CAL/OSHA 10/30 - Final Exam Questions
and Answers 100% Pass
The best way to prevent complacency from happening to you or around you is to: -
ANSWER-(letter may vary; Perform a daily Harzard Recognition Plan of your work area,
Conduct safety audits, Improve the safety culture by looking out for your fellow workers,
and Take ownership of your personal safety)
E. All of the above
Employees must not work on scaffold surfaces until ________________ - ANSWER-
(letter may vary)
A. It is determined to have strength and structural integrity to support intended loads.
To prevent a load from slipping, all loads raised by cranes and other hoisting devices
must _________ - ANSWER-(letter may vary)
A. Be rigged properly with appropriately rated equipment
Which of the following would be considered a flying hazard? - ANSWER-(letter may
vary)
A. A piece of material separates from a tool, striking a worker
By definition, a hazard is any situation or condition that has the potential to cause harm
to: - ANSWER-(letter may vary; Life, Health, Property, and The environment)
E. All of the above
Common safety measures that can help you avoid being involved in a struck by incident
are: - ANSWER-(letter may vary; Do not exceed a vehicle's rated load or lift capacity,
Do not carry personnel unless there is a safe place to ride, and Make sure that all
personnel are in the clear before using dumping or lifting devices)
D. All of the above
If equipment is not _________ during maintenance, it may start automatically and cause
injury or death. - ANSWER-(letter may vary)
, B. De-energized (locked-out)
What major hazard includes incidents where a person or part of a person was injured by
being squeezed, crushed, pinched or compressed between two or more objects, or
between parts of an object? - ANSWER-(letter may vary)
B. Caught in or between hazards.
When the Impact alone creates the injury, the event should be reoreded as. - ANSWER-
(letter may vary)
B. Struck-by
In the video clip we showed a worker knocked down by the swinging counterweight of
an excavator. What is an effective way to prevent this type of accident? - ANSWER-
(letter may vary)
C. Properly barricading the swing radius of the excavator.
Worn where there are sparks or molten metal splashes and have elastic sides or quick-
release buckles for speedy removal. - ANSWER-(letter may vary)
B. Foundry boots.
ANSI recommends locating emergency eye wash and shower stations in an area
reachable within _____ following an exposure event. - ANSWER-(letter may vary)
A. 10 seconds
Goggles can be worn in combination with spectacles or corrective lenses. - ANSWER-
(letter may vary)
A. True
Cal/OSHA generally requires that employers pay for PPE determined necessary
following a PPE hazard assessment including: - ANSWER-(letter may vary)
D. Steel-toed boots if exposed to crushing foot or penetrating injury.
and Answers 100% Pass
The best way to prevent complacency from happening to you or around you is to: -
ANSWER-(letter may vary; Perform a daily Harzard Recognition Plan of your work area,
Conduct safety audits, Improve the safety culture by looking out for your fellow workers,
and Take ownership of your personal safety)
E. All of the above
Employees must not work on scaffold surfaces until ________________ - ANSWER-
(letter may vary)
A. It is determined to have strength and structural integrity to support intended loads.
To prevent a load from slipping, all loads raised by cranes and other hoisting devices
must _________ - ANSWER-(letter may vary)
A. Be rigged properly with appropriately rated equipment
Which of the following would be considered a flying hazard? - ANSWER-(letter may
vary)
A. A piece of material separates from a tool, striking a worker
By definition, a hazard is any situation or condition that has the potential to cause harm
to: - ANSWER-(letter may vary; Life, Health, Property, and The environment)
E. All of the above
Common safety measures that can help you avoid being involved in a struck by incident
are: - ANSWER-(letter may vary; Do not exceed a vehicle's rated load or lift capacity,
Do not carry personnel unless there is a safe place to ride, and Make sure that all
personnel are in the clear before using dumping or lifting devices)
D. All of the above
If equipment is not _________ during maintenance, it may start automatically and cause
injury or death. - ANSWER-(letter may vary)
, B. De-energized (locked-out)
What major hazard includes incidents where a person or part of a person was injured by
being squeezed, crushed, pinched or compressed between two or more objects, or
between parts of an object? - ANSWER-(letter may vary)
B. Caught in or between hazards.
When the Impact alone creates the injury, the event should be reoreded as. - ANSWER-
(letter may vary)
B. Struck-by
In the video clip we showed a worker knocked down by the swinging counterweight of
an excavator. What is an effective way to prevent this type of accident? - ANSWER-
(letter may vary)
C. Properly barricading the swing radius of the excavator.
Worn where there are sparks or molten metal splashes and have elastic sides or quick-
release buckles for speedy removal. - ANSWER-(letter may vary)
B. Foundry boots.
ANSI recommends locating emergency eye wash and shower stations in an area
reachable within _____ following an exposure event. - ANSWER-(letter may vary)
A. 10 seconds
Goggles can be worn in combination with spectacles or corrective lenses. - ANSWER-
(letter may vary)
A. True
Cal/OSHA generally requires that employers pay for PPE determined necessary
following a PPE hazard assessment including: - ANSWER-(letter may vary)
D. Steel-toed boots if exposed to crushing foot or penetrating injury.
