Answers
What can be a sign of slab detachment? - CORRECT ANSWER-cracks along the slab
edge
Which of the following is true about perimeter vents in a crawl space? - CORRECT
ANSWER-There is little agreement about when to keep vents open or closed.
What is not a likely cause of slab settlement? - CORRECT ANSWER-shrinkage of the
concrete slab
Perimeter venting is required in a crawl space to prevent _____. - CORRECT
ANSWER-moisture from soil rising into the house
Which of the conditions can be caused by poor ventilation in a crawl space? -
CORRECT ANSWER-deterioration of framing members
Why should a dirt floor in a crawl space be covered? - CORRECT ANSWER-to prevent
moisture from the soil being released into the crawl space
Ceiling insulation in a crawl space should be installed _____. - CORRECT ANSWER-
with the moisture deterrent layer up
What would not be a cause of bulging or leaning in exterior masonry walls? -
CORRECT ANSWER-a rusting lintel
What should be suspected if a brick veneer wall has a bow to it? - CORRECT
ANSWER-loose brick ties
In which type of framing does the subfloor go only to the inner edge of the wall stud? -
CORRECT ANSWER-balloon framing
,A notch cut into a girder or joist can be no more than _____. - CORRECT ANSWER-1/6
of the depth
How should plywood subflooring not be laid? - CORRECT ANSWER-parallel to the
joists
In balloon framing construction, the wall studs rest directly on the _____. - CORRECT
ANSWER-sill
Which construction method is common in barns and churches? - CORRECT ANSWER-
post and beam construction
What may happen to the floor as a result of a load-bearing wall being offset from the
supporting beam below it? - CORRECT ANSWER-all of the answers shown
a low spot may appear in the floor along the wall
a ridge may appear above the beam
the joists supporting the wall may be deflected
What is the proper term to describe floors with a continuous slope in one direction? -
CORRECT ANSWER-unlevel
Which of the following can cause a floor to be bouncy? - CORRECT ANSWER-lack of
proper bridging in the joists
In platform framing construction, the wall studs rest directly on the _____. - CORRECT
ANSWER-sole plate
What condition should be reported as a major defect in the roof structure? - CORRECT
ANSWER-cracked rafters and delaminated sheathing
What condition in the attic can cause plywood roof sheathing to delaminate? -
CORRECT ANSWER-too much moisture in the attic
, Where should insulation in an unfinished attic be laid? - CORRECT ANSWER-on the
floor
Insulation in the attic should be installed _____. - CORRECT ANSWER-with the
moisture deterrent layer toward the heated portion of the house
When should attic vents be open? - CORRECT ANSWER-at all times
Rafters may not be attached to _____. - CORRECT ANSWER-the ledger and wall studs
What is the function of a knee wall in an attic? - CORRECT ANSWER-to prevent the
roof rafters from sagging
H-clips are used to secure roof sheathing to _____. - CORRECT ANSWER-roof
sheathing
What is the function of collar ties? - CORRECT ANSWER-to prevent the roof rafters
from sagging and spreading
At what temperature should the unfinished attic be? - CORRECT ANSWER-the same
as outdoors
Truss uplift is _____. - CORRECT ANSWER-a bowing upward of the bottom chord
What type of roof truss is used in vaulted or cathedral ceiling structures? - CORRECT
ANSWER-scissors truss
When should a retaining wall be inspected? - CORRECT ANSWER-If it is holding back
soil that could affect the house or garage