INTERMODAL DRY CARGO CNTR / CSC REINSPEC CERT EXAM QUESTIONS & ANSWERS VERIFIED 100% CORRECT

What must be displayed on both ends, both sides, and the top of a container? - Container Identification When inspecting containers, what tool is used to determine weld serviceability and the severity of corrosion? - Welder's Hammer When inspecting containers, what tool is used to make on-the-spot corrections to unacceptable bends in the side rails or other locations on the container? - Adjustable wrench A container with a major IMDG defect may be used to transport ___________. - General cargo only Which statement about minor defects is true? Refer to MIL-STD-3037, Section 4 as required. - Minor defects are documented and/or repaired at the inspector's discretion When inspecting containers, what tool would you use to inspect the container floor for excessive gaps? - Feeler gauge Which form certifies a container's serviceability and identifies the month and year the next reinspection is due? - DD Form 2282 decal Which of the following containers has a removable tarp in place of a rigid roof? - Open-top Which of the following containers is used for large, heavy cargo that cannot be loaded into a container with fixed sides or walls? - Flatrack Which of the following defects renders a container unserviceable and unable to transport any type of cargo?Select all that apply. Refer to MIL-STD-3037, Section 4 as required. - 1: A missing, cracked, or broken weld at the juncture between primary structural components. 2: A loose or missing fastener at the juncture between primary structural components