100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached 4.2 TrustPilot
logo-home
Exam (elaborations)

ASE Auto Maintenance & Light Repair Test (Test G1) Practice Questions and Answers

Rating
-
Sold
-
Pages
6
Grade
A+
Uploaded on
28-08-2024
Written in
2024/2025

ASE Auto Maintenance & Light Repair Test (Test G1) Practice Questions and Answers A tight timing belt makes what type of noise? - Answer️️ -Whining A RWD (rear wheel drive) transmission has a leaking output shaft seal on a vehicle with 25,000 miles on the odometer. The MOST likely cause for the leakage is: - Answer️️ -plugged transmission breather filter Of the following, when replacing a CV (constant velocity) joint or boot, what is the last step before clamping the boot? - Answer️️ - Burping Steering dampers can be used to reduce excessive __________. - Answer️️ -positive caster A technician is rotating the tires using the modified X-method of tire rotation on a front-wheel-drive vehicle. Where should be the right front wheel placed? - Answer️️ -Right rear The open circuit voltage (OCV) test on a fully charged battery should show which voltage? - Answer️️ -12.6 There is white exhaust smoke coming from the tailpipe of a vehicle well after the engine has been started. What is causing this condition? - Answer️️ -coolant in combustion chamber ©SOPHIABENNET@2024/2025 Wednesday, August 21, 2024 12:13 PM 2 A front wheel drive vehicle has a clacking noise that only occurs while cornering. The technician suspects a faulty front axle. Which of these is most likely the cause? - Answer️️ -outer CV Joint The tread of a tire is worn in the center and not on the outer shoulders. Technician A says this is caused by an improper wheel alignment angle. Technician B says this is caused by an over- inflated tire. Who is correct? (Just the letter) - Answer️️ -B A vehicle with power assist brakes has a hard brake pedal. Which of these is the most likely cause? - Answer️️ -faulty brake booster Technician A says that oil should be squirted into all of the cylinders before taking a compression test. Technician B says that if the compression greatly increases when some oil is squirted into the cylinders, it indicates defective or worn piston rings. Which technician is correct? (Letter only) - Answer️️ -B During a cylinder leakage (leak-down) test, air is noticed coming out of the oil fill opening. Technician A says that the oil filter may be clogged. Technician B says that the piston rings may be worn or defective. Which technician is correct? (Letter only) - Answer️️ -B What precautions are needed to be performed to help prevent air from getting trapped in the cooling system when replacing coolant? - Answer️️ -Open the bleeder valve during filling To flush a hydraulic clutch system, what should be used? - Answer️️ -DOT 3 ©SOPHIABENNET@2024/2025 Wednesday, August 21, 2024 12:13 PM 3 The engine of a vehicle will start, but is slow cranking. Technician A says there may be resistance in the starter circuit. Technician B says to perform a voltage drop test to test for excessive resistance in the starter circuit. Who is correct? ("A" "B" or "Both") - Answer️️ - Both Technician A says a stuck open PCV valve will cause a lean fuel condition. Technician B says the PCV system removes blowby gases from the crankcase. Who is correct? ("A" "B" or "Both") - Answer️️ - Both A technician removes and replaces a worn lower radiator hose on a four cylinder engine. The vehicle overheats after the technician has replaced the hose and added coolant. Which of these is most likely the cause of this condition? - Answer️️ -air pocket Engine mounts were recently replaced on a front wheel drive vehicle with independent suspension. The vehicle now has a steady pull to the left at all speeds. Technician A says this is most

Show more Read less
Institution
ASE
Course
ASE









Whoops! We can’t load your doc right now. Try again or contact support.

Written for

Institution
ASE
Course
ASE

Document information

Uploaded on
August 28, 2024
Number of pages
6
Written in
2024/2025
Type
Exam (elaborations)
Contains
Questions & answers

Subjects

Content preview

©SOPHIABENNET@2024/2025 Wednesday, August 21, 2024 12:13 PM




ASE Auto Maintenance & Light Repair Test
(Test G1) Practice Questions and Answers

A tight timing belt makes what type of noise? - Answer✔️✔️-Whining

A RWD (rear wheel drive) transmission has a leaking output shaft
seal on a vehicle with 25,000 miles on the odometer. The MOST
likely cause for the leakage is: - Answer✔️✔️-plugged transmission
breather filter

Of the following, when replacing a CV (constant velocity) joint or
boot, what is the last step before clamping the boot? - Answer✔️✔️-
Burping

Steering dampers can be used to reduce excessive __________. -
Answer✔️✔️-positive caster

A technician is rotating the tires using the modified X-method of
tire rotation on a front-wheel-drive vehicle. Where should be the
right front wheel placed? - Answer✔️✔️-Right rear

The open circuit voltage (OCV) test on a fully charged battery
should show which voltage? - Answer✔️✔️-12.6

There is white exhaust smoke coming from the tailpipe of a vehicle
well after the engine has been started. What is causing this
condition? - Answer✔️✔️-coolant in combustion chamber




1

, ©SOPHIABENNET@2024/2025 Wednesday, August 21, 2024 12:13 PM




A front wheel drive vehicle has a clacking noise that only occurs
while cornering. The technician suspects a faulty front axle. Which
of these is most likely the cause? - Answer✔️✔️-outer CV Joint

The tread of a tire is worn in the center and not on the outer
shoulders. Technician A says this is caused by an improper wheel
alignment angle. Technician B says this is caused by an over-
inflated tire. Who is correct? (Just the letter) - Answer✔️✔️-B

A vehicle with power assist brakes has a hard brake pedal. Which of
these is the most likely cause? - Answer✔️✔️-faulty brake booster

Technician A says that oil should be squirted into all of the
cylinders before taking a compression test. Technician B says that if
the compression greatly increases when some oil is squirted into
the cylinders, it indicates defective or worn piston rings. Which
technician is correct? (Letter only) - Answer✔️✔️-B

During a cylinder leakage (leak-down) test, air is noticed coming out
of the oil fill opening. Technician A says that the oil filter may be
clogged. Technician B says that the piston rings may be worn or
defective. Which technician is correct? (Letter only) - Answer✔️✔️-B

What precautions are needed to be performed to help prevent air
from getting trapped in the cooling system when replacing coolant?
- Answer✔️✔️-Open the bleeder valve during filling

To flush a hydraulic clutch system, what should be used? -
Answer✔️✔️-DOT 3


2

Get to know the seller

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
SophiaBennett Howard Community College
View profile
Follow You need to be logged in order to follow users or courses
Sold
131
Member since
1 year
Number of followers
5
Documents
9104
Last sold
1 day ago
EXAM GAME-CHANGER

Exam Questions and Answers Section : Study Like a Pro, Study Smart, Study with Sophia.

3.7

26 reviews

5
10
4
5
3
7
2
1
1
3

Recently viewed by you

Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Frequently asked questions