100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached 4.6 TrustPilot
logo-home
Exam (elaborations)

Plant Operations BOMA Pre-Quiz 1-100 Exam Questions With Correct Answers

Rating
-
Sold
-
Pages
23
Grade
A+
Uploaded on
11-11-2024
Written in
2024/2025

Plant Operations BOMA Pre-Quiz 1-100 Exam Questions With Correct Answers How may fittings be attached to a high pressure boiler? a. threaded b. certified welds c. flanges d. any of the above - answerd. any of the above Which test determines the relieving capacity of safety valves? a. hydrostatic test b. accumulation test c. orsat test ration test - answerb. accumulation test Flue gasses can leave at high temperatures. We can recover some of this heat using a(n): a. flash tank b. open feedwater heater c. economizer d. air compressor - answerc. economizer Feed water is typically heated with: a. commercial hot water heaters or extracted steam ©THEBRIGHT EXAM SOLUTIONS 11/05/2024 12:06 PM c. another burner d. superheaters - answer or extracted steam What is the maximum pounds of steam per hour of a boiler called? a. boiler capacity b. steaming rate c. heating surface d. water tube - answera. boiler capacity What is a steam condenser's reservoir called? a. surge tank b. hot well c. flash tank d. vacuum - answerb. hot well When inspecting a boiler, main steam valves are: a. open b. closed c. depends on the boiler d. closed, locked, and tagged - answerd. closed, locked, and tagged Boiler draft is the difference in _____ between two points: a. gas flow b. water flow c. pressure d. wind - answerc. pressure ©THEBRIGHT EXAM SOLUTIONS 11/05/2024 12:06 PM Boilers are required to have how many pressure gauges? a. 1 b. 2 c. 3 d. 1 for low pressure and 2 for high pressure - answera. 1 Feed water pumps take water from the: a. hotwell b. open feedwater heater c. flash tank d. boiler - answerb. open feedwater heater High vibrations in a feed water pump could be caused by: a. high pressure in the DA tank b. cold feed water c. hot feed water d. those things always vibrate - answerc. hot feed water Which type of pump is best for handling dirty water? a. chemical b. centrifugal c. gear d. positive displacement - answerb. centrifugal Which is not a part of a centrifugal pump? a. volute b. impeller

Show more Read less
Institution
BOMA
Course
BOMA










Whoops! We can’t load your doc right now. Try again or contact support.

Written for

Institution
BOMA
Course
BOMA

Document information

Uploaded on
November 11, 2024
Number of pages
23
Written in
2024/2025
Type
Exam (elaborations)
Contains
Questions & answers

Subjects

Content preview

©THEBRIGHT EXAM SOLUTIONS

11/05/2024 12:06 PM


Plant Operations BOMA Pre-Quiz 1-100
Exam Questions With Correct Answers


How may fittings be attached to a high pressure boiler?

a. threaded

b. certified welds

c. flanges

d. any of the above - answer✔d. any of the above



Which test determines the relieving capacity of safety valves?

a. hydrostatic test

b. accumulation test

c. orsat test

d.evaporation test - answer✔b. accumulation test



Flue gasses can leave at high temperatures. We can recover some of this heat using a(n):

a. flash tank

b. open feedwater heater

c. economizer

d. air compressor - answer✔c. economizer



Feed water is typically heated with:

a. commercial hot water heaters

b.waste or extracted steam

, ©THEBRIGHT EXAM SOLUTIONS

11/05/2024 12:06 PM

c. another burner

d. superheaters - answer✔b.waste or extracted steam



What is the maximum pounds of steam per hour of a boiler called?

a. boiler capacity

b. steaming rate

c. heating surface

d. water tube - answer✔a. boiler capacity



What is a steam condenser's reservoir called?

a. surge tank

b. hot well

c. flash tank

d. vacuum - answer✔b. hot well



When inspecting a boiler, main steam valves are:

a. open

b. closed

c. depends on the boiler

d. closed, locked, and tagged - answer✔d. closed, locked, and tagged



Boiler draft is the difference in _____ between two points:

a. gas flow

b. water flow

c. pressure

d. wind - answer✔c. pressure

, ©THEBRIGHT EXAM SOLUTIONS

11/05/2024 12:06 PM

Boilers are required to have how many pressure gauges?

a. 1

b. 2

c. 3

d. 1 for low pressure and 2 for high pressure - answer✔a. 1



Feed water pumps take water from the:

a. hotwell

b. open feedwater heater

c. flash tank

d. boiler - answer✔b. open feedwater heater



High vibrations in a feed water pump could be caused by:

a. high pressure in the DA tank

b. cold feed water

c. hot feed water

d. those things always vibrate - answer✔c. hot feed water



Which type of pump is best for handling dirty water?

a. chemical

b. centrifugal

c. gear

d. positive displacement - answer✔b. centrifugal



Which is not a part of a centrifugal pump?

a. volute

b. impeller

Get to know the seller

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
Thebright Florida State University
View profile
Follow You need to be logged in order to follow users or courses
Sold
179
Member since
1 year
Number of followers
6
Documents
12718
Last sold
3 days ago
Topscore Emporium.

On this page, you find verified, updated and accurate documents and package deals.

3.8

36 reviews

5
14
4
10
3
7
2
1
1
4

Recently viewed by you

Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Frequently asked questions