Alabama Boating and Safety (78 Questions) With 100% Correct Verified Answers

The port side of a vessel is the side. - left The stern of a vessel is the of the vessel. - rear Basic types of vessel hulls can be described as . - displacement and planning Name three basic hull shapes. - round, flat, and vee-bottom What are the four length classes of vessels? - i. Less than 16 feet ii. 16 to less than 26 feet iii. 26 to less than 40 feet iv. 40 to less than 65 feet List the four basic types of engines. - outboard, inboard, stern drive, and jet drive Stern drive and inboard engines are . - automotive engines adopted for marine use The USCG considers PWC to be . - an inboard vessel (Class A vessel) True or False: PWC are not subject to the laws and requirements of other vessels. - False is a device used to pump and force water under pressure through a steering nozzle at the rear ofthe vessel. - impeller What information is displayed on the capacity plate of an outboard powerboat? Maximum number of people and weight/Maximum horsepower for that vessel List three things that should be included on your float plan before you embark on an extended outing. - Number, names, and addresses of passengers, boat description, and Trip plan Name three things that you should do while filling the fuel tank of your vessel. Nozzle stays in contact with gas plate, don't want to fill it up to the top, and fill tank slowly and avoid spilling A rule of thumb to prevent running out of fuel on a PWC is out, in, and in reserve. - 1/3, 1/3, 1/3 If the combined weight of the vessel and its engine is more than of the recommended load capacity of the trailer, you should get the next larger trailer. 90% "Tongue weight" is the amount of the loaded trailer's weight that . - presses down on the towing hitch Two strong safety chains should be to support the trailer's coupler in case it becomes disconnected from the towing vehicle. - crisscrossed Where should you prepare your vessel before launching it from the trailer? - Away from the dock ramp. Name six engine maintenance tips. - I. Check oil levels 2. Change oil 3. Keep well-tuned 4. Check batteries 5. Grease and lubricate 6. Check for anything loose If the wind or current direction is toward the dock, you should cast off the first when leaving the dock. - stern line The is required to take early and substantial action to avoid a collision by stopping, slowing down, or changing course. - give way vessel The stand-on vessel must