100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached 4.2 TrustPilot
logo-home
Exam (elaborations)

Journeyman Electrician Practice Exam(100% Accurate)

Rating
-
Sold
-
Pages
22
Grade
A
Uploaded on
18-10-2024
Written in
2024/2025

Rod-type grounding electrodes of stainless steel shall have a diameter of no less than which of the following? a) 3/8 inch b) 1/2 inch c) 5/8 inch d 3/4 inch - ANSWERc) 5/8 inch Information technology equipment shall be permitted to be connected to a branch circuit by a power-supply cord with a macimum lenght of how many feet? a) 6 b) 10 c) 12 d) 15 - ANSWERd) 15 What is the power of a 4-Ohm resistive load connected to a 120-volt power supply? a) 1,200 watts b) 2,400 watts c) 3,600 watts d) 4,800 watts - ANSWERc) 3,600 watts Resistance-type heating elements in electric space in electric soace-heating equipment shall be protected at not more than how many amperes? a) 40 amperes b) 50 amperes c) 60 a

Show more Read less
Institution
Journeyman Electrician
Course
Journeyman Electrician










Whoops! We can’t load your doc right now. Try again or contact support.

Written for

Institution
Journeyman Electrician
Course
Journeyman Electrician

Document information

Uploaded on
October 18, 2024
Number of pages
22
Written in
2024/2025
Type
Exam (elaborations)
Contains
Questions & answers

Subjects

Content preview

Journeyman Electrician Practice
Exam(100% Accurate)

Rod-type grounding electrodes of stainless steel shall have a diameter of no less than which of the
following?



a) 3/8 inch

b) 1/2 inch

c) 5/8 inch

d 3/4 inch - ANSWERc) 5/8 inch



Information technology equipment shall be permitted to be connected to a branch circuit by a
power-supply cord with a macimum lenght of how many feet?

a) 6

b) 10

c) 12

d) 15 - ANSWERd) 15



What is the power of a 4-Ohm resistive load connected to a 120-volt power supply?



a) 1,200 watts

b) 2,400 watts

c) 3,600 watts

d) 4,800 watts - ANSWERc) 3,600 watts



Resistance-type heating elements in electric space in electric soace-heating equipment shall be
protected at not more than how many amperes?

a) 40 amperes

b) 50 amperes

c) 60 amperes

d) 75 amperes - ANSWERc) 60 amperes

,ENT shall not be

a) bent

b) grounded

c) reamed

d) threaded - ANSWERd) threaded

What part of bulk storage plat is classified as class 2, zone 2?

a) vents, discharging upwards

b) below grade storage tank equipment

c) pits and sums without mechanical ventilation

d) drainage ditches, separators, and impounding basins. - ANSWERd) drainage ditches, separators,
and impounding basins



In which application is the installation of UF cable permitted?

a) in theaters

b) in hoistways

c) in commercial garages

d) in photovoltaic systems - ANSWERd) in photovoltaic systems



For other than a totally enclosed switchboard or switchgear, what is the minimum amound of space
that shall be provided between the top of an unshielded shwitchboard or switchgear and any
combustible ceiling?

a) 18 inches

b) 24 inches

c) 30 inches

d) 36 inches - ANSWERd) 36 inches



The base of a 24-foot non-self-supporting ladder shall be placed approximately how far from the
vertical structure upon which is leaning?

a) 3 feet

b) 4 feet

c) 5 feet

, d) 6 feet - ANSWERd) 6 feet



The storage batteries used as a source of power for emergency systems shall be of suitable rating and
capacity to supply and maintain the total load for a minimum of how long?

a)45 minutes

b) 60 minutes

c) 75 minutes

d) 90 minutes - ANSWERd) 90 minutes



What clearance must be maintained when overhead spans of open conductors or open
multiconductors cables of not over 1000 volts pass over residential property?

a) 10 feet

b) 12 feet

c) 15 feet

d) 20 feet - ANSWERb) 12 feet



What is the maximum spacing for supports of 10 AWG copper conductors located in a vertical
raceway?

a) 50 feet

b) 60 feet

c) 80 feet

d) 100 feet - ANSWERd) 100 feet



Where are flat cable assemblies permitted to be installed?

a) in hostways

b) in exposed locations

c) on escalators and elevators

d) in 35 ampere branch circuits - ANSWERb) in exposed locations



If the branch circuit supplies a single non-motor-operated appliance, the rating of overcurrent
protection shall not exceed 20 amperes if the overcurrent protection rating is not marked and the
appliance is rated at

a) 12.2 amperes or less

Get to know the seller

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
papersmaster01 Howard Community College
View profile
Follow You need to be logged in order to follow users or courses
Sold
277
Member since
2 year
Number of followers
106
Documents
14036
Last sold
5 hours ago
PAPERSMASTER01

On this page you will find documents , package deals, flashcards offered by seller PAPERSMASTER01.With our documents on your side you"ll be well equipped to tackle you exams and achieve the grades you need.

3.9

71 reviews

5
22
4
33
3
9
2
3
1
4

Recently viewed by you

Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Frequently asked questions