Expansion Bus Types questions and answers

Peripheral Component Interconnect (PCI) PCI was developed to replace the obsolete ISA and VESA bus standards. PCI: • Is processor independent, meaning the CPU and PCI bus can process concurrently • Supports plug and play, meaning installed devices are detected and configured automatically • Used by devices such as sound cards, modems, network cards, and storage device controllers • Can run at 33 MHz and transfer data at 133 MB/s or run at 66 MHz and transfer data at 266 MB/s PCI Extended (PCI-X) PCI-X was built on existing the PCI architecture and aimed to overcome standard PCI bandwidth limitations. PCI-X: • Uses a 64-bit interface to achieve faster data speeds • Operates at 133 MHz, resulting in data rates of 1.06 GB/s • Is typically used by servers for network cards or Fibre Channel adapters • Is backwards compatible with standard PCI slots (i.e., a PCI-X card can be installed in a standard PCI slot) (When installed in a standard PCI slot, PCI-X cards are throttled down to standard PCI speeds.) PCI Express (PCIe) PCIe was developed to replace PCI, PCI-X, and AGP. Instead of a shared bus, each PCIe slot links to a switch that prioritizes and routes data through a point-to-point dedicated connection and provides a serial, full-duplex method of transmission. PCIe uses several different connection types. • PCIe types are defined by the number of transmission lanes that are used to transfer data. For example, PCIe x1 provides one lane for transmission (x1), while PCIe x16 provides sixteen lanes for transmission. PCIe defines x2, x4, x8, x16, and x32 connection types. • PCIe data rates depend on the protocol version and number of transmission lanes: o 1.0: 250 MB/s (x1); 4 GB/s (x16) o 2.0: 500 MB/s (x1); 8 GB/s (x16) o 3.0: 1 GB/s (x1); 16 GB/s (x16) o 4.0: 2 GB/s (x1); 32 GB/s (x16) • In addition to greatly increased speed, PCIe offers higher quality service. • PCIe can run alongside legacy PCI technology (i.e., both PCIe and PCI buses can be in the same system). • PCIe x1 slots are typically used for network cards, USB cards, and sound cards. PCIe x16 slots are primarily used for dedicated video cards. (PCIe cards are cross-size compatible, as long as the slot size is the same or larger than the card size. For example, a PCIe x1 card can be installed in a PCIe x16 slot, but a PCIe x16 card cannot be installed in a PCIe x1 slot.) Mini PCI Small form factor computers (e.g., laptops or Mini-ITX systems) might include a Mini PCI slot, which has either 100 or 124 pins and accepts Mini PCI cards. A typical use for a Mini PCI slot is to add internal cards (such as wireless cards) to laptops. Legacy buses Buses that have been replaced by newer types are considered legacy buses. Legacy buses are rarely used and include the following: • AGP (accelerated graphics port) was a dedicated bus type used by dedicated video cards. • AMR (audio/modem riser) was a riser card that attached to the motherboard and allowed additional cards (called daughter cards) to be installed. • CNR (communications network riser) was a riser card slot that allowed for installing network, sound, or modem functions.