSWERSPlugged Transmission
Breather filter
Of the following, when replacing a CV (constant velocity) joint or boot, what is the last step before
clamping the boot? - CORRECT ANSWERSBurping
Steering dampers can be used to reduce excessive __________. - CORRECT ANSWERSpositive caster
A technician is rotating the tires using the modified X-method of tire rotation on a front-wheel-drive
vehicle. Where should be the right front wheel placed? - CORRECT ANSWERSRight Rear
, The open circuit voltage (OCV) test on a fully charged battery should show which voltage? - CORRECT
ANSWERS12.6
There is white exhaust smoke coming from the tailpipe of a vehicle well after the engine has been
started. What is causing this condition? - CORRECT ANSWERSCoolant in combustion chamber
A front wheel drive vehicle has a clacking noise that only occurs while cornering. The technician suspects
a faulty front axle. Which of these is most likely the cause? - CORRECT ANSWERSOuter CV Joint
The tread of a tire is worn in the center and not on the outer shoulders. Technician A says this is caused
by an improper wheel alignment angle. Technician B says this is caused by an over-inflated tire. Who is
correct? (Just the letter) - CORRECT ANSWERSB
A vehicle with power assist brakes has a hard brake pedal. Which of these is the most likely cause? -
CORRECT ANSWERSA Faulty Brake Booster
Technician A says that oil should be squirted into all of the cylinders before taking a compression test.
Technician B says that if the compression greatly increases when some oil is squirted into the cylinders,
it indicates defective or worn piston rings. Which technician is correct? (Letter only) - CORRECT
ANSWERSB
During a cylinder leakage (leak-down) test, air is noticed coming out of the oil fill opening. Technician A
says that the oil filter may be clogged. Technician B says that the piston rings may be worn or defective.
Which technician is correct? (Letter only) - CORRECT ANSWERSB
What precautions are needed to be performed to help prevent air from getting trapped in the cooling
system when replacing coolant? - CORRECT ANSWERSOpen the Bleeder Valve during filling
To flush a hydraulic clutch system, what should be used? - CORRECT ANSWERSDOT 3
The engine of a vehicle will start, but is slow cranking. Technician A says there may be resistance in the
starter circuit. Technician B says to perform a voltage drop test to test for excessive resistance in the
starter circuit. Who is correct? ("A" "B" or "Both") - CORRECT ANSWERSBoth
ACCURATE ANSWERS
,NEW 2024 ASE G1 EXAM WITH
ACCURATE ANSWERS
Why are drum brakes adjusted?
a. To stop loose wheel bearings
b. To prevent brake fluid evaporation
c. To reduce fluid loss
check
d. To compensate for lining wear - CORRECT ANSWERSd. To compensate for lining wear
The starter motor was recently replaced and now makes a whining noise when starting. Which of the
following is the MOST likely cause?
a. Wrong starter installed
b. Shims left out
c. Defective solenoid
d. Defective flywheel - CORRECT ANSWERSb. Shims left out
A tight timing belt makes what type of noise? - CORRECT ANSWERSWhining
A RWD (rear wheel drive) transmission has a leaking output shaft seal on a vehicle with 25,000 miles on
the odometer. The MOST likely cause for the leakage is: - CORRECT ANSWERSPlugged Transmission
Breather filter
Of the following, when replacing a CV (constant velocity) joint or boot, what is the last step before
clamping the boot? - CORRECT ANSWERSBurping
Steering dampers can be used to reduce excessive __________. - CORRECT ANSWERSpositive caster
A technician is rotating the tires using the modified X-method of tire rotation on a front-wheel-drive
vehicle. Where should be the right front wheel placed? - CORRECT ANSWERSRight Rear
, The open circuit voltage (OCV) test on a fully charged battery should show which voltage? - CORRECT
ANSWERS12.6
There is white exhaust smoke coming from the tailpipe of a vehicle well after the engine has been
started. What is causing this condition? - CORRECT ANSWERSCoolant in combustion chamber
A front wheel drive vehicle has a clacking noise that only occurs while cornering. The technician suspects
a faulty front axle. Which of these is most likely the cause? - CORRECT ANSWERSOuter CV Joint
The tread of a tire is worn in the center and not on the outer shoulders. Technician A says this is caused
by an improper wheel alignment angle. Technician B says this is caused by an over-inflated tire. Who is
correct? (Just the letter) - CORRECT ANSWERSB
A vehicle with power assist brakes has a hard brake pedal. Which of these is the most likely cause? -
CORRECT ANSWERSA Faulty Brake Booster
Technician A says that oil should be squirted into all of the cylinders before taking a compression test.
Technician B says that if the compression greatly increases when some oil is squirted into the cylinders,
it indicates defective or worn piston rings. Which technician is correct? (Letter only) - CORRECT
ANSWERSB
During a cylinder leakage (leak-down) test, air is noticed coming out of the oil fill opening. Technician A
says that the oil filter may be clogged. Technician B says that the piston rings may be worn or defective.
Which technician is correct? (Letter only) - CORRECT ANSWERSB
What precautions are needed to be performed to help prevent air from getting trapped in the cooling
system when replacing coolant? - CORRECT ANSWERSOpen the Bleeder Valve during filling
To flush a hydraulic clutch system, what should be used? - CORRECT ANSWERSDOT 3
The engine of a vehicle will start, but is slow cranking. Technician A says there may be resistance in the
starter circuit. Technician B says to perform a voltage drop test to test for excessive resistance in the
starter circuit. Who is correct? ("A" "B" or "Both") - CORRECT ANSWERSBoth
