NTN FireTEAM Study Set Exam
Questions with Answers
What do you use to tighten a bolt - -socket wrench
-What shape is a drillbit used for metal - -sleek shape, not pointed, no
pertruding edges for operations at high speed to go through hard metal or
sometimes wood
-what shape drillbit is hand operated for drilling wood - -the tip is a
threaded point, pertruding edges to cut through soft wood.
-what shape drillbit is used from ceramics/masonry - -squared off tip bit
-small gear vs big gear, what turns faster? - -Big gear
-When installing Bolt w/ washer and nut, what side faces you? - -Threaded
end goes away from body to prevent hazard
-What tool is used to cut bolts? - -Hacksaw (NOT BOLTCUTTERS)
-Mechanical Brick Factory: What do you do if there is unmelted material? - -
Stop, call mechanic
-Mechanical Brick Factory: If you want more material from the start of the
assembly, what do you do? - -Adjust amount released by Hopper, DONT
adjust speed of belt
-Mechanical Brick Factory: If the first grinder is stuck, what do you suspect? -
-There is a jam in the grinder
-Mechanical Brick Factory: How do you fix a grinder jam? - -You put it in
reverse manually
-Mechanical Brick Factory: How do you remove a molding station arm? - -1.
Loosen middle nut
2. then remove end nut
-Mechanical Brick Factory: If water is pouring over the edge, what do you
suspect is wrong? - -Green Filter CLOG
-Mechanical Brick Factory: Water tank is rising quickly, how do you fix it? - -
Reduce amount of fresh water
Questions with Answers
What do you use to tighten a bolt - -socket wrench
-What shape is a drillbit used for metal - -sleek shape, not pointed, no
pertruding edges for operations at high speed to go through hard metal or
sometimes wood
-what shape drillbit is hand operated for drilling wood - -the tip is a
threaded point, pertruding edges to cut through soft wood.
-what shape drillbit is used from ceramics/masonry - -squared off tip bit
-small gear vs big gear, what turns faster? - -Big gear
-When installing Bolt w/ washer and nut, what side faces you? - -Threaded
end goes away from body to prevent hazard
-What tool is used to cut bolts? - -Hacksaw (NOT BOLTCUTTERS)
-Mechanical Brick Factory: What do you do if there is unmelted material? - -
Stop, call mechanic
-Mechanical Brick Factory: If you want more material from the start of the
assembly, what do you do? - -Adjust amount released by Hopper, DONT
adjust speed of belt
-Mechanical Brick Factory: If the first grinder is stuck, what do you suspect? -
-There is a jam in the grinder
-Mechanical Brick Factory: How do you fix a grinder jam? - -You put it in
reverse manually
-Mechanical Brick Factory: How do you remove a molding station arm? - -1.
Loosen middle nut
2. then remove end nut
-Mechanical Brick Factory: If water is pouring over the edge, what do you
suspect is wrong? - -Green Filter CLOG
-Mechanical Brick Factory: Water tank is rising quickly, how do you fix it? - -
Reduce amount of fresh water
